
Refer to the Heat Transfer Paper Instructions for best results.
General Heat Transfer Instructions
•Follow the Heat Transfer Paper Instructions for best results.
•Adjust press pressure to medium-heavy.
•Preheat the heat press to 295-305°F or temperature specified per paper instructions.
oIf using a heat pad, adjust temperature to 325-335°F.
•Print and place transfer sheet face down onto the surface of the product blank. Secure transfer with
heat tape.
•Place the product blank with attached transfer sheet onto the heat press platen with the transfer
paper on top.
•Place a piece of Teflon or blowout paper on top of the transfer paper.
oRecommended: use Nomex pad
•Close and press for the recommended time.
•When finished, open the press and remove the Teflon or blowout paper.
•Using heat gloves, remove the product from the press.
•Peel the transfer paper off of the surface of the product while the product surface is still hot/warm.
oThe product should still be warm, but able to be handled without heat gloves.
Tips and Tricks
•For best image placement, utilize the product template found on the product page on JPPlus.com.
Troubleshooting
•The image did not completely transfer to the product.
oSlightly increase the press pressure.
oThe product may still be too warm when peeled. Wait a little more time before peeling the
transfer paper.
•Ensure that the Hard Surface paper used is compatible with the product material, as there are several
types of Hard Surface papers available for different types of hard surface goods.