KEYA TRONIC TOUCH PANEL User manual

TRONIC TOUCH PANEL

TRONIC TOUCH PANEL
2 www.keya.cat

TRONIC TOUCH PANEL
Multiuser mode
Open and close by 4-digit code. The code is erased every time the lock is opened, being available for
a new use.
Open and close by 4-digit code. The code is set for 1 user only.
Single User mode
To close:
To open:
To open:
To close:
The latch closes automatically after 2 seconds.
Note: the lock is provided with a metal latch holder
that allows to close the door just by pushing it.
(slam door system)
1
2
www.keya.cat 3

INSPECTION MODE
Introduce Master code and press Enter
Close the lock by pressing Enter before 30s.
The User code is not deleted.
-30s
INSPECTION
MODE
+30s
USER
ERASED
TRONIC TOUCH PANEL
Change the User code
Press Enter during 3 seconds.
Introduce Current code and press Enter.
Introduce New code and press Enter
Open using Master code: Inspection mode / Delete User code
CURRENT code NEW code
press during 3 seconds
MASTER code
To open:
3
4
4 www.keya.cat
DELETE USER CODE
Introduce Master code and press Enter.
After 30s the lock remains opened.
The user code has been deleted and a new User
code will be required to close the lock again.

TRONIC TOUCH PANEL
Change the Master Code
Press Enter during 3 seconds.
Introduce Current master code and press Enter.
Introduce New master code and press Enter
Open using electronic Master key: Inspection mode / Delete User code
INSPECTION MODE
Connect the Master key (BLUE)
Lock opens
Remove electronic key
Press enter before 30 seconds
User code is not deleted.
NEW master code
CURRENT master code
press during 3 seconds
5
6
www.keya.cat 5
DELETE USER CODE
Connect the Master key (BLUE).
Lock opens
Remove electronic key
After 30 seconds the User code will be deleted .
A new User code will be required to close the lock
again.

TRONIC TOUCH PANEL
Programmable settings ( management software and cable required )
AUTOMATIC OPENING TIME:
The lock will open automatically at the programmed time:
- hh : mm
- Mon, Tue, Wed, Thu, Fri, Sat, Sun
- Working days
- Two options: Leave door open
Close door again
ACOUSTIC SIGNAL VOLUME:
- High/Low/Off
LED INDICATION OF CLOSED POSITION:
- On/Off blinking red LED when locker is closed
CODES:
- User / Master
LAST EVENTS
BATTERY LEVEL
Nº OF OPERATIONS
Settings key
7
Load settings from the computer to the settings key.
Connect settings key to the lock.
The settings will be loaded into the lock.
6 www.keya.cat

Technical specifications
Salt spray test > 96h
Working temperature -5°C < > +70°C
Latch force > 45Kgf
UV Rays > 10000h
Vibration 10 - 200 Hz 2g
Life test > 200000 cycles
Electrostatic discharge 8000 V
Battery life > 70000 cycles
Measurements
Torx T20
4 x AA(LR6)
Batteries replacement
IMPORTANT: The batteries replacement
must be done in less than 5 minutes.
The BATPACK must remain
connected during the release of the
batteries
1
2
TRONIC TOUCH PANEL
www.keya.cat 7

ENG - Rev1775008