KingShield Corvus Series User manual

Installation Instructions for Corvus Rang
IP65 LED Non-corrosiv Luminair s
Operating C nditi ns:
These Luminaires are suitable for a temperature ran e of to -20°C to 40°C.
INSTALLATION & OPERATION
Do not drill th body for mounting purpos s.
Drillin the body will invalidate the warranty, ONLY use the fixin methods provided. Please ensure that the rated
volta e and frequency of the luminaire is compatible with the supply.
Disc nnect the p wer supply bef re installati n.
D scription L ngth
(mm)
Clips
Qty
40WSingl 1565 12
2 x 40WTwin 1565 12
48WSingl 1835 14
2 x 48WTwin 1835 14
Mains Cable
Lock Nut
Dia:1
2. Assemble the clips at the desi nated position.
See Dia:2.
Dia:2
1. Fix the cable land into the pre drilled hole in
the base. See Dia:1.
3. Fix the two ends of the cover and base first.
See Dia: 3.
4. The fixin centre points for this luminaire are
located on the mountin bracket. Choose a
suitable location and fix the mountin brackets,
usin the wall plu s, screws and washers
provided.
Dia:4
Fixin Centres
Dia:3
Model Numbers: ACPLED15, ACPLED25, ACPLED16 & ACPLED26
Imp rtant Safety Instructi ns
• Please read these instructions carefully before installation and keep safe for future reference.
• This unit should be installed by a competent person and in accordance with the current IET Wirin
Re ulations.
If in doubt, consult a qualified electrician.
• Always turn off the supply before commencin work.
• This appliance must be earthed.
• All luminaires are complete with electronic ballast.
S pecificati n:

GUARANTEE
Your Kin Shield IP65 LED Bulkhead is uaranteed for 3 years from the date of purchase.
This is in addition to your statutory ri hts.
Issue no: 704186
TECHNICAL INFORMATION
Rated volta e: 100-277V AC 50Hz
IP Ratin : IP65
Classification: Class 1
Construction: Polycarbonate body &
Diffuser
Temperature Ran e: -20°C to 40°C
Ballast Type: Electronic
PLEASE KEEP THESE
INSTRUCTIONS SAFE
FOR FUTURE REFERENCE
MAINTENANCE
Re ular cleanin of the luminaire, especially diffusers are recommended to ensure maximum efficiency.
When cleanin use a soft cotton cloth. Do not use chemical solvents.
If suspended the supplied suspension clips must be used with a suitable cable suspension system, capable of
bearin the wei ht of the luminaire. The luminaire can also be wall mounted.
Note: The bracket position can be adjusted to give a minimum and maximum fixing centre measurement.
Dia:5
6. Fit the LED tray into the base unit. See Dia:6.7. Put on the diffuser and fix it with the clips. All
clips should be used. See Dia:7
Dia:6
Dia:7
N te: These diagrams are f r illustrati n
nly, and may vary slightly fr m
actual pr duct.
WEST ROAD . HARLOW
ESSEX . CM20 2BG . UK
sales@ reenbrook.co.uk
www.gr nbrook.co.uk
Clip in
90°
90°
5. Insert the installation cable, throu h the land. See Dia:5 Connect the cable to the terminal block. Pay
attention to the correct polarity.