Kitronik MOVE Motor Klaw User manual

:MOVE Motor Klaw
V1.0
GET TO GRIPS WITH THE

BUILD INSTRUCTIONS
2
1
3
Remove the horn from
the servo and follow
the diagram to
assemble the rest
of your Klaw.
4Attach to your :MOVE Motor using the M4 bolt
into the mounting hole as shown below, then
connect the servo lead to one of the servo pin
headers on the :MOVE Motor. You can mount the
Klaw vertically or horizontally based on which
mounting hole you use.
Note: There are two
kinds of Klaw in this
kit! Swap out this pincer
to switch between builds
(see step 4).
a
b
a
b
Take care not to damage
the servos wires when
tightening these screws!
Visit www.kitronik.co.uk/5696 for coding tutorials!
Check these screws are
loose enough that the
pincers can rotate freely.
Connect a horn to the servo axle
and gently rotate clockwise until it
stops. Then rotate back an 1/8 turn.
3

For more information on RoHS and CE please visit kitronik.co.uk/rohs-ce. Children
assembling this product should be supervised by a competent adult. The product
contains small parts so should be kept out of reach of children under 3 years old.
TOOLS REQUIRED: STOCK CODE
5696
• Small Phillips Screwdriver
CONTENTS
Designed & manufactured
in the UK by
T: [phone]
W: www.kitronik.co.uk
E: [email protected]
kitronik.co.uk/twitter
kitronik.co.uk/facebook
kitronik.co.uk/youtube
kitronik.co.uk/instagram
For more information on RoHs and CE please visit kitronik.co.uk/rohs-ce. Children
assembling this product should be supervised by a competent adult. The product
contains small parts so should be kept out of reach of children under 3 years old.
WARNING: Contents may inspire creativity