JWA LOZANO 716650001 User manual

1
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
LOZANO
ITEM CODE 716650001
COFFEE TABLE

Allow 15 min For 1 person Additional tool
required
2
PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
2. Take care when lifting. Product should be assembled as near as possible to the
point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
7. Assembly is to be carried out by a competent adult(s) ONLY
8. During assembly, children should be kept away from the product due to possible
risk to injury.
9. Do not use this item if any components are missing or damaged.
10. Please keep the instructions for future reference.

3
PARTS LIST
1 Table Top x1
2 Side Frame x2
3 Top Frame x1
4 Bottom Bar x2
A M6X16MM LONG BOLT WITH
WASHER
6 SETS
BHEX KEY 1 PC
CPOLISHING CLOTH 1 PC
DM6X10MM SHORT BOLT 8 PCS
ESCREW WITH
SLEEVE
2 SETS
FKNOB 2 PCS
GPLASTIC FOOT 4 PCS

4
STEP 1:
•Prepare a surface with a protective blanket or cardboard.
•Connect side frame(2) top frame(3) and bottom bar(4)togegher
as shown below.
•Secure with short bolt(D) per connection. Fasten with allen
key(B).
•Fasten only until the bolt is tight in the thread, do not fully fasten
for now.
•Put Plastic foot(G) into unit.

5
STEP 2:
•Place the table top(1) flat on the surface and connect to top
frame(3) using long bolt with washer(A) per connection as shown
below.
•Once levelled turn the table back on its side and fasten all the bolts.

6
STEP 3:
•Remove the knob(F) from inside of drawer to outside.
•Connect knob(F) to drawer using screw with sleeve(E) as shown
below.

7
ASSEMBLY IS COMPLETE

8
PRODUCT CARE:
If the glass is chipped or broken, stop using the product and consult
place of purchase
WARNING:
•Do not place very hot or cold items directly onto the glass
surface,unless a coaster or placemat are used to prevent the items
from coming into direct contact with the glass
•Do not sit or stand upon the glass surface
•Do not use the glass as a chopping surface
•Do not strike the glass with hard or pointed items
•When cleaning glass panels use a damp cloth or lather with washing
up liquid or soft soap if necessary. Do not use any cleaning substances
that contain obrasive properties,as these could scratch or damage the
glass.