JWA ERICA 69386 User manual

Imported by JWA FurniturePty Ltd, Qld, Brisbane Australia.
For anyassistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
1
69386
2 Tier Shoe Rack
ERICA
ITEM CODE
530MM
180MM
765MM

PRE-ASSEMBLY PREPARATION
Before you start:
1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the
product
2.Take care when ling. Product should be assembled as near as possible to the point of
use
3.Ensure that you have all requiredcontents for complete assembly
4.Always read the assembly instrucons carefully before beginningassembly.
5.Keep all hardware partsand packaging out of reach of small children.
6.Do not over ghten the screws and bolts as this may damage the threads
Allow 30 min For 1 person Addionaltools required
2

PARTS LIST
3

4
NO. ITEM QTY NO. ITEM QTY
A6PCS
B6PCS
C4PCS
D24PCS
E4PCS
4PCS
F
4PCS
H
1PC
Y
4PCSG
NO. ITEM QTY NO. ITEM QTY
1RIGHT DRAWER BRACKET 2 PCE
2
3
2 PCE
2 PCE
42 PCE
52 PCE
61 PC
71 PC
1 PC
91 PC
10 1 PC
Φ5*40
Φ7*10
Φ6*30
Φ3*25
Φ5*20
Φ12*24
Φ6*35
Φ12*10
LEFT DRAWER BRACKET
DRAWER BOTTOM PANEL
DRAWER BACK PANEL
DRAWER FRONT PANEL
LEFT SIDE PANEL
RIGHT SIDE PANEL
TOP PANEL
BACK PANEL
11
SUPPORT PANEL
BACK PANEL 1 PC
8
12
13
SUPPORT PANEL 1 PC
SUPPORT PANEL 1 PC
PARTS LIST

STEP 1:
STEP 2:
5
D X8E X4
X2
D X16
X2

STEP 3:
STEP 4:
6
C X4
B X6
A X3
F X2

STEP 5:
STEP 6:
7
F X2A X3

STEP 7:
STEP 8:
8
Y X1G X4
H X4

STEP 9:
9
Y X1

ASSEMBLY IS COMPLETE
10

11
SAFETY BRACKETS
INSTRUCTIONS
1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to
attach the Mounting Plate into a stud. If mounting into brick or masonry you
will need to acquire wall anchors.
2. Attach the second Mounting Plate to the furniture frame with the Short
Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and
furniture and that the Wall Strap is snug.
WALL
BACK SLDE
SCREWS X1 SCREWS X1WALL FIXING X1 Expanded plastic pipe X1
HARDWARE

To protect your furniture, we suggest the following:
• Avoid placing your furniture in direct sunlight.
• Do not place furniture directly under windows.
• Do not place sharp materials (knife, fork, etc.) directly onto
your furniture as sharp material may scrape and damage the
finish.
• Do not place material with high temperature directly onto the
surface of your furniture.
•Clean up spills quickly. Water left over a prolonged period of
time may cause damage. Alcohol, perfume, nail polishes,
aftershave and some medication may cause severe finish
damage if not cleaned immediately.
• Use a clean, soft, dry, lint free absorbent cloth to clean your
furniture. Do not use any detergent as they may contain
ingredients that may react and damage the finish.
NOTE: If the above care advise is not adhered to your product
warranty may become void
12