Karlik ICUSB-6 User manual

USER MANUAL - ICUSB-6
DOUBLE USB CHARGER
The ICUSB-6 charger is intended to charge devices like smartphones, MP3 players and other electronic
equipment. Before connecting the device, check compliance of the charger with charging
parameters of the given device.
Specification of ICUSB-6 double USB charger
1 I 2
Warranty period will be extended for the duration of the repair.
Warranty conditions
Warranty is granted for a period of 12 months of the date of purchase. The defective DCUSB-6 charger
along with the proof of purchase should be sent to the manufacturer or to the seller. Warranty does not
include mechanical damages, defects resulting from unauthorised repairs and improper use of the
product.
Number of USB ports (type A)
2
Nominal input voltage
100-240V AC; 50/60Hz
Nominal input current
0,25 A
Nominal output voltage
5 V DC
Nominal output current
3.1 A ( )total value for the whole mechanism
Ingress protection degree
IP 20
Dane techniczne
54,00
54,00
46,00

ASSEMBLY INSTRUCTIONS
2 I 2
NOTE!
The installation must be done by a person with sufficient qualifications, with power supply
disconnected, and must comply with national safety standards.
The connection to the installation should be done as shown in Figure 2. With improper connection, the
charger may be damaged or may work incorrectly.
USB charger mechanism with idle power supply consumes less than about 0,2W.
4. Remove the spacer frame (5) from the assembly block (7). Pull away the block tabs or pull the frame
tightly to do this.
9. Screw down the intermediary unit to the assembly block.
7. Connect the wires of the installation to the USB charger module as shown in Figure 2.
8. Insert the USB charger modules in the intermediary unit.
2. Remove the screw (2).
6. Insert the spacer frame in the external frame (6) and snap the entire set on the tabs protruding from
the assembly block.
3. Dismantle the USB charger modules (4).
10. Attach the label and glass pane.
1. Remove the glass panel (1) with the label applying a knife or a flat screwdriver in the recess (3).
5. Set the assembly block in the box (9) with tabs or screws at the box (8).
Fig. 1
Fig. 2
98
7
6
5
4
2
3
1