Kambrook KTF816 Series User manual

Suits all KTF816 modelsINSTRUCTION BOOKLET

Important
Please retain your instruction
book for future use.
In the event that you need some assistance with your
Kambrook appliance, please contact our Customer Service
Department on 1300 139 798 (Australia) or 0800 2738 45
(New Zealand). Alternatively, visit us on our website at
www.kambrook.com.au or www.kambrook.co.nz

Contents
Kambrook Recommends p4
Safety First
Your Kambrook Arctic p6
Tower Fan
Using Your Kambrook Arctic p7
Tower Fan
Care, Cleaning and Storage p11

4
Kambrook Recommends Safety First
IMPORTANT: Please retain your
instruction book for future use.
At Kambrook, we believe that safe performance is the first priority in any
consumer product, so that you, our valued customer can confidently
use and trust our products. We ask that any electrical appliance that
you use be operated in a sensible fashion with due care and attention
placed on the following important operating instructions.
Important Safeguards For Your Kambrook
Arctic Remote Controlled Tower Fan
• Carefully read all instructions before
operating the tower fan for the first time
and save for future reference.
• Remove and safely discard any
packaging material and promotional
labels before using the fan for the first
time.
• To eliminate a choking hazard for
young children, remove and safely
discard the protective cover fitted to
the power plug of this fan.
• When unpacking the fan, check to see
you have received all the items listed
in the parts list, before discarding the
packaging.
• Do not place the fan near the edge
of a bench or table during operation.
Ensure that the surface is level, stable,
clean and free of water and other
substances.
• Always ensure the fan is properly
assembled before use. Follow the
instructions provided in this book.
• This fan is intended for household
use only and not for commercial or
industrial use.
• Disconnect the power plug before
assembling, dismantling or before
cleaning and when the fan is not in use.
• Avoid touching moving parts of the fan.
• Never insert fingers, pencils or any
other objects through the grille
guards whenever the power plug is
connected, in particular while the fan is
switched on.
• The fan must not be used if the base is
not fastened correctly, according to
the instructions provided in this book.
• Do not operate in the presence of
explosives and/or flammable fumes or
liquids.
• Never leave the fan unattended when
in use.
• Do not unplug the fan by pulling on the
cord.
• Never carry the fan by the cord or yank
to disconnect from an outlet; instead,
grasp the cord and pull to disconnect.
Do not pull the cord around sharp
edges or corners.
• Always switch off at the power outlet,
and then unplug the fan from the
outlet:
- Before leaving it unattended
- Before attempting to move
the fan
- Before cleaning and maintenance
unless otherwise specified in this
booklet
- Immediately after use.

5
Important Safeguards For All
Electrical Appliances
• To prevent damage to the fan do not
use alkaline cleaning agents when
cleaning, uses a soft cloth and mild
detergent.
• Do not place anything, on top of the
fan when assembled, when in use and
when stored.
• Any maintenance other than cleaning
should be performed at an authorised
Kambrook Service Centre.
• This appliance is for household use only.
Do not use this appliance for anything
other than its intended use. Do not use
in moving vehicles or boats. Do not use
outdoors. Misuse may cause injury.
• The installation of a residual current
device (safety switch) is recommended
to provide additional safety protection
when using electrical appliances. It
is advisable that a safety switch with
a rated residual operating current
not exceeding 30mA be installed in
the electrical circuit supplying the
appliance. See your electrician for
professional advice.
• Always turn the appliance to the
OFF position, switch off at the power
outlet and unplug at the power outlet
when the appliance is not in use.
• Before cleaning, always turn the
appliance to the OFF position, switch
off at the power outlet, unplug at
the power outlet and remove the
power cord, if detachable, from the
appliance and allow all parts to cool.
• Do not place this appliance on or near
a heat source, such as hot plate, oven
or heaters.
• Position the appliance at a minimum
distance of 20cm away from walls,
curtains and other heat or steam
sensitive materials and provide
adequate space above and on all
sides for air circulation.
• Store the unit out of reach of children.
• Keep the fan clean. Follow the cleaning
instructions provided in this book.
• Fully unwind the power cord before
use.
• Connect only to a 230V or 240V power
outlet.
• Do not let the power cord hang over
the edge of a bench or table, touch
hot surfaces or become knotted.
• To protect against electric shock,
do not immerse the power cord,
power plug or appliance in water or
any other liquid or allow moisture to
come in contact with the part, unless
it is recommended in the cleaning
instructions.
• The appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.
• Children should be supervised to
ensure that they do not play with the
appliance.
• It is recommended to regularly inspect
the appliance. To avoid a hazard, do
not use the appliance if power cord,
power plug or appliance becomes
damaged in any way. Return the
entire appliance to the nearest
authorized Kambrook service centre
for examination and / or repair.

