Kitronik MOVE mini User manual

:MOVE LINE
FOLLOW BOARD
FOR BBC MICRO:BIT
STAY ON TRACK WITH THIS
For Original :MOVE mini

To use with the :MOVE mini,
please see ‘Use with :MOVE
mini’ on the following page.
If you wish to use this board
separately connect the line
follow board to the interface
board in the order shown.
GND 0V
P15 R
3V3 3V
P16 L
GND 0V
BUILD INSTRUCTIONS
1
To use the Line Following board
with the Interface board, first
complete the build instructions
provided with the Interface Board.
2
NOTE: This kit includes fixings for both the original
:MOVE mini and :MOVE mini Mk2, so there may be spare
components left over after the build.

Remove both the front ‘:MOVE’ piece
and the SERVO:lite board from the
:MOVE mini. Fix the Line Follow board to
the chassis using the two SHORTER M3
countersunk screws. Insert the screws
from above and fix in place with two M3
nuts. The remaining spacers, screws and
:MOVE panel are no longer needed.
1
Connect the servos and install the Servo:Lite/Interface board
assembly into the :MOVE mini. Reconnect the cables, refer to
step 2 from the ‘Build instructions’ on the previous page.
GET CODING!
Visit kitronik.co.uk/5659 for help. See
the online datasheet for a tuning guide.
2
3
USE WITH :MOVE MINI
NOTE: Make sure you use the board the
correct way up, with the larger Kit robot
visible from below and the pins pointing
out of the front of the :MOVE mini.
NOTE: This instruction book is for :MOVE mini Mk1. If you have a Mk2
:MOVE mini, visit www.kitronik.co.uk/5659-mk2.

For more information on RoHs and CE please visit kitronik.co.uk/
rohs-ce. Children assembling this product should be supervised by
a competent adult. The product contains small parts so should be
kept out of reach of children under 3 years old.
:
Example
Use
STOCK CODE:
5659
TOOLS REQUIRED:
- Small Phillips screwdriver
Add line following to your micro:bit buggy/
robots with the compact Kitronik :Move
Line Following Board For BBC micro:bit,
also fully compatible with :MOVE mini.
KIT REQUIRES:
- 1 x BBC micro:bit
- 1 x :MOVE Sensor Interface
board (optional)
- 1 x :MOVE mini buggy kit
(optional)
INSTRUCTIONS:
This booklet contains build instructions.
For more detailed resources please visit
our website at www.kitronik.co.uk/5659