
Note:
lFor non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse
cover is lost then the plug must
not be used until a replacement
can be obtained. The correct fuse
cover is identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
lIf a non-rewireable plug is cut
off it must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
l This appliance conforms to EC
Regulation 1935/2004 on materials
and articles intended to come into
contact with food.
before using for the first time
1 Wrap any excess cord around the
bracket f on the underside of the
powerbase.
2 Fill to ‘MAX’, boil, then pour the
water away. Repeat 3 times.
key
a lid
b water level gauge
c on/off switch
d power on light
e 360° powerbase
f cord wrap
g filter
to use your kettle
1 Fill the kettle through either the spout
or by removing the lid. The water
level must be between ‘MAX’ and
1 cup (250mls).
lIf you live in a hard water area we
recommend that you use filtered
water in order to maintain the
appearance and efficiency of your
kettle.
lBe economical: do not boil more
water than you need.
lTo improve the quality of your drinks
always use fresh water.
lEmpty the kettle after each use.
lRinse out with fresh water if the
kettle has not been used for more
than 2 days.
2 Check the lid is fitted correctly.
3 Plug in and switch on. The power on
light dwill come on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a few
seconds - the on/off switch needs
time to reset.
Note - To interrupt the boiling
ensure that the switch is
in the off position before
removing from the powerbase.
lIf you experience problems
with your kettle switching
on and off during use or
switching off before boiling,
check that the flat element
is free from scale - see
“descaling”.
lYour kettle is fitted with a filter to
hold back limescale particles.
lIf you find drops of water under
your kettle, do not worry - it is just
condensation.
boil-dry protection
lIf you switch on with too little water,
your kettle will cut out automatically.
Switch off, remove from the
powerbase and let it cool down
before re-filling. When it has cooled
down, the switch will reset itself.
care and cleaning
lBefore cleaning, unplug your kettle
and let it cool down.
the outside and powerbase
lWipe with a damp cloth, then
dry. Do not use abrasives - they
will scratch the metal and plastic
surfaces.
the inside
lWipe with bicarbonate of soda on a
damp cloth. Rinse thoroughly.
lEven though your kettle comes with
a filter, you still need to clean the
inside (and the filter) regularly.
the filter
1 Remove the lid.
2 Lift the filter out away from the spout
area 1.
4