Kambrook Arctic HV KFA624 User manual

Due to continual improvement in design or otherwise, the product you
purchase may differ slightly from the illustration in this book. Issue C12
Kambrook - Australia
Building 2, Port Air Industrial Estate
1A Hale Street
Botany NSW 2019
Australia
Customer Service Line 1300 139 798
Customer Service Fax [phone]
www.kambrook.com.au
Kambrook - New Zealand
Private Bag 94411
Botany, Manukau
Auckland 2163
New Zealand
Customer Service Line/
Spare Parts 0800 273 845
Customer Service Fax [phone]
www.kambrook.co.nz

Instruction Booklet
Arctic HV
46cm Floor Fan
KFA624

Important
Please retain your instruction
book for future use.
In the event that you need some assistance with your
Kambrook appliance, please contact our Customer Service
Department on 1300 139 798 (Australia) or 0800 273 845
(New Zealand). Alternatively, visit us on our website at
www.kambrook.com.au or www.kambrook.co.nz

Contents
Kambrook Recommends p4
Safety First
Your Kambrook Arctic HV P6
46cm Floor Fan
Using Your Kambrook p7
Floor Fan
Care and Maintenance p9

4
Kambrook Recommends Safety First
IMPORTANT: Please retain your
instruction book for future use.
At Kambrook, we believe that safe performance is the first priority in any
consumer product, so that you, our valued customer can confidently
use and trust our products. We ask that any electrical appliance that
you use be operated in a sensible fashion with due care and attention
placed on the following important operating instructions.
Important Safeguards For Your Kambrook
Arctic HV Floor Fan
• Carefully read all instructions before
operating the Kambrook Floor Fan for the
first time and save for future reference.
• Remove and safely discard any
packaging material and promotional
labels before using the fan for the first time.
• To eliminate a choking hazard for
young children, remove and safely
discard the protective cover fitted
to the power plug of this fan.
• Ensure that the surface is level, clean
and free of water and other substances
• Always ensure the fan is properly
assembled before use. Follow the
instructions provided in this book.
• Keep the fan clean. Follow the cleaning
instructions provided in this book.
• Do not leave the fan unattended
when in use.
• Do not place anything, on top of the
fan when assembled, when in use
and when stored.
• This fan is not intended for commercial
or industrial use.
• Avoid touching mobile parts of the fan.
• Never insert fingers, pencils or any other
objects through the guards whenever
the power plug is connected, in
particular while the fan is switched on.
• Do not operate in the presence of
explosives and/or flammable fumes
or liquids.
• Never carry the fan by the cord or yank
to disconnect from an outlet; instead
grasp the cord at the plug and pull
to disconnect. Do not pull the cord
around sharp edges or corners.
• The fan must not be used if the grilles
are not fastened correctly and the
triangular base correctly fitted as per the
instructions provided in this book.
• When unpacking the fan, check to see
you have received all the parts before
discarding the packaging.
• To avoid electrical circuit overload,
it is recommended that no other
appliances are plugged into the same
circuit as your fan, when it is in use.
• Disconnect the power plug before
dismantling, assembling or before
cleaning and when the fan is not
in use.

