Kettler 0393113-0200 User manual

Assembly Instructions
Elba
Day Bed
0393113-0200
Feb 2021
ASSEMBLY
TIME
PERSONS
REQUIRED
IMPORTANT
PLEASE KEEP THIS BOOKLET FOR FUTURE REFERENCE.
THIS IS IMPORTANT INFORMATION REGARDING THE USE AND
CARE OF YOUR HALOGEN HEATER.

Parts List
Do not discard any of the packaging until you have checked
that you have all the parts and the pack of fixings.
x2
x2
x18
x1
x2x2
x10
x1
x2
x1
x32
x32
x2
x2
x1
x4
x1
Long Frame
A
Upper Tube
E
Bolt M6x20
I
Middle Leg
M
Short Frame
B
Top Frame
F
Bolt M6x55
J
Roof/canopy
N
Leg-L Leg-R
D-L
Bolt M6x35
H
Allen Key
L
Lower Tube
P
Bed Frame
C
Washer
G
Bolt Cap
K
Cushion
O
D-R

Assembly
Helpful advice before you begin:
1. We suggest you spend a short time reading through this leaflet and then follow the simple
step by step instructions.
2. Do not discard any of the packaging until you have checked that you have all the parts and
the pack of fittings.
3. Assemble this product on a soft surface.
4. To ensure an easier assembly, we strongly advise that all fittings are only finger tightened
during initial assembly. Only upon completion of the assembly should all fixing points
be fully tightened.
5. Keep fittings out of children’s reach.
6. Do not use any other tools other than those recommended to build this product.
7. Please do not use substitute parts. Use only additional or replacement parts supplied by Kettler.
8. In the unlikely event that this product has missing or damaged parts, please visit our website
www.kettler.co.uk

Assembly
1
2
KLHG
M
B
C
KLIG
B
A
K
L
I
G
A
D-L
D-R
D-R
D-L

Assembly
E
L K
3
44
F
G J

Finished
5
6
N
N
P
P
Assembly
O
OInsert Slot
Insert Slot
Between Tubes
Attention
Please be aware that painted/varnished surfaces can be damaged by sunscreens and
oil based products. If the surface of your Kettler leisure furniture comes into contact
with sunscreens, the surface is to be cleaned without delay as described above.
Only in this way can lasting discolouration of the surface by the ingredients of the
sunscreen be prevented.

Maintenance and Care Instructions
• This product may only be used for its intended
purpose for residential premises. Any other
uses may affect the warranty.
• Kettler furniture is designed to be left
outdoors all year round (excluding cushions).
Cushions should be stored in a dry ambient
temperature when not in use. Failure to
comply with the outlined care instructions for
the cushions will result in the warranty being
invalidated.
• The canopy should be removed in windy
conditions or when not in use for a period of
time (e.g 3 days+).
• Kettler cushions are not suitable for dry
cleaning and are not machine washable.
Sponge clean only. We recommend the use of
the Kettler fabric care kit to clean and protect
your cushions. This is available to purchase
form the Kettler website.
• We recommend to maintain and lengthen
the life of this product you follow the below
regime:
On wood areas:
1. Use our Hardwood cleaner.
First moisten the wood with water.
Apply the HARDWOOD CLEANER with a soft
cloth or sponge. Allow to soak for 3 minutes.
Brush the furniture clean with a scrubbing pad
in the direction of the grain.
Rinse furniture well with water.
We recommended that you treat your teak
furniture with Hardwood cleaner once a year
at the beginning of April.
2. Use Instant Grey Protector for Elba
Apply a thin layer of Instant Grey Protector with
a soft cloth.
Allow to dry for 1 hour and then the wood has
turned driftwood-grey. (If you wish to have a
more intense grey colour, apply a second thin
layer).
We recommended that you treat your teak
furniture with Instant Grey Protector once a
year at the beginning of April.
3. Hardwood Shield
On grey teak: apply carefully by dabbing
(rubbing damages the grey patina).
Make sure the Hardwood is 100% dry and free
of dust.
Apply a thin layer of HARDWOOD SHIELD with
a soft cloth. Allow to dry for one hour and
then apply a second thin coat of HARDWOOD
SHIELD.
Let the wood dry for 48 hours before exposure
to moisture and rain.
We recommended that you treat your teak
furniture with HARDWOOD SHIELD twice a
year April & October.
On aluminium parts:
We recommend the Kettler Multi-surface
cleaner when necessary.
The Kettler after-care range is available to
purchase from the Kettler website.
• Tree sap and bird droppings should be
cleaned off immediately.
• Moving parts such as locking mechanisms,
catches and joints need to be lubricated
where necessary.
• Kettler furniture can be covered – we
recommend that you use Kettler tailored
covers (where available) or universal
breathable covers.
• This product is 100% recyclable. At the
end of the products life, please dispose of
responsibly.
• Colours may vary slightly

• This product may only be used for its intended purpose as furniture for residential properties.
• Check all components regularly for correct function, damage and loose connections especially
at the start of the season and at 1-2 month intervals dependent on use.
• Damaged components may endanger your safety or shorten the life of the product. Replace all
damaged parts immediately. Use only spare parts manufactured by Kettler. Should you wish to
purchase spare parts, they can be ordered directly from: www.kettler.co.uk/shop
• Kettler will not be responsible for damaged caused by improper use.
For Your Safety
Attention
• Whilst assembling this product keep out of the reach of children. (Choking hazard –
contains small parts)
• Ensure that your working area is free of possible sources of danger, for example don’t
leave any tools lying around.
• Always dispose of packaging material in such a way that it may not cause any danger.
There is always a risk of suffocation if children play with plastic bags!
• We reserve the right to make changes for technical reasons.
www.kettler.co.uk
Warranty For Home Use
This product is covered by a 3 year
warranty against manufacturing faults.
This warranty applies to domestic use
only. It does not cover commercial use,
mis-use or accidental damage.
To validate your warranty, register
at www.kettler.co.uk and quote
the product code from the front of
this booklet.