JWA ALAN 69518 User manual

1
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
ALAN
ITEM CODE 69518
ETU

PRE-ASSEMBLY PREPARATION
Before you start:
1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the
product
2.Take care when lifting. Product should be assembled as near as possible to the point of
use
3.Ensure that you have all required contents for complete assembly
4.Always read the assembly instructions carefully before beginning assembly.
5.Keep all hardware parts and packaging out of reach of small children.
6.Do not over tighten the screws and bolts as this may damage the threads
2
Allow 30 min For 2 person Additional tools required

3
PARTS LIST

4
PARTS LIST

5
STEP 1:
STEP 2:
Ax8 Mx2
Cx8Bx8
Hx6

STEP 3:
6
STEP 4:
Cx8 Dx8
Ex8
Nx1

STEP 5:
7
STEP 6:
Fx4
Gx20

STEP 7:
8
STEP 8:
Jx4Ix2
Kx8Lx4
x2
Kx8

9
ASSEMBLY IS COMPLETE

10
SAFETY BRACKETS
INSTRUCTIONS
1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to
attach the Mounting Plate into a stud. If mounting into brick or masonry you
will need to acquire wall anchors.
2. Attach the second Mounting Plate to the furniture frame with the Short
Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and
furniture and that the Wall Strap is snug.