5
Important Safeguards For All
Electrical Appliances
• Fully unwind the power cord before use.
• Connect only to a 230V or 240V
power outlet.
• Do not let the power cord hang over
the edge of a bench or table, touch
hot surfaces or become knotted.
• To protect against electric shock, do
not immerse the power cord, power
plug or appliance in water or any
other liquid, unless it is recommended
in the cleaning instructions.
• The appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance, by
a person responsible for their safety.
• Children should be supervised to
ensure that they do not play with
the appliance.
• It is recommended to inspect the
appliance regularly. Do not use
the appliance if the power supply
cord, plug, connector or appliance
becomes damaged in anyway. Return
the entire appliance to the nearest
authorised Kambrook Service Centre
for examination and/or repair.
• Any maintenance other than cleaning
should be performed at an authorized
Kambrook Service Centre.
• This appliance is for household use only.
Do not use this appliance for other than
its intended use. Do not use in moving
vehicles or boats. Do not use outdoors.
Misuse may cause injury.
• The installation of a residual current
device (safety switch) is recommended
to provide additional safety protection
when using electrical appliances. It
is advisable that a safety switch with
a rated residual operating current
not exceeding 30mA be installed in
the electrical circuit supplying the
appliance. See your electrician for
professional advice.
• Always turn the appliance to the OFF
position, switch off at the power outlet
and unplug at the power outlet when
the appliance is not in use.
• Before cleaning, always turn the
appliance to the OFF position, switch
off at the power outlet, unplug at
the power outlet and remove the
power cord, if detachable, from the
appliance and allow all parts to cool.
• Do not place this appliance on or near
a heat source, such as hot plate, oven
or heaters.
• Position the appliance at a minimum
distance of 20cm away from walls,
curtains and other heat or steam
sensitive materials and provide
adequate space above and on all
sides for air circulation.

6
Not Shown
• Convenient carry handle
for portability
• Nuts (2) and washers (2) to secure
fan head to triangular base
• Small screw (1) with washers (2)
to fit the triangular base together
HIGH
MED
LOW
OFF
Your Kambrook Arctic HV Floor Fan
1. Fan blade size: 46cm
2. Choice of 3 fan speed settings
3. Removable tilt adjustment knobs
to direct air flow
4. Sturdy triangular base for stability
5. All metal construction including
grille and blades
5

7
Using Your Kambrook Arctic HV Floor Fan
Before First Use
Carefully remove the fan from its
packaging and also remove any
promotional material from the fan.
IMPORTANT: When
unpacking the fan,
check to see you have
received all the items
before discarding
the packaging.
Assembling Your Kambrook
Arctic HV Floor Fan
To Assemble the Triangular Base
1. The Triangular Base comes in
two pieces that first must be
screwed together.
2. Fit the smaller rounded end from
one side of the base into the
larger rounded end of the other
side of the base piece.
3. Once fitted together, align the
two pieces so that you can see
the screw hole clearly
(Fig. 1) .
Use the included small screw with
two washers to assemble the base.
Fit the thinner of the two washers
on to the screw first, followed by
the thicker washer and then, using
a screw driver, tighten into the
screw hole of the triangular base
until tight.
To Assemble the Fan Head
to the Base
4. Carefully fit the attached
threaded screws located on both
sides of the pre-assembled Fan
Head into the holes provided at
each end of the Triangular Base
making sure that the point of the
Triangular Base is at the back of
the fan head (Fig. 2).
5. Fit a washer onto each screw
followed by the nut. Tighten the
nut with you fingers as much as
you are able.
6. Fit a Tilt Adjustment Knob onto
each nut and use the knob
to tighten fully.
Fig. 1
Fig. 2

8
To Operate the Floor Fan
Plug the cord into a 230V or 240V
power point and switch on.
The fan has 3 speeds.To adjust the
flow of air, turn the fan speed dial
located at the back of the fan to the
preferred speed - LOW, MED or HIGH.
To turn Off, turn the fan speed dial
to the OFF position.
NOTE: To avoid an electrical circuit
overload, it is recommended that
no other appliances are plugged
into the same circuit as your fan
when it is in use.
To adjust the flow of air up or down,
slightly loosen the two adjustment
knobs located on either side of the
fan and tilt the fan either upwards or
downwards to suit. Once the fan is in
the desired position, re-tighten the
two knobs to hold in place.
Using Your Kambrook Arctic HV Floor Fan continued

9
Care and Maintenance
Before cleaning, always turn the Floor
Fan to the OFF position, switch off at
the power outlet, then unplug at the
power outlet.
To clean the fan, remove dust that
may have accumulated with a soft
cloth or a vacuum cleaner using the
brush attachment. Wipe the exterior
of the fan with a soft, damp cloth.
Never use an abrasive cleaner.
When not in use, store the fan in
a cool, clean and dry location.
Care and Maintenance

10
Notes

11
Notes