Kleenmaid OMF6010 Installation guide

2

3

4
Dear Customer,
we would like to thank you and congratulate
you on your choice.
This new product has been carefully designed
and built using top quality materials, and
meticulously tested to ensure that it meets all
your culinary requirements.
Please read and observe these simple
instructions, which will enable you to achieve
excellent results from the very first time you
use it. This state-of-the-art appliance comes
to you with our very best wishes.
THE MANUFACTURER
THIS PRODUCT IS DESIGNED FOR DOMESTIC
USE.
THE MANUFACTURER DECLINES ALL
RESPONSIBILITY FOR DAMAGES TO THINGS
OR PEOPLE DERIVING FROM INCORRECT
INSTALLATION OR IMPROPER, ERRONEOUS
OR UNSUITABLE USE.
THE APPLIANCE MUST NOT BE USED BY
PEOPLE (INCLUDING CHILDREN) WITH
PHYSICAL, SENSORIAL OR MENTAL
IMPAIRMENTS, OR BY PEOPLEWITHOUTTHE
NECESSARY EXPERIENCE OR KNOWLEDGE,
UNLESS THEY ARE SUPERVISED OR
INSTRUCTED INTHE USE OFTHE APPLIANCE
BY A PERSON RESPONSIBLE FOR THEIR
SAFETY.
CHILDREN MUST BE SUPERVISED TO
ENSURE THAT THEY DO NOT PLAY WITH THE
APPLIANCE.
DO NOT PLACE TIN FOIL, PANS OR SIMILAR
IN CONTACT WITH THE INNER BASE OF THE
OVEN TO COOK. THE HEATING ACTION OF
THE LOWER RESISTANCE CAUSES THE
LOWER PART OF THE OVEN TO OVERHEAT,
LEADING TO DAMAGE AND EVEN SERIOUS
CONSEQUENCES (FIRE RISK) ALSO TO THE
UNIT IN WHICH THE OVEN IS INSTALLED.

5
Contents
User instructions, 6
First use, 6
Control panel, 7
Instructions for use:
- conventional cooking, 7
- fan cooking, 7
- defrosting, 7
- grill cooking, 8
Thermostat, 8
Cooling fan, 8
Timer touch control, 9
Setting the clock, 9
Minute counter,9
Cooking time, 9
End of cooking time, 9
Programming automatic cooking, 10
Adjusting beep volume, 10
Light replacement, 10
Removing the oven door, 11
Installation instructions, 12
Flush fitting, 12
Electrical connections, 13
IMPORTANT
The oven’s data plate is accessible even
with the oven fully installed. The plate is
visible simply by opening the door. Always
quote the details from it to identify the
appliance when ordering spare parts.

6
The first time you use the oven
Clean the oven thoroughly with soapy water and rinse
well. To remove the lateral frames from smooth-walled
ovens, proceed as shown in the figure.
Operate the oven for about 30 minutes at maximum
temperature to burn off all traces of grease which might
otherwise create unpleasant smells when cooking.
Important:
As a safety precaution, before cleaning the oven,
always disconnect the plug from the power socket or the
power cable from the oven. Do not use acid or alkaline
substances to clean the oven (lemon juice, vinegar, salt,
tomatoes etc.). Do not use chlorine based products,
acids or abrasive products to clean the painted surfaces
of the oven.
User instructions

7
Instructions for use
Conventional cooking
Conventional cooking uses top and bottom heat to cook
a single dish.
Place the food in the oven only once cooking temperature
has been reached, i.e. when the heating indicator goes
out.
If you want to increase top or bottom temperature towards
the end of the cooking cycle, set the temperature control
to the right position. It is advisable to open the oven door
as little as possible during cooking.
Fan cooking
For this type of cooking a fan positioned at the back
allows the circulation of hot air inside the oven, creating
uniform heat. In this way cooking is more rapid than
conventional cooking. It is a suitable method for cooking
dishes on more than one shelf, especially when the food
is of different types (fish, meat etc.).
Defrosting
By selecting one of the fan cooking functions and setting
the thermostat to zero, the fan allows cold air to circulate
inside the oven. In this way frozen food can be rapidly
defrosted.
It is not essential to preheat the oven, but you are
advised to do so when cooking pastries.
Control panel functions
Function symbols on the selector
Oven light (stays on while oven is in use).
Top and bottom heating elements.
Thermostat setting from 50°C to MAX.
Top heating element (small, low)
Double top heating element with fan (large
area grill). Thermostat setting from 50°C to
200°C.
Top and bottom heating elements with fan.
Thermostat setting from 50°C to MAX.
Circular heating element with fan. Thermostat
setting from 50°C to MAX.
Bottom heating element + fan.
Thermostat setting from 50°C to MAX.

