Jura IMPRESSA C5 User manual

IMPRESSA C5 – Quick Reference Guide
The 'IMPRESSA Manual' and this 'IMPRESSA C5 –
Quick Reference Guide' have together been awarded the
seal of approval by the independent German Technical
Inspection Agency, TÜV SÜD, due to their easy-to-
understand style, their thoroughness and coverage of
safety aspects.

2
IMPRESSA C5 – Quick Reference Guide
This Quick Reference Guide does not replace the 'IMPRESSA
C5 Manual'. Please read first and take careful note of the safety
and warning information to avoid any danger.
When the IMPRESSA is switched on, a prompt to perform a
rinse operation automatically appears.
Precondition: your IMPRESSA is switched on at the power
switch and the On/Off symbol gis illuminated (standby).
m l Press the Rotary Switch to switch the IMPRESSA on.
The machine is heating up, the Maintenance symbol hwill
flash.The Maintenance symbol hlights up.
Place a receptacle under the coffee spout.
m l Press the Rotary Switch to start the rinse operation.
The coffee spout will be rinsed.The operation stops auto-
matically and your IMPRESSA is now be ready for use.
A classic Italian recipe. The Cappuccino consists one-third of
Espresso, hot milk and milk foam. It is finished with a sprinkling
of cocoa powder.
Precondition: your IMPRESSA is ready to use, the Easy-Auto-
Cappuccino Frother is mounted.
Take the milk pipe out of the Welcome Pack.
Take the protective cap off the Easy-Auto-Cappuccino
Frother.
Attach the milk pipe to the frother.
Insert the other end in a milk Tetrapack or connect it to
a milk container.
l
l
l
l
l
Switching onSwitching on
CappuccinoCappuccino

3
IMPRESSA C5 – Quick Reference Guide
Place a cup under the Easy-Auto-Cappuccino Frother.
ä l Turn the Rotary Switch so that it points to the Steam
symbol k.
m l Press the Rotary Switch to confirm your choice.
The Steam symbol kwill continue flashing until the
IMPRESSA has warmed up. As soon as the required
temperature has been reached, the light segment by the
switch will flash.
r l Turn the switch in the anticlockwise direction.
The milk foam will be prepared.
t l Turn the switch in the clockwise direction when there is
sufficient milk foam in the cup.
As long as the light segment continues to flash on the
switch, you can continue preparing milk foam.
Move the cup under the coffee spout.
ä l Turn the Rotary Switch to the 1 Espresso setting a.
m l Press the Rotary Switch to initiate preparation of the
Espresso.
The 1 Espresso symbol awill now flash, and the pre-set
amount of water will flow into the cup.
Drink preparation stops automatically.
To ensure that the Easy-Auto-Cappuccino Frother works per-
fectly, you should clean it regularly. Further information on this
subject can be found under 'Cleaning the Easy-Auto-Cappuccino
Frother'.
Your IMPRESSA no longer has to be de-scaled if you are using
CLARIS plus filter cartridges.
Perform the 'Using filter' operation without a break. This
will ensure that your IMPRESSA always produces its
best.
Remove the packaging on the CLARIS plus filter car-
tridge.
l
o
l
o
l
Using and activating
filter
Using and activating
filter

4
IMPRESSA C5 – Quick Reference Guide
Remove the water tank and empty it.
Lift the cartridge holder and insert the filter cartridge
into the water tank, applying a light pressure.
Close the cartridge holder. It will lock into place audibly.
Fill the water tank with cold, fresh tap water and rein-
sert.
After two months,the filter will cease to work. Monitor the
elapsed time as shown on the date plate on the cartridge
holder.
Precondition: your IMPRESSA must be switched off (standby
mode).
Open the access door.
n l Hold down the Filter button until the Filter indicator n
lights up.
ä l Turn the Rotary Switch until the 3 light segments around
the Rotary Switch lights up.
When the 3 light segments light up, this means that the
filter is activated. If none of the light segments light up,
this means that the filter has not been activated.
m l Press the Rotary Switch to confirm the setting.
The light segment by the switch will now flash.
Place a receptacle (containing at least 500 ml) under
the Easy-Auto-Cappuccino Frother.
If the milk pipe is connected, remove it.
l
l
l
l
o
l
o
l
l

