What’s in the box?
• eZeeBeads
• BeadStorageTray
• WaterSprayer
• BeadTool
• DesignCards
• PlasticPins(ahandytoolfor
helpingtolineupbeadlayers)
INTRODUCTION
ThefollowingdiagramsshowhoweZeeBeadswork.Readthroughtheseinstructions
beforeyoustarttomakeyour3Dcharactersasexplainedoverleaf.
Selectadesigncardand
slideitintothebaseof
the bead tray with the
designfacingupwards.
Allow at least 30
minutes to dry and
thenremoveyourbead
design from the tray.
AfterremovingyoureZeeBeaddesign,theremaybesomebeadcolourleftonthetray.
Thiswillnotinterferewithfuturedesigns.Ifyouwouldliketoremovethesemarks,cleanthe
traywithwarmsoapywaterandallowtodry.
Start by pushing the
coloured beads onto the
pegsofthetraymatching
thebeadstothecolours
onthecards.
Take out the design
card. Using the water
bottle, spray enough
water to thoroughly
wetallthebeads.
Remove your design by using the spatula end of the bead tool, carefully lifting and
looseningthebeadsupwardsaroundtheshape.Nextuseyourfingerstopullitupfromthepegs.
Asyouliftuptheshape,ifanyofthebeadscomedetachedfromtherest,puttheshapebackdown
ontothepegs,re-spraythatareawithwaterandleavetodryagain.
WhenusingeZeebeads,thepointed endofthebeadtoolishandyforliftingoutanydrybeadswhich
areinthewrongplace.
