Kleenmaid RHSO91 Installation guide

cooking collection
Instructions for use and warranty details
T o re g ister your warranty or m a k e a
warranty clai
m, scan t h is QR code :
Rangehood
Model No.: RHSO91

Dear Customer,
Thank you and congratulations for choosing
Kleen maid.
Your new appliance has been designed
and meticulously tested to ensure that it
meets all your culinary requirements, and
has been carefully manufactured using top
quality materials to give you years of reliable
performance.
For best results, carefully read the instructions
on how your new appliance is to be installed.
Correct installation will avoid delays and
unnecessary service call costs.
Once installation is complete, please read this
instruction manual carefully and get to know
the controls and the features of your new
Kleenmaid appliance. These simple instructions
will enable you to achieve excellent results from
the very first time you use it.
Again, congratulations and thank you for
choosing The Best You Can Own.
KLEEN MAID
2

Table of contents
4
4
5
6
7
8
8- 10
• Technical S pecifi cations
•
• SAFETY: Read this first!
• Warnings
• Description of Parts
• Instruction for use
• Installation
• Cleaning & Maintenance
• Troubleshooting
• Warranty Terms & Conditions
3
11 - 1 2
14-15
*Read the complete manual carefully before installation*
The current online version of the User Manual is available on the
Kleenmaid website (see back cover for details).
Dimensions
13

2 8
φ 1 5 0
278
4 2
2 2
1 5 52 8 0
8 9 9
4 4
9 0
2 5
8 6 0
50 0
W899xD280xH278mm
Voltage
Rated Power
Lighting Power
Motor Power
Diameter of air outlet
Air flow
1.5 W x2
150mm
Max 850m 3/h (air flow meter)
280W
283W
220-240V~ 50Hz/60Hz
Noise 57dB(A) at Low Speed
Standby Power
0W
TECHNICAL SPECIFICATIONS
DIMENSIONS
ExternalDimensions:
4

SAFETY: Read this First !
•
•
•
•
•
•
•
•
•
Do not connect the appliance if there are obvious signs of transportation
damage.
Read this user manual thoroughly before attempting to use this appliance.
Installation and repair should be attempted only by qualified technical
personnel.
It is dangerous to modify any parts of this appliance.
The manufacturer declines all responsibility in case of failure to adopt proper
safety measures.
Ensure the location in which this appliance is installed has good, permanent
ventilation.
The safety gap between the rangehood and the hob below must comply with
the recommendations of the hob manufacturer. In case of no instructions, a
minimum distance of 650mm (or other minimum distance as may be specified
by AS ZS 5601 and interpreted by a certified installer) should apply.
Use an electrical connector with earth that conforms to local standards.
Check that the voltage in your area is correct before plugging in.
Multiple plugs and extension cables must not be used. Electrical overload is
dangerous and may cause a fire.
Ensure that the power cord is free from any heat source or sharp objects.
The appliance should be switched off and the electrical supply disconnected
before any cleaning or maintenance work is carried out.
The electrical connection of this appliance must be connected to earth.
  


EARTH
NEUTRAL
LIVE
5
•
•
•
WARNING: IT MUST BE ENSURED THAT THIS
APPLIANCE IS CONNECTED ONLY
TO A 230VAC &
+10%/-6% 50Hz MAINS POWER SUPPLY WHICH
CONTINUOUSLY COMPLIES WITH THE RELEVANT
AUSTRALIAN STANDARD. FAILURE TO DO SO MAY
SERIOUSLY DAMAGE THE APPLIANCE AND ANY
SUCH DAMAGE
IS NOT COVERED BY THE
MANUFACTURER'S WARRANTY.

Warning
6
•This appliance and packaging are produced by processes that minimize waste
and respect the environment.
•There are model specific accessories (e.g. screws) supplied with the
rangehoodwhich should be retained for installation and not discarded with
packaging.
•Please help us to continue the protection of the environment by disposing of the
packaging in a correct manner.
•Please do not allow young children to play with the plastic bag packaging.
•Before disposing of any old appliances, be sure to cut off the power cord so that
others will not be endangered by a defective electric appliance.
----This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their well being.
--- Children must be supervised so they do not play with the appliance.
--- There should be adequate ventilation of the room when the rangehood is used at the
same time as appliances burning gas or other fuels. (Not applicable to appliances that
only discharge the air back into the room.)
--- There is a fire risk if cleaning is not carried out in accordance with the instructions.
--- Do not flame under the rangehood.
--- CAUTION: Accessible parts may become hot when used with cooking appliances.
--- The air must not be discharged into a flue that is used for exhausting fumes from
appliances burning gas or other fuels.
---- Regulations concerning the discharge of air must be fulfilled .
--- If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
----Cleaning and user maintenance should not be made by children without supervision.
Safe disposal of appliances and packaging

