
8
ENGLISH
PTY Standby Reception
PTY Standby Reception allows the unit to switch
temporarily to your fa orite PTY programme from any
source other than AM.
To activate and select your favorite PTY code for
PTY Standby Reception, see page 13.
The PTY indicator either lights up or flashes.
• If the PTY indicator lights up, PTY Standby Reception
is acti ated.
• If the PTY indicator flashes, PTY Standby Reception is
not yet acti ated.
To acti ate PTY Standby Reception, tune in to another
station pro iding these signals. The PTY indicator will
stop flashing and remain lit.
To deactivate the PTY Standby Reception, select
“OFF” for the PTY code (see page 13). The PTY indicator
goes off.
Tracing the same programme—
Network-Tracking Reception
When dri ing in an area where FM reception is not
sufficient enough, this unit automatically tunes in to
another FM RDS station of the same network, possibly
broadcasting the same programme with stronger
signals (see the illustration below).
When shipped from the factory, Network-Tracking
Reception is acti ated.
To change the Network-Tracking Reception
setting, see “AF-REG” on page 12.
Programme A broadcasting on different frequency areas
(01 – 05)
2 Select the preset number (1 6) you want to
store into.
3 Repeat steps 1 and 2 to store other PTY
codes into other preset numbers.
4 Finish the procedure.
Using the standby receptions
TA Standby Reception
TA Standby Reception allows the unit to switch
temporarily to Traffic Announcement (TA) from any
source other than AM.
The olume changes to the preset TA olume le el if the
current le el is lower than the preset le el (see page
13).
To activate TA Standby Reception
The TP (Traffic Programme) indicator
either lights up or flashes.
• If the TP indicator lights up, TA Standby Reception is
acti ated.
• If the TP indicator flashes, TA Standby Reception is
not yet acti ated. (This occurs when you are listening
to an FM station without the RDS signals required for
TA Standby Reception.)
To acti ate TA Standby Reception, tune in to another
station pro iding these signals. The TP indicator will
stop flashing and remain lit.
To deactivate the TA Standby Reception
The TP indicator goes off.
Ex.: When “ROCK M” is selected
EN06-11_KD-G333_003A_f.indd 8EN06-11_KD-G333_003A_f.indd 8 9/7/06 9:21:53 AM9/7/06 9:21:53 AM