Kinderkraft XPEDITION 2 i-Size User manual

MODEL: I-GUARD ECE.R129.03 ver. 1.2
XPEDITION 2 i-Size
USER GUIDE
MODEL: XPEDITION 2 i-Size ECE R129.03 v.1.0

2
CAUTION! The product graphics are for illustrative purposes only!
Please carefully read the user manual before using the child car seat for
the first time. Ensuring the safety of the child is your responsibility, and
not reading this manual may have an impact on their safety.
1.0 Usage
The car seat has been designed, tested, and approved for use in accordance
with the requirements of regulation No. 129 of the UNECE/ONU regarding
the approval of child restraint systems (UN/ECE R129/03).
Do not place the car seat facing forward until the child reaches 15 months
and has a height of 76 cm.
The car seat can be installed in the car in locations indicated by the
manufacturer in the vehicle's user manual. Reading the vehicle
manufacturer's operating manual is required.
To ensure proper installation, please refer to the table on the next page.

3
Height of the child
Car seat orientation
Car seat attachment
40-105 cm
ISOFIX + Top Tether + inner harness straps
76-105 cm
ISOFIX + Top Tether + inner harness straps
100 –150 cm
ISOFIX + 3-point safety harness
3- point safety harness

4
2.0 Safety instructions
Please take a few minutes to read this user manual to ensure appropriate
child's safety.
•DO NOT install the car seat on seats facing backward or
sideways to the direction of travel
• DO NOT place the child’s car seat on seats equipped with
an active front airbag.
• A child seat can only be fitted in the middle seat if it has 3-
point safety belts and ISOFIX connectors and a Top Tether
attachment.
• If the car seat is installed in the front seat, the front airbag
must be deactivated.
•It is recommended to install the car seat only on the back
seats of the car

5
A: Head part of the insole
B: Insole sides
C: Inner side of the insole
D: Inner straps
E: Inner strap’s buckle
3.0 Securing the child
3.1 Inserting the insole
The additional insole should be used until the child reaches 76 cm.
1.Connect the headrest section of the insole and its sides of to the inner
section by using the fasteners
2.Unfasten the safety harness
3.Spread the belts to the sides of the seat
4.Insert the insole