JWA NOVI 68426 User manual

1
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
NOVI
68426
Lamp Table

Allow 15 min For 1 person
PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
2. Take care when lifting. Product should be assembled as near as possible to the
point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
7. Assembly is to be carried out by a competent adult(s) ONLY
8. During assembly, children should be kept away from the product due to possible
risk to injury.
9. Do not use this item if any components are missing or damaged.
10. Please keep the instructions for future reference.
2

3
PARTS LIST
1 Tabletop 1PC
2 Legs 4PCS
WASHER SPRING WASHER M6*25MM

4
STEP 1:
•Prepare a floor or bench area, with protective blanket or
blanket.
•Lay down the tabletop ①, underside facing up.
•Insert the 4 x legs ②into the tabletop as shown below.
•Secure the legs with the bolts from step 1. Fasten using
Allen Key (D).
•Tighten only until the bolt is a little firm in the thread, do
not fasten completely.
•Start by preparing the 8x bolts(C), with the 8x washers(A)
and 8x spring washers(B). As shown below.
STEP 2:

5
STEP 3:
ASSEMBLY IS COMPLETE
•Stand the table the right way up on a level surface.
•Push down on the table until it levels out. Do not lean
beyond your own balance.
•Once level, flip the table back over again (upside down).
Now fully fasten all the bolts. Do not over tighten, this
may damage the product.

6
SAFETY BRACKETS INSTRUCTIONS
1. Install Plastic Screw Anchor in the wall and attach one Mounting Plate to the anchors
with the Large Screws. Make sure to attach the Mounting Plate into a stud.
2. Attach the second Mounting Plate to the furniture frame with the Short Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and furniture and
that the Wall Strap is snug.
5. NOTE: Please adjust the installation mode of the safety bracket according to the
actual situation.

7
PRODUCT CARE:
To protect your furniture, we suggest the following:
•Avoid placing your furniture in direct sunlight.
•Do not place furniture directly under windows.
•Do not place sharp objects (knife, fork, etc.) directly onto your
furniture as sharp objects may scrape and damage the finish.
•Do not place hot objects directly onto the surface of your furniture.
•Clean up spills quickly. Water left over a prolonged period of time
may cause damage.Alcohol, perfume, nail polishes, aftershave and
some medication may cause severe finish damage if not cleaned
immediately.
•Use a clean, soft, dry, lint free absorbent cloth to clean your
furniture. Do not use any detergent as they may contain chemicals
that may react and damage the finish.
NOTE: If the above care advise is not adhered to your product
warranty may become void