JWA MARTOS 68546 User manual

ASSEMBLY INSTRUCTION
MARTOS LAMP TABLE
ITEM CODE 68546
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
1

PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose aclean, level, sparea.Avoid hard surfaces that may
damage the product
2. Take care when li ꢁ ing. Product sembled as the
point of use
3. Ensure that you have all required co for complete assembly
4. Always read the assembly instruclly before beginning assembly.
5. Keep all hardware parts out of reach mall children.
6. Do not over ꢀ ghten the screws ydamage the threads
7. Assembly is to be carried out by acompet(s)ONLY
8. During assembly, children yfrom the product due to possible
risk to injury.
9. Do not use this item if any components are missing or damaged.
Allow 20 min For 1person Addi ꢀ onal tools required
2

A
E
I
B C
G
D
M7X39mm M15X12mm M8X30mm M5X40mm
6pcs 6pcs 12pcs 6pcs
4pcs
1pcs
F H
M3.5X14mm M4X14mm
20pcs
1pcs 12pcs
4pcs
1pcs
JCL
K
M3X16mm M4x30mm M3.5x14mm 1pcs
6pcs
1pcs
DL DR
CR
1pcs
1 6
IDE PANEL DRAWER SIDE PANEL
DRAWER BACK PANEL
DRAWER BASE
2
3
4
5
7
8
SIDE PANEL
BOTTOM PANEL
TOP PANEL 9DRAWER FRONT
BACK PANEL
10
DRAWER SIDE PANEL
3

STEP 1
STEP 2:
4

STEP 3:
STEP 4:
5

STEP 5:
STEP 6:
6

STEP 7:
STEP 8:
7

STEP 9:
ASSEMBLY COMPLETE
8

SAFETY BRACKETS
INSTRUCTIONS
1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to
attach the Mounting Plate into a stud. If mounting into brick or masonry you
will need to acquire wall anchors.
2. Attach the second Mounting Plate to the furniture frame with the Short
Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and
furniture and that the Wall Strap is snug.
HARDWARE
Mounting Plate x 2 Wall Strap x 1 Large Screw x 2 Small Screw x 2
Back side
Wall
K
9

To protect your furniture, we suggest the following:
•Avoid placing your furniture in direct sunlight.
•Do not place furniture directly under windows.
•Do not place sharp materials (knife, fork, etc.) directly onto
your furniture as sharp material may scrape and damage the
finish.
•Do not place material with high temperature directly onto the
surface of your furniture.
•Clean up spills quickly. Water left over a prolonged period of
time may cause damage. Alcohol, perfume, nail polishes,
aftershave and some medication may cause severe finish
damage if not cleaned immediately.
•Use a clean, soft, dry, lint free absorbent cloth to clean your
furniture. Do not use any detergent as they may contain
ingredients that may react and damage the finish.
NOTE: If the above care advise is not adhered to your product
warranty may become void
10