JWA KYTHIRA BLACK TOURNAMENT ELITE GAMING TABLE... User manual

KYTHIRA BLACK TOURNAMENT ELITE GAMING TABLE
70621
1200mm
500mm
175mm
600mm
782mm
110mm

4

Tabletop
1
Monitor Stand
6
Left leg
2
Right leg
3
Connecting Rod
5
Cross-bar
4

1
INSTALLATION STEPS
×4
A) Adjustable pad
Tools
×2
K) Cable management
×4
G) Decorative cover
B) M6×35mm
×12 ×4
C) M6×10mm D)
M6×12mm
×3
F) M5×12mm
I) Power cord J) Connection cable
) Controller
H
E) Wing nut M6
3
A×4
2
×4
Swirl adjustable pad A (x4) into base
A

INSTALLATION
2
4
Unscrew the screws on
both sides of the cross-bar
Press each table leg in the
slot at right and left side
Snap the cross-bar
into the leg and lock
with screws
Tools

3
3
C×4
Put the frame down
Fix with C(×4)
5
E
D
Combine with D and E
5
5
Tools
×4
C
E
D

4
7
G×4
Fix G(×4)
×4
G

7
5
8
1
B×4

6
9
B×8
Fix by B(×8)
6
6
×8
B
Tools

7
10
F×3
H
F
×3
H
Tools

8
11
I
K
Tips
Uncover the back glue of K and stick it under the desktop,
K can be used to arrange cables
Cables

12
Manual controller instruction
Front view
Headphone port Microphone port
Power button：Press for 3 seconds to turn on the light;
Press for 3 seconds to turn off the light.
M(Mode button)：3 modes:1)Single color mode
2)RGB color mode
3)Music mode
Press the button for cycle mode switching.
C(Color button)：Press to change the color with 8 options;
Long press to adjust the brightness of light.
Music mode：The light would flash with the sound of music.
Better to adjust the volume of the computer to
30-60 for the best experience.
Back view
Power port USB Port
Only for 5V/2.5A
1 for single color light
2&3 for RGB light Audio port
1 2 3
Connection cable：Green for headphone port of computer;
Red for microphone port of computer

General Product Care
To protect your furniture, we suggest the following:
Avoid placing your furniture in direct sunlight.
Do not place furniture directly under windows.
Do not place sharp materials (knife, fork, etc.) directly onto your furniture
as sharp material may scrape and damage the finish.
Do not place material with high temperature directly onto the surface of
your furniture.
Clean up spills quickly. Water left over a prolonged period of time may
cause damage. Alcohol, perfume, nail polishes, aftershave and some
medication may cause severe finish damage if not cleaned immediately.
Use a clean, soft, dry, lint free absorbent cloth to clean your furniture.
Do not use any detergent as they may contain ingredients that may react
and damage the finish.
13

6
SAFETY BRACKETS
INSTRUCTIONS
1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to
attach the Mounting Plate into a stud. If mounting into brick or masonry you
will need to acquire wall anchors.
2. Attach the second Mounting Plate to the furniture frame with the Short
Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and
furniture and that the Wall Strap is snug.
14