5
IMPRESSA C5 – Quick Reference Guide
r l Turn the switch in the anticlockwise direction.
Rinsing of the filter will now begin.The light segment by
the switch will light up.
The water could be slightly discoloured. This is not harmful to
health, nor does it affect the taste.
Rinsing of the filter will automatically stop after approx.
500 ml, and the light segment by the switch will then
flash.
t l Turn the switch in the clockwise direction.
The IMPRESSA will switch itself off (into standby
mode).The filter is now activated.
After 50 litres of water have been dispensed, the filter will
cease to work.Your IMPRESSA will automatically prompt
you to replace the filter.
After two months,the filter will cease to work. Monitor the
elapsed time as shown on the date plate on the cartridge
holder.
If the CLARIS plus filter cartridge is not activated, you
will not be prompted to change the filter.
Precondition:theMaintenanceindicatorandtheFilterindicator n
are illuminated
.
Remove the water tank and empty it.
Lift the cartridge holder.
Take out the old CLARIS plus filter cartridge.
Insert the new CLARIS plus filter cartridge into the
water tank, pressing it lightly.
Close the cartridge holder.
It will lock into place audibly.
Fill the water tank with cold, fresh tap water and reinsert .
o
o
o
l
l
l
l
l
l
Changing the filterChanging the filter

6
IMPRESSA C5 – Quick Reference Guide
Place a receptacle (containing at least 500 ml) under
the Easy-Auto-Cappuccino Frother.
If the milk pipe is connected, remove it.
n l Hold down the Filter button until the Filter indicator n
flashes.
The light segment by the switch will now flash.
r lTurn the switch in the anticlockwise direction.
Rinsing of the filter will now begin.The light segment by
the switch will now light up.
The water could be slightly discoloured. This is not harmful to
health, nor does it affect the taste.
Rinsing of the filter will automatically stop after approx.
500 ml, and the light segment by the switch will then
flash.
t l Turn the switch in the clockwise direction.
The Maintenance symbol hflashes, the IMPRESSA
heats up and is once again ready for use.
After dispensing 200 cups of coffee or performing 80 switch-on
rinses, the IMPRESSA will prompt you to clean it.
If the wrong cleaning agent is used,the machine could be damaged
and/or traces of detergent could be left behind in the water.
Use only original JURA care products.
The cleaning program only lasts about 15 minutes.
Do not interrupt the cleaning program, as this will impair
the quality of cleaning.
Your dealer will stock JURA cleaning tablets.
l
l
l
o
o
o
Cleaning the machineCleaning the machine
CAUTIONCAUTION

7
IMPRESSA C5 – Quick Reference Guide
Precondition: the Maintenance indicator and the Cleaning
indicator vare illuminated.
v l Hold down the Cleaning button until the Cleaning indica-
tor vflashes.
The coffee grounds container indicator xnow flashes.
Empty the drip tray and the coffee grounds container.
Insert the empty drip tray and coffee grounds container
back in the machine.
The Cleaning indicator vwill now light up.
Place a receptacle under the coffee spout.
v l Press the Cleaning button.
The Cleaning indicator vnow flashes. Water flows out
of the coffee spout.
The process is interrupted.The pre-ground coffee symbol j
flashes and the Cleaning indicator vlights up
.
Open the cover of the filler funnel for pre-ground coffee.
Insert a JURA cleaning tablet into the filler funnel.
Close the cover of the filler funnel.
v l Press the Cleaning button.
The Cleaning indicator vnow flashes.Water flows out
of the coffee spout once again.
The operation stops, the coffee grounds container
indicator xflashes.
Empty the drip tray and the coffee grounds container.
Insert the empty drip tray and coffee grounds container
back in the machine.
The cleaning operation is now complete.The Maintenance
symbol hflashes, the IMPRESSA heats up and is once
again ready for use.
l
l
l
l
l
l
l
l

