Kitronik BULLDOZER 5671 User manual

BULLDOZER
ADD-ON
GET LIFTING WITH THE
V2.0
For :MOVE mini Mk2

BUILD INSTRUCTIONS
The Servo:Lite board will need to be converted for the use of three
servos with the pin header provided. Visit kitronik.co.uk/3servo for the
online guide.
3 SERVO CONVERSION
1
Remove the wheels, followed by the green and white side panels.
DISASSEMBLY
2
This kit is compatible with all versions of
:MOVE mini.
If you are using a Mk2 :MOVE mini, you will not
require the two side panels, as shown to the right.
If you have the original :MOVE mini, visit
kitronik.co.uk/5671 for instructions.
NOTES

a. Remove the boot lid and feed the new
servo cable through the central cross.
MOUNT SERVO MOTOR
3
b. Push the servo arm into the rectangular cut
out on the left hand side.
c. Place the boot lid back into its
original place, slotting the servo
axle through the side panel.

Push the gear onto the
servo shaft. Secure in
place with a washer and
the small screw provided
in the servo packet.
ADD GEAR
4
With the back of the board facing you, the third servo attaches to the
uppermost, right, set of pins. Track the servo cable round the side of
:MOVE mini, and connect to these pins. Make sure the brown cable is at
the top!
CONNECT SERVO CABLE
5

Gently rotate the servo gear until it
reaches its maximum clockwise
position.
SET THE SERVO
6
Align the arm with the gear, as shown,
in the fully down position.
ALIGN THE ARM
7
Use one of the M3 Countersunk
screws to secure it to :MOVE
mini.
SECURE ARM
8

Repeat for opposite side, using the remaining bulldozer arm.
REPEAT
9
Using the smaller M2x6mm screws, slot
the scoops in between the two arms, and
secure in place.
ADD SCOOPS
10

Visit kitronik.co.uk/5671 for help.
GET CODING
13
Re-assemble the green and white
side panels into their original
place, and secure with the
original nuts and bolts.
REASSEMBLE THE SIDES
11
Finally slot the wheels back
onto the servo motors, and
secure back in place using
the small servo screws
previously removed.
ADD THE WHEELS
12

Designed & manufactured
in the UK by
T: 0845 8380781
W: www.kitronik.co.uk
E: [email protected]
kitronik.co.uk/twitter
kitronik.co.uk/facebook
kitronik.co.uk/youtube
kitronik.co.uk/instagram
For more information on RoHs and CE please visit kitronik.co.uk/rohs-ce. Children
assembling this product should be supervised by a competent adult. The product
contains small parts so should be kept out of reach of children under 3 years old.
WARNING: Contents may inspire creativity
NOTE: This accessory requires modification to the Servo:Lite board
and disables the on board ZIP LEDs. Visit kitronik.co.uk/3servo for
the online guide.
- Phillips Screwdriver
- Soldering Iron
- Knife
TOOLS REQUIRED
5671
STOCK CODE
CONTENTS
*Only required for use with the original :MOVE mini.
*
*