6
Your Kambrook Arctic Tower Fan
1. 77cm tower fan
2. Oscillating body to circulate air
throughout the room
3. Control panel featuring;
• FAN Off/Speed button
(Includes 3 speed settings;
low, medium and high)
• MODE button
(includes 2 cooling modes;
nature and reduction mode)
• TIMER button (Max. 8 hours)
• OSC button to set oscillation
4. Base stand (two fitted pieces)
5. Remote Control with soft touch
buttons
Not Shown
• Convenient carry handle for
easy portability
• 5 base stand fastening screws
5

7
Before First Use
Remove your tower fan from its carton
and associated protective wrapping.
Ensure that all parts listed are
accounted for before discarding
the packaging.
Unwind the cord to its full length and
remove any promotional labels and
or packaging materials from the
tower fan.
Place the tower fan on a firm, level
surface in a stable position. Visually
inspect the air inlet and outlets to
ensure no foreign materials are
blocking these areas.
WARNING: When
unpacking the fan, check
to see you have all the
items listed in the parts
list, before discarding the
packaging.
NOTE: Assembly of the fan requires
a Phillips head screwdriver
(not supplied).
Assembling Your Arctic
Tower Fan
To assemble the base stand:
1. The tower fan base stand comes
in two separate pieces; piece (a)
and piece (b) that must be fixed
together before being fitted to the
fan body (see Fig.1).
Fig. 1
2. To assemble the base stand, first
carefully place the tower fan body
on its side. Holding base stand
piece (a), align the four locating
posts on piece (b) with the
corresponding slots found in base
stand piece (a) and firmly push
downwards until the base stand is
securely fixed together (see Fig. 2).
Fig. 2
Using Your Kambrook Arctic Tower Fan
(b)(a)
(b)(a)

8
3. Thread the power cord through
the circle cord opening, once
the power cord is pulled through,
align the base stand with the
tower fan body being sure that
the power cord is situated to sit
on top of the groove found on
base stand piece (a). Press the
power cord into the cord clip to
secure it into place (See Fig. 3).
Fig. 3
4. Fit the base stand on to the
stem located on the base of the
tower fan, using the 5 fastening
screws supplied, screw the base
stand to the tower fan body and
fasten until tightened (see Fig. 4).
Fig. 4
5. Return the tower fan to its upright
position. It is now ready for use.
WARNING: Do not operate
the tower fan without the
base stand fitted.
WARNING: Never insert
fingers, pencils or any
other objects through
the guards whenever the
power plug is connected,
in particular while the fan
is switched on.
NOTE: Ensure the power cord is not
caught or trapped between the
tower fan base and the floor flat
surface at all times.
Using Your Kambrook Arctic Tower Fan continued
(b)
(a)
Cord
Grooves
Cord
Clip

