Kallista P22107 User manual

Installation Guide
Deck-Mount Bath Faucet with Riser Tubes
P22107, P22109, P22110,
P22207, P22707, P22709,
P23007
1019831-2-C

Thank You For Choosing Kallista
We appreciate your commitment to KALLISTA quality products. Please
take a moment to review this manual before you install your
KALLISTA product. If you encounter any installation or performance
problems, please do not hesitate to contact us at the phone number
listed on the back cover.
Tools and Materials
Before You Begin
IMPORTANT! For proper drainage of the spout, install the bath
faucet to a level surface.
WARNING: Risk of product damage. To avoid product
damage, do not exceed 45 psi (3.1 bars) supply pressure limit.
Observe all local plumbing and building codes.
Shut off the main water supply.
The appearance of your faucet may differ from the faucet
illustrated. The referenced components in the illustration and the
installation instructions still apply.
Before installation, unpack the new faucet trim and inspect it for
damage. Return it to the carton until installation.
Inspect all threads, connections, and O-rings to ensure they are
clean before installing.
Before installing this product, the water supplies, finished deck
material, and bath must be in place.
The installation method for deck riser tubes and floor riser tubes
are identical.
Adjustable Wrench Plumbers Putty Sealant Tape
1019831-2-C 2 Kallista

Before You Begin (cont.)
Supply connections may vary from site to site. For this
installation guide, copper supply tubing is used.
An adapter to convert an IPS thread to an NPT thread is included
with the deck/floor riser tubes.
KALLISTA reserves the right to make revisions in the design of
faucets without notice, as specified in the Price Book.
Kallista 3 1019831-2-C

1. Install the Riser Tubes and Faucet
Connect the Supplies
NOTE: Supply connections may vary from site to site. For this
installation guide, copper supply tubing is used.
For copper supply connections: Solder the female connections to
the water supply tubes, then apply thread sealant to the female
copper connections.
For all other supply connections: Connect the supplies. Use the
adapter (supplied) to convert the IPS thread to the NPT thread, if
necessary.
Install the Riser Tubes
For floor riser tubes: Ensure the escutcheon, large washer,
locknut, small washer, and adapter are assembled on each floor
riser tube (as shown). Thread the riser tubes down onto the
female copper connections until the riser tubes bottom out.
For deck riser tubes: Insert the riser tube with escutcheon
through the deck. From underneath the deck, secure the riser
tubes with a washer and locknut.
For all installations:
Apply plumbers putty to the underside of each escutcheon, then
press each escutcheon against the finished floor/deck. Wipe away
any excess putty.
Insert a supply washer into each yoke of the bath faucet.
Female Copper
Connection
Riser Tube
Water Supply Tube
Escutcheon
Large Washer
Locknut
Small Washer
Adapter
Supply Washer
Yoke
Supply Nut
1019831-2-C 4 Kallista

Install the Riser Tubes and Faucet (cont.)
Slide the yokes of the bath faucet onto the riser tubes.
NOTE: Wrap a clean cloth around the supply nuts before tightening
the supply nuts with a wrench. This will protect the finish.
Wrench tighten the supply nut on each yoke to secure the bath
faucet to the riser tubes.
Kallista 5 1019831-2-C

2. Install the Handshower
Insert the washer into the nut of the bracket assembly.
Wrench tighten the nut of the bracket assembly to the hose outlet
on the bath faucet.
Secure the female hose end to the hose outlet on the bracket
assembly.
Secure the male hose end to the handshower.
Place the handshower on the cradle.
3. Installation Checkout
Ensure that all connections are watertight.
Open the drain.
Open the main water supply and check for leaks. Repair as
necessary.
Open both hot and cold valves and run water through the spout
for one minute to remove debris.
Activate the handshower. Check for leaks at the flexible hose and
handshower hose connections.
Close the valves.
Nut
Washer
Bracket
Assembly
Hose Outlet on
Bath Faucet
Hose
Outlet
Cradle
Male
Hose End
Female
Hose End
1019831-2-C 6 Kallista

1019831-2-C

USA/Canada: 1-888-4-KALLISTA
Fax: [phone]
kallista.com
©2018 KALLISTA
1019831-2-C