Kanaad MOTO CHARGER MC-1 User manual
MC-1 | MC-2 | MC-4
www.kanaad.com 1
OPERATING AND INSTRUCTION MANUAL
KANAAD ELECTROMATION SOLUTIONS PVT.LTD.
www.kanaad.com 2
KNOW YOUR MACHINE
Weight :- 3Kg(approx.)
MODEL - MC2
Size (mm) :- 130(h)x190(w)x120(d)
Weight :- 5.8Kg(approx.)
MODEL - MC5
Size (mm) :- 130(h)x370(w)x120(d)
MODEL - MC1
Size (mm) :- 130(h)x95(w)x120(d)
Weight :- 1.5Kg(approx.)
12 position Rotary Switch
For Selection between MF-VRLA and FLOODED battery
OUTPUT FAULT Indication
ON means REVERSE Polarity
Slow Blink means OPEN Terminals
Fast Blink means SHORT Terminals
ON means FUSE Blown / Not OK
OFF means FUSE OK
FUSE BLOWN LED Indication
Battery Connection Cable
1 meter Length with +VE and -VE charging clips
20% to 100% Battery charging indication
Charging Indication Bargraph
MF-VRLA
Battery Range (AH):- 3/4/5/7/9/14
Charging cutoff Voltage:- 14.5 V
Charging Current (A):- 0.3/0.4/0.5/0.7/0.9/1.0
ACID/FLOODED
Battery Range (AH):- 2.5/5/7/9/14
Charging Current (A):-0.25/0.5/0.7/0.9/1.0
Charging cutoff voltage:- 16 V
www.kanaad.com 3
HOW TO CHARGE BATTERY
Remove battery from charger.
Plug mains input(230Vac)and start charger.
Connect battery to charger with proper polarity.
Set battery AH/Current using selection knob.
Wait until charger shows 100% battery charge.
If every thing goes right, Charging indication will
be shown on BARGRAPH.
Manufactured By:
Kanaad Electromation Solutions Pvt.Ltd.
Joglekar Building, Opp. Hotel Lotus, Old Station Road,
Azad Chowk, Sangli, (Maharashtra,India) - 416416.
Warning:
Do not try repairs without any technical
help from company service. This may
lead to damage to person attending
repairs / operator.
Call company service for repairs and
maintenance.
For Better Results:
Make battery terminals clean and dry for
proper contact.
Confirm correct and tight connections.
Select proper charging current
www.kanaad.com 4
PROBLEM CAUSE FINDINGS/
Battery not charging
Charger does not start
Check all input connections and supply.
Check fuse blown indication.
Wrong current/battery selection.
Battery connection reversed.
Check all connections from battery to machine.
Charger showing Output Fault
indication Battery open/short.
Battery connection not proper.
TROUBLESHOOTING
§Input Voltage:- 230Vac(+/-15%) 50Hz
§Charging Profile:- Constant Current Constant Voltage
§Input Current:- 0.8A max
§Operating Temperature:- 0 to 85 Deg
Speci!ications:-
This manual suits for next models
2
