KingSlim D2 User manual

USER MANUAL
V1.0
KingSlim D2 Dash Cam

01 - 16
CONTENTS
17 - 32
日本語

English
WHAT'S IN THE BOX
D2 Dash Cam * 1 Waterproof
Rear Camera * 1
Car Charger with
Power Cable * 1
7m Rear Camera
Extension Cable * 1 Bracket * 1 3M Adhesive * 4
Screws * 2 Car Crowbar * 1 Cable Clips * 6 Quick Start Guide * 1
Quick Start Guide
KingSlimD2 Dash Cam
V1.0
CAMERA OVERVIEW
Mini Usb Power Port
Bracket Slot
Rear Camera IN
Slot for MicroSD Card
OK Button
Lens
Reset
Microphone
Charging Indicator
Working Indicator
Up Button
Menu Button
Down Button
Screen
Power Button
01 02

Note:
1. Power Button:
Function 1: Press to wake up/turn off the screen.
Function 2: Long press to turn on/off camera.
2. Down Button: Press to turn on/off audio recording.
3. Up Button:
Function 1: Press to take screenshots when it is recording.
Function 2: Long press to switch display modes.
4. Menu Button:
Function 1: Press to enter the setup menu mode.
Function 2: Long press to enter the playback menu mode.
5. OK Button: Press to start or stop recording, long press to start emergency
recording.
6. Reset: Restore factory settings.
7. Mini USB Power Port: Supply power for the machine and charge the internal
battery.
1080P
G
P
A B C D E F G 3 1
2020-07-06 13:33:16
00:01:26
INSTALLATION
1. Insert the microSD card.
Warm Tips: A Class 10 or above microSD card is highly recommended for D2 dash
cam (microSD card is not included). Please format your card in the camera
before using this dash cam.
microSD
2. Insert the bracket into the bracket slot.
03 04
1080P
G
P
A B C D E F G 3 1
2020-07-06 13:33:16
00:01:26

3. Install the D2 dash cam on the windshield.
Firstly, clean the windshield with a dry cloth. Secondly, take off the film of the
suction cup and press the suction cup onto the windshield to make sure there is
no air inside the suction cup, and then rotate to secure the bracket.
Cable clip
4. Adjust the view angle of the dash cam to ensure a good view.
5. Connect the USB Power Cable into the USB power port of D2 Dash Cam,
then plug the Car Charger in the cigarette lighter in your car.
6. Connect the Rear Camera with the Extension Cable into D2 Dash Cam to
check whether the Rear Camera works well.
7. Install the Rear Camera.
Position 1: Install the Rear Camera on the rear windshield. The installation is easier.
Position 2: Install the Rear Camera near the license plate. Position 2 is highly
recommended. The rear image is crisp and clear for both rear viewing
and reversing guide.
To use the reversing guide function, please install the rear camera in position 2,
then connect the red trigger wire of the Rear Camera Extension Cable to the
positive lead of the vehicle reversing lamp.
Reversing Lamp Reversing Lamp Positive Lead
Rear
Rear Camera
05 06

Note:
① Pay attention to the connector position when connect the Rear Camera with
the Extension Cable, please refer to the below details.
② Please clean the position to ensure the adhesive quality before installing the
Rear Camera.
③ Please clean the rear windshield regularly to ensure the image quality if you
choose the position 1.
④ If you choose the position 2, you can install the rear camera with the included
adhesive stickers or screws.
8. Use the crowbar to hide the cables.
FORMATTING THE MICROSD CARD
Please format your microSD card in the camera before using this dash cam.
①Press “ (menu button)” to enter the Settings page;
②Press “ (down button)” to select “Format”, then press the “ ” button;
RECORDING
1. Press “ (Power button) to turn on the device; or connect a car charger and
start the car engine, the device will start automatically.
2. Every time you exit from the setting menu or playback menu, the device will be
in the automatic recording mode. If you want to stop it, please press “ ”.
SpeakerKey Voice Language Date/Time
Version
Boot Sound
Default
Format
Format
③ Select “Confirm” then press the “ ” button.
Notice
Format SD at once?
Cancel Confirm
Fast format
1080P
G
P
A B C D E F G 3 1
2020-07-06 13:33:16
00:01:26
ICON INTRODUCTION
345 6 7
17
18
98
1011
12
13
14
15
1
2
The main interface
07 08

