Kallista P24814 User manual

INSTALLATION INSTRUCTIONS
Wall-Mount Bath Spout
1242695-2-A
1 of 5 Questions? Problems? For additional assistance, please contact KALLISTA’s Customer Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
©2014 KALLISTA
P24814

INSTALLATION INSTRUCTIONS
Wall-Mount Bath Spout
1242695-2-A
2 of 5 Questions? Problems? For additional assistance, please contact KALLISTA’s Customer Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
THANK YOU FOR CHOOSING KALLISTA
We appreciate your commitment to KALLISTA quality products. Please take a moment to review this manual
before you install your KALLISTA product. If you encounter any installation or performance problems, please do
not hesitate to contact us at the phone number listed at the bottom of the page.
BEFORE YOU BEGIN
Shut off the water supply.
Observe all local plumbing and building codes.
If needed, complete the finished wall before beginning this installation.
KALLISTA reserves the right to make revisions in the design of products without notice, as specified in the
Price Book.
TOOLSAND MATERIALS
Silicone Sealant
Plus:
• 1-1/4" copper tube or 1/2" nipple
• Emery paper
Plumbers Putty
1/8" Hex Wrench
Sealant Tape
Strap Wrench Rags

INSTALLATION INSTRUCTIONS
Wall-Mount Bath Spout
1242695-2-A
3 of 5 Questions? Problems? For additional assistance, please contact KALLISTA’s Customer Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
1. SPLIT- FIT SPOUT INSTALLATION
1-1/4"
(32 mm)
Ø 2"
(51 mm)
Hole
1/8"
Gap
NOTE: Tubes extending less than 1-1/4” (32 mm) will leak.
Install the tube.
Remove burrs with emery paper.
Apply plumbers putty or sealant to the spout. Leave a small gap.
Loosen the setcrew and slide the spout against the wall.
Firmly tighten the setscrew.
Remove the excess sealant.

INSTALLATION INSTRUCTIONS
Wall-Mount Bath Spout
1242695-2-A
4 of 5 Questions? Problems? For additional assistance, please contact KALLISTA’s Customer Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
3. THREADED SPOUT INSTALLATION
Gap
Carefully tighten the spout using a strap wrench.
Apply plumbers putty or sealant. Leave a small gap.
Remove the excess sealant.
2. THREADED SPOUT INSTALLATION
1-1/4"
(32 mm)
Ø 2"
(51 mm)
Hole
1/8"
Apply sealant tape to the 1/2” nipple.
Install the 1/2” nipple.
Remove the slip-fit assembly.

INSTALLATION INSTRUCTIONS
Wall-Mount Bath Spout
1242695-2-A
5 of 5 Questions? Problems? For additional assistance, please contact KALLISTA’s Customer Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
4. INSTALLATION COMPLETION
Aerator
Key
Turn on the water supplies and check the installation for leaks.
Repair as needed.
Remove the aerator with the aerator key.
Open the valves and run water through the spout for a minute to remove any debris.
Turn off the valves and reinstall the aerator.
Keep the aerator key for future use.