8
Grill cooking
Use the grill to grill or brown foods.
Place the shelf with the food to be cooked in the 1st or
2nd position from the top.
Pre-heat the oven for 5 minutes. Turn the thermostat to
a temperature between 50° and 200.
Cooling fan
TANGENTIAL COOLING
A forced air circulation system which contributes to
reducing the heat exchange temperature in the front
and lateral areas of the ovens.
The fan is positioned on the upper part of the oven and
create a circle of cooling air on the inside of the furniture
and through the door of the oven. It is turned on when
the temperature of the outer shell of the oven reaches
60°C.
By switching on the oven with the thermostat at 200°C
the fan starts working after approx.10 min.
It is turned off when the temperature of the outer shell of
the oven falls below 60°C.
By switching off the oven with the thermostat at 200°C
the fan stops working after approx. 30 min.
Thermostat
Use the thermostat to set the cooking temperature
you need. The thermostat can be adjusted from 50° to
250°C.

9
Minute counter
Fig. 2
As this minute counter does not control the oven, when it
finishes counting the oven will continue to work.
To set, press the central button for 3 seconds until
appears (figure 2). Press “+” and “-” to set the required
time.
To set the minute counter at a later stage, press the
central button for 3 seconds and adjust as described
above.
The minute counter beeps when it finishes counting. To
disable it, press any button.
Cooking time
Fig. 3
This is a semi-automatic cooking function. It can be used
to set cooking times.
Press the central button for 3 seconds. Then press it
again until “dur” appears (figure 3). Press “+” and “-” to
set the required cooking time.
End of cooking time
Fig. 4
The end of cooking time can also be set.
Press the central button for 3 seconds. Press the central
button twice consecutively and wait for “End” to appear
(figure 4). Press “+” and “-” to set the required end of
cooking time.
The oven will work in the set mode and at the set
temperature until the end of cooking time.
Timer touch control
Setting the clock
Fig. 1
“Auto” and “0:00” will start flashing when the unit is
switched on for the first time. To set the clock, press the
central button for about 3 seconds. When appears,
press “+” or “-“ to set the correct time.
Wait until a beep tells you that the clock has been set
(figure 1).
To set the time at a later stage, press “+” and “-” together
for 3 seconds and then adjust the clock as described
above.

10
Programming automatic cooking
Fig. 5
Cooking function with set times.
Press the central button for 3 seconds. Then press it
again until “dur” appears. Press “+” and “-” to set the
required cooking time. Wait a few seconds for the setting
to be memorised.
Press the central button for 3 seconds. Press it another
two times and wait for “End” to appear (figure 4). Press
“+” and “-” to set the required end of cooking time.
E.g.:
Current time: 12.30
Cooking time: 10 minutes
End of cooking time: 14.00
The oven will start cooking at 13.50 (14.00 less 00.10)
at the set temperature and in the set mode and will stop
at 14.00.
The oven will beep when it stops cooking. To disable it,
press any button.
Adjusting beep volume
Fig. 6
To adjust beep volume, press “+” and “-” together. Then
press the central button and wait for “ton1” (high volume)
to flash. Press “-” to select “ton2” (medium volume) or
“ton3” (low volume).
Press the central button to set the selected volume.
Replacing the oven light
IMPORTANT:
The oven light must be the correct specification
a) it must be able to resist high temp (up to 300°C)
b) 240v
c) power 25W
d) E14 connection. Before proceeding, disconnect
the appliance from the main electricity supply.
- To prevent damage, place a tea cloth in the oven;
- unscrew the glass cover of the light;
- unscrew the old light bulb and replace it with the new
one;
- put back the glass cover and remove the tea cloth;
- connect the appliance to the main electricity supply;