SETTING LEGACY MODE FOR TRACKING
a. Push Menu Down once so Options System is displayed at
the bottom of the screen.
b. Press the Left Softkey button to enter the Options menu.
c. ‘AutoPilot Mode’ should be highlighted, press the to
confirm.
d. Once in the AutoPilot Mode menu, select Legacy, scroll
up, and push the to confirm selection.
e. Push the Right Softkey button to exit to the main screen.
f. Hold for a couple of seconds to power o the remote
to be stored with the drive.
K 01.1332.0075 REV B | 4OLDTOWNCANOE.COM
INSTRUCTIONSINSTRUCTIONS
1
2
3
SYNCING REMOTE TO MOTOR
a. With the battery and motor plugged into the hull, deploy
the drive and ensure power is connected.
b. Turn on remote by pushing the (OK) button. Press the
again to accept the warning message.
c. Push Menu Down once, so Options System is displayed at
the bottom of the screen.
d. Press the Right Softkey button to enter the Systems menu.
e. Using the Menu Down, navigate to Pair and push the
button.
f. Press and hold the Pair button on the top of the motor
head (motor must be powered).
g. Motor will have a sustained beep when paired successfully.
h. Confirm motor function by using the Steer Left and Steer
Right arrows to turn the steering servo, the Prop button,
and the +/- to turn the motor shaft on.
SETTING BOAT LENGTH OFFSET
a. Push Menu Down once so Options System is displayed at
the bottom of the screen.
b. Press the Right Softkey button to enter the System menu.
Using the Menu Down, navigate to Boat Scale and push
the button.
c. Set Boat Scale to -2, by scrolling to -2 and pushing the
button.
d. Push the Right Softkey button to exit to the main screen.
3a
2a
3d
2c
3e
2d
3c
2b
1d 1e
1f
Pair Button