Installation
Notes:
•Attach the rangehood to the kitchen unit.
•The safety gap between the rangehood and the hob below must comply with the
recommendations of the hob manufacturer. In case of no instructions, a minimum
distance of 650mm (or other minimum distance as may be specified by AS/NZS 5601
and interpreted by a certified installer) should apply.
•When the rangehood is operating at the same time as other non-electrical cooking
equipment, the outlet air pressure must not exceed 4 Pa.
•To achieve optimum performance the length of the outlet ducting should not exceed 4
meters, or include more than two 90 angles (elbows). Rigid smooth surface ducting is
recommended.
•The maximum recommended overall ducting path to the outside of the building (for
150mm diameter smooth-walled, rigid pipe only) is 10m, reduced by 2.5m for each 90’
bend in the ducting path.
•It is recommended that the rangehood in an apartment be either connected to a
dedicated ducting outlet on the external wall, or that it be installed in recirculating
mode, including the use of carbon filters, allowing the air to be returned to the kitchen
through the outlet pipe.
•If the cabinet into which the rangehood is installed is more than the total depth of the
rangehood the installer will need to fit an appropriately thick sealing batten to the wall
behind the rangehood, equal in width to the rangehood.
Instructions for use
Press the button shown in the diagram below, to control the functions of the rangehood.
To achieve better fume extraction, it is recommended the rangehood be switched on for
a few minutes (approx 3-5minutes) before starting to cook so that the air flow is stable
and continuous.
8
NOTE: Before making preparations for or commencing installation, the installer should refer
to the current online version of the User Manual, which is available on the Kleenmaid website
(see back cover for details).
Speed
Low
11
Hi gh
* Light
ON
0
OFF
A Automatic

•Before installation make sure that the household voltage is same as the voltage on the
rating label of the rangehood.
•The wall or ceiling on which the rangehood is installed must be flat and strong enough to
support the rangehood. The wall shall be non-combustible. The rangehood must not be
mounted on a wall made of flammable material such as wood.
•To prevent any fire, please discharge the exhaust gas outdoors.
•The air must not be discharged into a flue that is used for exhausting fumes from
appliances burning gas or other fuels.
•Do not unpack your rangehood if your kitchen is being renovated as building materials,
dust, paint, coatings, and their gases may corrode and tarnish the surface of the
rangehood. Please install the rangehood after cabinetry work and painting etc is complete.
•The rangehood shall be level, firm and steady after the installation.
Location and height for installation
•Install the rangehood in a dry place without direct sunlight.
•If the rangehood is installed within a cabinet, there must be enough space allowed to
easily install, disassemble and maintain the rangehood.
•The rangehood shall be installed as close to the external wall as possible to shorten the
distance between the outlet of the rangehood and the external wall.
•The rangehood shall be mounted above the stove in parallel and on the same axis.
•The safety gap between the rangehood and the hob below must comply with the
recommendations of the hob manufacturer. In case of no instructions, a minimum distance
of 650mm (or other minimum distance as may be specified by AS/NZS 5601 and
interpreted by a certified installer) should apply.
•The vertical separation distance shall not exceed 750mm so as not to adversely affect
the extraction efficiency. See diagram below.
Notes
9
E
E
0
0
M
Duc ti ng
~
.- -1 2=il mrrncrn nn ,,,(,,,
1 1
"'''
1
'' '1'''''';,,:#~ Ceili ng
--,
: : :.
==:.
=::,
II
--, I
II u
I 610/910 I
=
0000000000,000
=
=
0
.,,
...
l
0
.,,
CD
r ict ure:)
Unit:mm

Drill holes and install rangehood body
■Drill hole of 170mm diameter on the top of the cabinet. See diagram below.
■The top four ST4 self-tapping screws are screwed up into the bottom of the cabinet OR
■Fix the rangehood to the cabinet/wall behind it.
■Install a batten (mounting board) under the rangehood to cover the gap between the back of
rangehood and cabinet.
Ducted Mode - Installing the rigid smooth surface ducting (not supplied)
■Fix one end of the rigid duct pipe onto the outlet of the rangehood, and connect the other end
directly to the external wall hole. The connection should be firmly fixed and sealed.
■The non-return (butterfly) valves need to be installed when using the ducted mode. When
installing the duct pipe, ensure the non-return valves of the rangehood can be operated normally.
■Avoid too many bends of the duct pipe, and bending angle of less than 90 degrees as this will
affect the efficiency of the appliance. (See Notes page 8.)
■Do not connect the duct pipe of this rangehood with any pipe of smaller diameter as this may
affect the exhaust.
■Do not attach the ducting from this rangehood to a shared or public flue, unless the specific
nature and design of this attachment has been certified in accordance with all applicable local
building and safety regulations.
■The distance from the top of rangehood to the ceiling should be at least 300mm.
Recirculation Mode
Put the carbon filters onto both sides of the
blower motor (as shown above), then turn in a
clockwise direction to click into place. Caution:
1) The non return (butterfly) valves should be
removed when using recirculating mode.
2) The distance of the rangehood air outlet to the
top of the cabinet should be at least 200mm
3) With normal usage the carbon filter should be
replaced every 3 mths.
4) The cabinet door should have an air inlet louvre.
10
450/750
4- M5
Ho le ror the top Q1 cab l n4!1
Unit (mm)
Pid ure4
Duct i ng
Duct i ng
I
1n 1 r,11,n n ,,C
~i li ng1.Ut.LIUIU.J..I UI~/~
~
,nt nn,n n ,.C C .1 .
E
~
IUUJUIW•U•~ ,.,_..\ e, 1 ng
'=.::j -
~
--·
C: ::,
E =•
'=~
E I -
-·
0
~
C =•
0 E
.= ,
(".)
'= =I
~
-C:
::,
1 =7
-
~
-C =1
I I -
~
A
~
A
I =
OO<I0:>011000000
=
=
=
~
=
IIOCIOOOCOOOOOO
=
=
5 =
Connec t to oub lic flu e Connec t to out doo rs