JWA RODGER 70145 User manual

ASSEMBLY INSTRUCTION
RODGER OFFICE CHAIR
70145
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
1

PRE-ASSEMBLY PREPARATION
Before you start:
1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product
2.Take care when lifting. Product should be assembled as near as possible to the point of use
3.Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
2

PARTS LIST
1
Backrest
6
Gas lift cover
2
Seat
7
Gas lift
3
Armrest
8
Base
4
Armrest
9
Castors
5
Seat plate
3

STEP 1:
a. Push all the five castors ⑨ into the underside of the base ⑧.
b: Insert the gas lift ⑦ into the base ⑧.Use gas lift cover ⑥ to cover the gas lift
⑦.
4
STEP 2:
Use bolts (A) and washer(C) to fix the seat plate ⑤
onto the seat ②.

STEP 3:
STEP 4:
Use bolts (B) to fix the second screw on the armrest
③ and ④ onto the backrest ①.
5
Use bolts (B) to fix the armrest ③ and ④ onto two sides of chair
seat ②, and install the seat ② on the whole base ⑧.

STEP 5:
Use bolts (B) to fix the first screw on the
armrest ③ and ④ onto the backrest ①.
Then open the backrest ①.
6
STEP 6:
Put the screw cap(D) for the armrest.

ASSEMBLY IS COMPLETE

8
REGULAR CARE:
•Protect from direct sunlight
•Vacuum regularly using low suction
•Rotate reversible cushions regularly
•Avoid exposure to new clothing, cushions or throws as this may lead
to dye transfer and permanent staining
CLEANING:
•Do not remove cushion covers for separate cleaning even though they
may have zippers
•Do not wash, Do not dry clean, Do not shampoo clean
•Clean only with hot water extraction machine. Professional cleaning
recommended
•Do not use dishwashing liquid or laundry detergent. Use only
upholstery detergents
•Do not wet filling
•Dry in shade away from direct heat and sunlight
•Allow to dry thoroughly before re-use
SPOT CLEANING:
•Do not rub
•Do not spot clean with any solvent
•Treat spills and stains as soon as possible
•Gently scrape off any soil or blot any liquid from the surface of the
fabric before applying cleaner
•Apply proprietary cleaning agents strictly according to instructions
to remove the residue of the spill
•Do not saturate the fabric or interior with water or other cleaning
liquids
WARNING: Apply only water-based soil resist (fabric protection)
treatments. Do not use aerosol products
*PILLING IS NOT A FABRIC DEFECT OR FAULT AND IS NOT COVERED
BY WARRANTY
*PILLING IS A NORMAL OCCURRENCE CAUSED BY WEAR AND TEAR
AND DOES NOT AFFECT THE DURABILITY OR FUNCTIONALITY OF
THE FABRIC AND IS EASILY REMOVE