8
IMPRESSA C5 – Quick Reference Guide
The IMPRESSA builds up deposits of limescale over time and
automatically prompts you to de-scale it when necessary. The
degree of calcification depends on the degree of hardness of your
water.
If the descaling agent comes into contact with the skin or eyes,
this can cause irritation.
Avoid contact with the skin or eyes.
Rinse the descaling agent off with clean water. Should you
get any descaling agent in your eye, see a doctor.
If the wrong descaling agent is used, the machine could be
damaged and/or traces of detergent could be left behind in the
water.
Use only original JURA care products.
If the descaling operation is interrupted, it is possible that the
machine could be damaged.
Allow the descaling program to run to the end.
If the descaling agent comes into contact with sensitive surfaces,
the possibility of damage cannot be excluded.
Clean up any splashes immediately.
The descaling program lasts approx. 40 minutes.
Your dealer will stock JURA descaling tablets.
Precondition: the Maintenance indicator and the Descaling
indicator bare lit up.
b l Hold down the Descaling button until the Descaling
indicator bflashes.
The coffee grounds container indicator xnow flashes.
Empty the drip tray and the coffee grounds container.
Insert the empty drip tray and coffee grounds container
back in the machine.
The Water Tank indicator ynow flashes.
Remove the water tank and empty it.
l
l
l
l
l
o
o
l
l
l
Descaling the machineDescaling the machine
CAUTIONCAUTION
CAUTIONCAUTION
CAUTIONCAUTION
CAUTIONCAUTION

9
IMPRESSA C5 – Quick Reference Guide
Completely dissolve the contents of one blister (3 JURA
descaling tablets) in a container that holds 500 ml of
water.This can take a few minutes.
Pour the solution into the empty water tank.
Insert the water tank.
The light segment by the switch will now flash.
Remove the frother.
Place a container under the Connector System©.
r lTurn the switch in the anticlockwise direction.
This causes water to flow out of the Connector System©.
The light segment by the switch lights up during the
descaling operation.
The operation stops automatically, and the light segment
by the switch flashes.
t l Turn the switch in the clockwise direction.
The descaling operation will resume. After a few minutes,
the coffee grounds container indicator xflashes.
Empty the container under the Connector System©.
Empty the drip tray and the coffee grounds container.
Insert the empty drip tray and coffee grounds container
back in the machine.
The Water Tank indicator ynow flashes.
Rinse the water tank thoroughly and fill it with cold,
fresh tap water.
Put the water tank back in.
Place a container under the Connector System©.
The light segment by the switch will now flash.
l
l
l
l
l
l
l
l
l
l
l

10
IMPRESSA C5 – Quick Reference Guide
r lTurn the switch in the anticlockwise direction.
This causes water to flow out of the Connector System©.
The operation stops automatically, and the light segment
by the switch flashes.
t l Turn the switch in the clockwise direction.
The descaling operation will resume. After a few minutes,
the coffee grounds container indicator xflashes.
Empty the drip tray and the coffee grounds container.
Insert the empty drip tray and coffee grounds container
back in the machine.
Put back the frother.
The descaling operation is now complete.The Maintenance
symbol hflashes, the IMPRESSA heats up and is once
again ready for use.
If the descaling operation stops unexpectedly, rinse the
water tank thoroughly.
To ensure that the Easy-Auto-Cappuccino Frother works
perfectly, you should rinse it with water whenever you have
prepared some milk.
The IMPRESSA will not prompt you to rinse the Easy-
Auto-Cappuccino Frother.
Carefully remove the Easy-Auto-Cappuccino Frother
from the Connector System©.
Take the Easy-Auto-Cappuccino Frother apart.
Rinse all the frother parts thoroughly under running water .
Reassemble the Easy-Auto-Cappuccino Frother and
attach it to the Connector System©.
l
l
l
o
o
l
l
l
l
Rinsing the Easy-
Auto-Cappuccino
Frother
Rinsing the Easy-
Auto-Cappuccino
Frother