JWA LUGANO 72391 User manual

1
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
LUGANO
72391
DESK

Allow 30 min For 2 person
PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
2. Take care when lifting. Product should be assembled as near as possible to the
point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
7. Assembly is to be carried out by a competent adult(s) ONLY
8. During assembly, children should be kept away from the product due to possible
risk to injury.
9. Do not use this item if any components are missing or damaged.
10. Please keep the instructions for future reference.
2

3
PARTS LIST
1 Tabletop 1PC
2 Legs 2PCS
3 Sbelf 2PCS
M6*25MM M6*30MM

4
STEP 1:
STEP 2:

5
STEP 3:

6
ASSEMBLY IS COMPLETE

7
SAFETY BRACKETS INSTRUCTIONS
1. Install Plastic Screw Anchor in the wall and attach one Mounting Plate to the anchors
with the Large Screws. Make sure to attach the Mounting Plate into a stud.
2. Attach the second Mounting Plate to the furniture frame with the Short Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and furniture and
that the Wall Strap is snug.
5. NOTE: Please adjust the installation mode of the safety bracket according to the
actual situation.

8
PRODUCT CARE:
As our timber is supplied from sustainable forests there will
be natural variations in surface texture and grain like knots,
mineral streaks and sap runs that may affect the finish. These
differences in character are not defects, but distinctions that
make each piece of furniture unique
•Our furniture is built to last. Following these steps for basic
care should protect your investment for years to come
•Dust frequently with a clean damp lint-free cloth. This will
help remove abrasive build up which can damage a finish
over time
•Do not place hot objects on any furniture surface. Always
use a hot plate or placemat. Laminate and lacquer finishes
on table tops provide added scratch and heat resistance to
our furniture, but they can still be damaged without proper
care
•Avoid exposing your furniture to strong sunlight, heat outlet,
open windows or dampness. Prolonged exposure to direct
sunlight can fade the finish of your furniture, while extreme
temperature and humidity changes can cause cracking or
splitting
•Do not expose your furniture to any liquids. Never allow
water to sit on your furniture. Alcohol, nail polish and
perfume are also dangerous as they will dissolve the
lacquer finish on contact and may require professional
repairs
•Do not allow plastic to come in direct contact with your
furniture. Chemicals in the plastic of placemats etc. may
soften and mark the finish if left in contact with the furniture
for a period of time