7
USK STP 23783 - 080302
PRESS NG
• Make sure the locking knob (2) is in the open position (UNLOCK).
• Lift the handle (1). The pressing plate (4) oves to the up position.
• Carefully arrange the gar ent to be pressed onto the ironing
board (5).
• Grasp the handle of the pressing plate(4) and lower it onto the
ironing board (5), capturing the gar ent between the two halves
of the stea press.
• For lightly creased gar ents, si ply lowering the handle and
allowing the pressing plate to rest on the ironing board will be
sufficient. Return to the open position. For very creased gar ents,
continue to grasp the handle and press downward until the
pressing plate is pushed to its lowest position, then open the press.
• If the te perature is set high enough you ay give the fabric a
burst of stea by pressing the burst of stea button (3) to
re ove stubborn wrinkles. Lower the pressing plate until it is about
two inches fro the gar ent. Press the burst of stea button for
about 3-5 seconds. After releasing the burst of stea button you
ay fully lower the pressing plate.
NOTE: Do not press the burst of steam button when the pressing
plate is in its lowest (closed) position.
• After a few seconds, lift the handle and raise the pressing plate
back to the raised position.
US NG THE SPRAY BOTTLE
Lightly spray the gar ent before placing it on the ironing board. This
helps to distribute an even, fine ist over the fabric, preparing it to
be pressed, and re oving all wrinkles.
US NG THE PRESS NG CUSH ON
So e gar ents have been constructed with details, such as darts,
curved sea s and shoulder pads, which are not intended to be
pressed flat. A pressing cushion is supplied with your stea press for
use with these areas.
• Use the cushion whenever pressing areas where no creases are
desired or to shape tailored gar ents.
• Place the area to be pressed onto the ironing board.
