Kallista One P25202-CR User manual

INSTALLATION INSTRUCTIONS
One™ Deck-mount
Bridge Kitchen Faucet
1102265_2_A
1 of 4
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].
P25202-CR P25202-LV

INSTALLATION INSTRUCTIONS
One™ Deck-mount
Bridge Kitchen Faucet
1102265_2_A
2 of 4
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].
ThANk YOU FOR ChOOSINg kALLISTA
We appreciate your commitment to Kallista quality products. Please take a moment to review this manual be-
fore you install your Kallista product. If you encounter any installation or performance problems, please do not
hesitate to contact us at the phone number listed at the bottom of the page.
BeFORe YOU BegIN
Observe all local plumbing and building codes.
Shut off the water supplies.
Before installation, unpack the new faucet and inspect it for damage. Return the faucet to the carton until
you are ready to install it.
Carefully inspect waste and supply tubing for any sign of damage and replace if necessary.
For new installations, assemble the faucet to the sink before installing the sink.
Do not use petroleum based products on this faucet.
Kallista reserves the right to make revisions in the design of products without notice, as specied in the 
Price Book.
TOOLS ANd MATeRIALS
Adjustable
Wrench
Two 3/8” Male
Supply Connections

INSTALLATION INSTRUCTIONS
One™ Deck-mount
Bridge Kitchen Faucet
1102265_2_A
3 of 4
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].
INSTALL The FAUCeT
Sink/Countertop
Escutcheon
O-Ring
Cold Supply
Hot Supply
Stud
Bracket
Nut
Washer
Optional Sidespray
Hose Outlet
IMPORTANT! If you are mounting the faucet to an uneven surface (such as tile grout lines), apply a
suitable sealant in addition to the O-rings and gasket provided. Do not use petroleum based sealant.
Slide an escutcheon and O-ring over each of the hoses and onto the faucet.
Insert the faucet through the mounting surface with the cold supply hose to the right side of the user.
Assemble a bracket, washer, and nut to each stud from underneath the mounting surface.
Securely tighten the nuts with an adjustable wrench.
Ensure the handles are in the OFF position, as shown.

INSTALLATION INSTRUCTIONS
One™ Deck-mount
Bridge Kitchen Faucet
1102265_2_A
4 of 4
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX [phone].
INSTALL The SUPPLIeS
Hot
Cold
3" (7.6 cm)
or Larger
Optional Sidespray
Supply Outlet
CAUTION: Risk of restricted water ow and product damage. Use extreme care to avoid kinking and
twisting the supply hoses. The supply hoses must not be taut after installation.
NOTe: If the sink installation requires that you coil the supply hoses to obtain a good connection, maintain an
inside coil diameter of at least 3″ (7.6 cm).
NOTe: DO NOT remove the plug from the optional sidespray supply outlet unless you are installing the optional
sidespray.
Carefully position the hot and cold water supplies so they will not interfere with other hoses or items below
the mounting surface.
Connect and tighten the supply hoses to the supply stops. Left is hot, right is cold.
INSTALLATION CheCkOUT
Aerator
AeratorTool
Verify that all connections are tight and the handles are in the OFF position.
Turn on the main water supply.
Check all connections for leaks. Repair as needed.
Turn both handles to the ON position and allow the water to run through the spout to remove any debris.
Turn both handles to the OFF position.
NOTe: If water ow is restricted: Using the aerator tool (provided), turn the aerator clockwise to remove it from
the spout, remove the debris, then reinstall the aerator. Retain the aerator tool for future use.