Recording indicator
Video resolution
Date/Time
Video time
Rear cam status
Microphone indicator
Power status
Video lock
Settings
Video recording
Audio recording
Emergency recording
License Plate
Parking guard
G-Sensor
Front cam recording interface
Rear cam recording interface
Note:
The emergency recording status bar appears on the screen only when it is in the
emergency recording mode.
SETUP MENU
Press “ (menu button)” to enter dash camera setting menu.
Press “ ” or “ ” to select functions. Press “ ” to confirm your selection.
The device stops recording when setting up the dash cam.
Resolution Loop Record
Frequency USB Mode Mirror
Image
License Screen Saver Video
Encode
Record
Audio
G-Sensor Parking
Guard
Back
Back
Select “Back” and press “ ” to return to the main interface.
Resolution
Select “Resolution” and press “ ” to select the recording resolution of
“2K+1080P” or “1080P+1080P”.
Loop Record
Select “Loop Record” and press “ ”. Press “ ” or “ ” to select the duration
of the individual recorded video files, and press “ ” to save and exit. The oldest
file will be automatically overwritten when the microSD card is full.
Options: 1Min, 3Mins and 5Mins
Default Setting: 3Mins
Record Audio
Select “Record Audio” and press “ ”. Press “ ” to turn on or off the microphone,
and press “ ” to exit.
Options: ON and OFF
Default Setting: ON
G-Sensor
Select “G-Sensor” and press “ ”. Press “ ” or “ ” to turn off or adjust the
sensitivity of the built-in G-sensor, and press “ ” to save and exit. When the
G-Sensor is turned on, if an impact or sudden braking is detected, it will
automatically start recording and save footage to either the “front emr” folder
or “back emr” folder. The higher the G-sensor’s sensitivity level, the easier to
trigger the emergency recording.
Options: OFF, Low, Middle, and High
Default Setting: LOW
Parking Guard
Select “Parking Guard” and press “ ”. Press “ ” or “ ” to turn off or adjust
the sensitivity of the parking mode, and press “ ” to save and exit. The higher
level you select, the more likely the dash cam will activate the 20s video recording.
If the parking mode is turned off, the device will not be turned on.
Options: OFF, Low, Middle, and High
Default Setting: OFF
1
2
3
4
5
6
7
8
9
10
11
12
13
15
16
17
18
09 10

License
Select “License” and press “ ”. Press “ ” or “ ” to choose your license plate
number, and press “ ” to confirm. After finishing, choose Confirm and press “ ”.
Screen Saver
Select “Screen Saver” and press “ ”. Press “ ” or “ ” to change screen saver
time, press “ ” to save and exit.
Options: OFF, 1Min, and 3Mins
Default Setting: 1Min
Video Encode
Select “Video Encode” and press “ ”. Press “ ” to switch video encode modes.
Note: H.265 can minimize the footage size, you can store more video files in the
emory card. H.264 has better compatibility.
Options: H.264 and H.265
Default Setting: H.265
Frequency
Select “Frequency” and press “ ”. Press “ ” to switch frequency, “60Hz” or
“50Hz”. The default setting is “60Hz”. To avoid interference, please choose the
right frequency based on your local AC parameters.
USB Mode
Select “USB Mode” and press “ ”. Press “ ” or “ ” to choose “STORAGE/UVC
/CHARGE”, and press “ ” to save and exit.
Storage: The device could be connected to a computer via a USB cable to copy
and transfer files to/from a computer.
UVC: USB video class. The device could be connected to a computer via a USB
cable as a computer camera.
CHARGE: Charging the dash cam.
Mirror Image
Select “Mirror Image” and press “ ”. Press “ ” to turn on or off mirror image.
This function is for the rear camera. The rear camera video is flipped horizontally
in the main recording interface, like looking in the mirror.
Options: ON and OFF
Default Setting: ON
Key Voice
Select “Key Voice” and press “ ”. Press “ ” to turn on or off the key sound.
Options: ON and OFF
Default Setting: ON
Speaker
Select “Speaker” and press “ ”. Press “ ” or “ ” to adjust speaker volume.
Options: Mute, Low, Middle, and High
Default Setting: High
Boot Sound
Select “Boot Sound” and press “ ”. Press “ ” to turn on or off boot sound.
Options: ON and OFF
Default Setting: ON
Language
Select “Language” and press “ ”. Press “ ” or “ ” to change a language,
and press “ ” to save and exit.
Options: English, French, German, Italian, Japanese, Spanish, etc.
Default Setting: English
Date/Time
Select “Date/Time” and press “ ”. Press “ ” or “ ” to adjust the date and
time, press “ ” to confirm, after finishing, choose Confirm and press “ ”.
11 12

