JWA OTTAWA 68321 User manual

Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
OTTAWA
68321
Grey Bench and Stool Set
1

2
SAFETY BRACKETS INSTRUCTIONS
1. Install Plastic Screw Anchor in the wall and attach one Mounting Plate to the anchors
with the Large Screws. Make sure to attach the Mounting Plate into a stud.
2. Attach the second Mounting Plate to the furniture frame with the Short Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and furniture and
that the Wall Strap is snug.
5. NOTE: Please adjust the installation mode of the safety bracket according to the
actual situation.

3
PRODUCT CARE:
REGULAR CARE:
•Protect from direct sunlight
•Vacuum regularly using low suction
•Rotate reversible cushions regularly
•Avoid exposure to new clothing, cushions or throws as this may lead to dye
transfer and permanent staining
CLEANING:
•Do not remove cushion covers for separate cleaning even though they may
have zippers
•Do not wash, Do not dry clean, Do not shampoo clean
•Clean only with hot water extraction machine. Professional cleaning
recommended
•Do not use dishwashing liquid or laundry detergent. Use only upholstery
detergents
•Do not wet filling
•Dry in shade away from direct heat and sunlight
•Allow to dry thoroughly before re-use
SPOT CLEANING:
•Do not rub
•Do not spot clean with any solvent
•Treat spills and stains as soon as possible
•Gently scrape off any soil or blot any liquid from the surface of the fabric before
applying cleaner
•Apply proprietary cleaning agents strictly according to instructions to remove the
residue of the spill
•Do not saturate the fabric or interior with water or other cleaning liquids
WARNING:
Apply only water-based soil resist (fabric protection) treatments. Do not use
aerosol products
* PILLING IS NOT A FABRIC DEFECT OR FAULTAND IS NOT COVERED BY
WARRANTY
* PILLING IS ANORMAL OCCURRENCE CAUSED BY WEARAND TEAR AND
DOES NOT AFFECT THE DURABILITY OR FUNCTIONALITY OF THE FABRIC
AND IS EASILY REMOVED