9
Operating Your Tower Fan
To operate the tower fan, plug the
power cord into a 230V or 240V
electrical outlet and switch on.
Be sure that the plug fits tightly as a
loose fit will cause overheating
and damage the plug.
NOTE: To avoid an electrical circuit
overload, it is recommended that
no other appliances are plugged
into the same circuit as your fan,
when it is in use.
NOTE:To avoid infrared interference
that may trigger the operation
of the cooling fan, ensure the
fan is positioned away from
other infrared remote controlled
appliances.
Fan Speed Settings
The tower fan has three fan speed
settings; (LOW), (MED) and (HIGH).
To start the tower fan, turn the
tower fan on by pressing the ‘FAN’
button once; the unit will be in
NORMAL fan mode, at LOW speed
setting.
Pressing the ‘FAN’ button a second
time will set the tower fan into
MEDIUM speed setting. Pressing the
‘FAN’ button a third time will set the
tower fan into HIGH speed setting.
To turn the tower fan OFF, press the
‘FAN’ button continuously until none
of the indicator lights are illuminated
on the control panel display and the
fan is no longer running. Then turn off
at the power outlet and remove the
plug from the power outlet.
Setting the Nature and
Reduction Mode
The tower fan has a NATURE and
REDUCTION setting.
Both the NATURE and REDUCTION
modes can be used on any fan
speed. The LED screen will indicate
what mode the fan has been set in.
Nature Mode
The NATURE mode simulates the
natural rise and fall of the wind over
time.
Once a fan speed setting is selected,
press the 'MODE' button once to
activate the NATURE setting. The fan
will now alternate between the
pre-selected setting, all lower settings
and OFF.
To switch the NATURE mode off, press
the 'MODE' button twice, until the
indicator light disappears.
Reduction mode
The REDUCTION mode allows you to
decrease the fan speed over time.
Once a fan speed setting is selected,
press the 'MODE' button twice to
activate the REDUCTION setting. After
30 minutes, the selected setting will
drop to the next lowest setting.
For example if the fan speed is set at
MED, after 30 mins it will drop down
to LOW, and remain on LOW until the
unit is turned off.
To switch the REDUCTION mode off,
press the MODE button once. The fan
will now be in normal operation
Setting the Oscillation
This function will work in any mode.
Pressing the ‘OSC’ button once
will allow the tower fan to oscillate
from side to side. To stop the unit
oscillating, press the ‘OSC’ button
once more.

10
Setting the Timer
The timer function works in all
operating modes and switches the
unit into standby mode after the
selected number of hours have
elapsed.
The Tower Fan incorporates an eight
hour, count down timer, which allows
the fan to switch itself off after 1, 2, 4
or 8 hours.
Press the TIMER button once to
activate the timer setting. The timer
will then be set to turn off the fan
in 1 hour and the 1h indicator will
illuminate on the control panel
display.
Press the TIMER button again, to
set the fan to switch itself off after
2 hours, and the 2h indicator will
illuminate on the control panel
display.
Similarly, pressing the TIMER button
a 3rd or 4th time will set the fan to
switch itself off after 4 or 8 hours, and
the relevant setting will illuminate on
the control panel display.
To cancel the TIMER press the timer
button continuously until none of the
timer indicator lights are illuminated
on the control panel display
(See fig.5).
Using the Remote Control
The remote control buttons operate
in the same way as those on the fan
control panel.
Your remote control takes 2 x AAA
Batteries.
Using Your Kambrook ArcticTower Fan continued
Fig. 5

11
1. Ensure that the tower fan is
switched OFF and disconnected
from the power outlet before
cleaning.
2. Use a clean, dry cloth to clean
the external surfaces of the tower
fan. If the tower fan has collected
dirt inside the unit, have the unit
cleaned by a qualified service
agent. Do not operate the tower
fan in this condition.
3. Do not attempt to open the case
of the tower fan at any time as
there are no customer serviceable
parts inside.
4. When not in use, remove the base
stand and screw connection ring
to the stem on the base. Store the
tower fan (preferably in its original
box) in a cool, clean and dry
location.
Care, Cleaning and Storage

Due to continual improvement in design or otherwise, the product you
purchase may differ slightly from the illustration in this book. Issue B17
Kambrook - New Zealand
Private Bag 94411
Botany, Manukau
Auckland 2163
New Zealand
Customer Service Line/
Spare Parts 0800 273 845
Customer Service Fax [phone]
www.kambrook.co.nz
Kambrook - Australia
Ground Floor, Suite 2, 170-180 Bourke Rd
Alexandria NSW 2015, Australia
Locked Bag 2000
Botany NSW 1455
Customer Service Line 1300 139 798
Customer Service Fax [phone]
www.kambrook.com.au