Format
Every time you insert a new microSD card, please format the card in the dash cam
to ensure better compatibility with the camera.
Select “Format” and press “ ”, choose “Confirm” and press “ ”.
Default
Select “Default” and press “ ”, choose “Confirm” and press “ ”, and then dash
cam will be restored to factory settings.
Version
Select “Default” and press “ ” to check the camera’s version. Press “ ” to exit.
PLAYBACK MENU
Use this mode to view and manage photos and videos. Long press “ ” to enter
the playback menu. Use the Up and Down buttons to scroll through the recorded
video/photo files. The device is not recording when it is in the Playback menu.
Fa
R RaR
F
Front emr Front photo
Back norm Back emr Back photo
Back
F
Front norm
Delete the videos/photos
Press “ ” to switch from “Folder Name”, “Select All”, “Delete”, and “Return”.
1. Select All: Press “ ” to select all videos/photos. If you want to choose a few
videos/ photos, press “ ” and use the Up and Down buttons to scroll through
the recorded video/photo, press “ ” to deselect.
2 Press “ ” and press “ ” to choose “ ”.
3 Press “ ” and press “ ” to choose “Confirm”.
Return to the playback menu
Press “ ” and press “ ”. Or press “ ”, use “ ” to choose “ “ and
press “ ”.
Return to the recording menu
Press “ ” to choose “Back” and press “ ” to exit.
View the videos/photos
1. Press “ ” to enter the files.
2. Use the Up and Down buttons to choose which video/photo you want to view.
3. Press “ ” to play the video/photo.
4. Long press “ ” to exit
SPECIFICATIONS
1. Front Camera: 5MP, f/1.6, 170° FOV
2. Rear Camera: 2MP, f/2.0, 170° FOV
3. Video: 2.5K@25fps + 1080P@30fps
4. Screen: 3-inch IPS Display
5. Video Coding: H.264/H.265
6. Input: 5V DC
7. Size: 85mm*48mm*17mm
8. Weight: 104.9g
9. Working Temperature: -20°C~60°C
13 14

TROUBLESHOOTING
If your dash cam does not appear to be operating properly, please follow these
troubleshooting steps:
1. Cannot record
① Check whether your microSD card has enough space. Please format the
microSD card after use.
② Check if the loop recording in the setting menu is set to OFF.
Set "Loop Record" to 3 MINS.
2. When it is recording, it will stop automatically
At the time of recording, a large amount of high-definition video data are
processed. Please use a high-speed microSD card of Class 10 or higher.
3. A "File Error" prompt appears when you playback your pictures and videos
Please use a genuine microSD card. Please format the microSD card.
4. The image is misty
Ensure there is no fingerprints or dirty on the camera lens, and use a soft and dry
cloth to clean the lens. Clean the front windshield.
5. Crash
After the crash, use a sharp object to press the reset button to restart the device.
PRECAUTIONS
1. Please place it in a secure place and prevent the lens from scratches and dirt.
2. Do not expose the device to rain, moisture, or water under any circumstance.
3. Avoid leaving the device in direct sunlight for extended periods of time.
4. Do not dismantle or expose the internal battery.
CONTACT US
For any inquiries with KingSlim products, please feel free to contact us, we will
respond within 24 hours.
E-mail: [email protected]
Tel: [phone] (US) Mon-Fri (except holiday) 9am-5pm (EST)
Official website: www.kingslim.net
microSD and the microSD logo are trademarks of SD-3C, LLC.
15 16