JWA 69491 User manual

1
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
PINE CREEK
ITEM CODE 69491
ETU

PRE-ASSEMBLY PREPARATION
Before you start:
1.Choose aclean, level, spacious assembly area.Avoid hard surfaces that may damage the
product
2.Take care when lifting.Product should be assembled as near as possible to the point of
use
3.Ensure that you have all required contents for complete assembly
4.Always read the assembly instructions carefully before beginning assembly.
5.Keep all hardware parts and packaging out of reach of small children.
6.Do not over tighten the screws and bolts as this may damage the threads
2
Allow 45 min For 2person Additional tools required

PARTS LIST
1Top panel
2Bottom panel
3Middle panel
4Layer panel
5Layer panel
F1 Metal frame
F2 Connection pipe
3

4

Connect F1 to F2 with fitting B, and lock. Then fix the four
corner with fitting E and lock by the fitting C.
STEP 1:
Assemble the bottom panel 2 to the connection pipe with
fitting B.
STEP 2:
5

Assemble Panel 3 to panel 4 with fitting A.
STEP 3:
Assemble Panel 5 to panel 3 with fitting A.
STEP 4:
6

Put the main frame down for easy installation. Assemble the
component into the main frame and connect the Panel 3 to
Panel 2 with fitting A.
STEP 5:
Assemble the Panel 5 to main frame with fitting D.
STEP 6:
7

Install fitting I to the bottom of Panel with fitting G, and assemble Panle 1 to
Panel 3 with litting A and connect to main fram with fitting B.
STEP 7:
8
Punch holes in the wall at the appropriate position and insert the glue J,
lock fitting H through fitting I to the wall.
STEP 8:

9
ASSEMBLY IS COMPLETE

SAFETY BRACKETS
INSTRUCTIONS
1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to
attach the Mounting Plate into a stud. If mounting into brick or masonry you
will need to acquire wall anchors.
2. Attach the second Mounting Plate to the furniture frame with the Short
Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and
furniture and that the Wall Strap is snug.
10