Kleenmaid RHSOG60 Installation guide

RHSOG60 & RHSOG90

!
EXT

X
Y
Z
XY Z
312 234 23 450 mm
362 234 23 500 mm
412 234 23 550 mm
462 234 23 600 mm
762 234 23 900 mm
Ø 6 mm
3,9 x 6 mm (3x)
1
2
3

M
T
M= 183 mm
T= Ø 156 mm
4,2x32mm
(4x)
4
5
6
42
71 140
4,2x32mm (4x)
3,9x9,5mm (4x)

EXT
Installing the
charcoal
filters
D
AB C
10
7
8
9
Removing the
charcoal filters

Please Read Carefully
WARNING
The minimum distance between the hob surface on which the
pans stand and the lower part of the hood must be 65 cm, unless
otherwise specified in the installation instructions. If the hob
installation instructions specify a greater distance, it must be
taken into account.
The air collected must not be conveyed into a duct used to blow
off smokes from appliances fed with an energy other than
electricity (central heating systems, thermosiphons, water-
heaters, etc.).
Comply with the official instructions provided by the competent
authorities in merit when installing the disposal duct. In addition,
exhaust air should not be discharged into a wall cavity, unless
the cavity is designed for that purpose.
Regulations concerning the discharge of air have to be fulfilled.
The room must be well aerated in case a hood and some other
heat equipment fed with an energy other than electricity (gas,
oil, coal heaters, etc) operate at the same time.
In fact the intake hood, disposing of air, could create a vacuum
in the room. The vacuum should not exceed 0,04mbar. This
prevents the gas exhausted by the heat source from being
intaken again. It is therefore advisable to ensure the room
contains air taps able to ensure a steady flow of fresh air.
Check the data label inside the appliance; if the symbol
() is printed, read the following: this appliance has
such technical particulars that it belongs to class II
insulation, therefore it must not be earthed.
Check the data label inside the appliance; if the symbol
() is NOT printed, read the following: ATTENTION: This
appliance must be earthed. When making the electrical
connections, check that the current socket has a ground
connection.
When making the electrical connections, check that the voltage
values correspond to those indicated on the data plate inside
the appliance itself. In case your appliance is not fitted with a
supply cord and a plug or with other means for disconnection
from the supply mains having a contact separation in all poles
that provide full disconnection under overvoltage category III
conditions, that means for disconnection must be incorporated
in the fixed wiring in accordance with the wiring rules. If your
unit features a power lead and plug, position this so the plug is
accessible.
Always switch off the electricity supply before carrying out any
cleaning or servicing operations on the appliance.
USE
Avoid using materials which could cause spurts of flame
(flambées) near the appliance.
Do not flambé under the range hood.
When frying, take particular care to prevent oil and grease from
catching fire. Already used oil is especially dangerous in this
respect. Do not use uncovered electric grates.
To avoid possible risks of fire always comply with the indicated
instructions when cleaning grease filters and when removing
grease deposits from the appliance.
The appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
Caution: accessible parts may become hot when used with
cooking appliances.
This kitchen hood is intended for installation in domestic
kitchens above cooktops, cooking devices and similar kitchen
equipment.
MAINTENANCE
Thorough servicing guarantees correct and long-lasting
operation.
Any fat deposits should be removed from the appliance
periodically depending on amount of use (at least every 2
months). Avoid using abrasive or corrosive products. To clean
painted appliances on the outside, use a cloth dipped in
lukewarm water and neutral detergent. To clean steel, copper
or brass appliances on the outside, it is always best to use
specific products, following the instructions on the products
themselves. To clean the inside of the appliance, use a cloth
(or brush) dipped in denatured ethyl alcohol.

Closely follow the instructions set out in this manual.
All responsibility, for any eventual inconveniences, damages or
fires caused by not complying with the instructions in this manual,
is declined. The extractor hood has been designed exclusively for
domestic use.
!It is important to conserve this booklet for consultation at any
moment. In the case of sale, cession or move, make sure it is
together with the product.
!Read the instructions carefully: there is important information
about installation, use and safety.
!Do not carry out electrical or mechanical variations on the product
or on the discharge conduits.
Caution
WARNING! Do not connect the appliance to the mains until the
installation is fully complete.
Before any cleaning or maintenance operation, disconnect hood
from the mains by removing the plug or disconnecting the mains
electrical supply.
Always wear work gloves for all installation and maintenance
operations.
The appliance is not intended for use by children or persons with
impaired physical, sensorial or mental faculties, or if lacking in
experience or knowledge, unless they are under supervision or
have been trained in the use of the appliance by a person responsible
for their safety.
This appliance is designed to be operated by adults, children should
be monitored to ensure that they do not play with the appliance.
This appliance is designed to be operated by adults. Children should
not be allowed to tamper with the controls or play with the appliance.
Never use the hood without effectively mounted grating!
The hood must NEVER be used as a support surface unless
specifically indicated.
The premises where the appliance is installed must be sufficiently
ventilated, when the kitchen hood is used together with other gas
combustion devices or other fuels.
The ducting system for this appliance must not be connected to any
existing ventilation system which is being used for any other
purpose such as discharging exhaust fumes from appliances
burning gas or other fuels.
The flaming of foods beneath the hood itself is severely prohibited.
The use of exposed flames is detrimental to the filters and may cause
a fire risk, and must therefore be avoided in all circumstances.
Any frying must be done with care in order to make sure that the oil
does not overheat and ignite.
Accessible parts of the hood may became hot when used with
cooking appliance.
With regards to the technical and safety measures to be adopted for
fume discharging it is important to closely follow the regulations
provided by the local authorities.
The hood must be regularly cleaned on both the inside and outside
(AT LEAST ONCE A MONTH).
This must be completed in accordance with the maintenance
instructions provided in this manual). Failure to follow the instructions
provided in this user guide regarding the cleaning of the hood and
filters will lead to the risk of fires.
Do not use or leave the hood without the lamp correctly mounted due
to the possible risk of electric shocks.
We will not accept any responsibility for any faults, damage or fires
caused to the appliance as a result of the non-observance of the
instructions included in this manual.
This appliance is marked according to the European directive 2002/
96/EC on Waste Electrical and Electronic Equipment (WEEE). By
ensuring this product is disposed of correctly, you will help prevent
potential negative consequences for the environment and human
WARNING: PLEASE READ THIS PAGE CAREFULLY BEFORE
INSTALLING OR USING THIS DEVICE
!
health, which could otherwise be caused by inappropriate waste
handling of this product.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
This appliance is marked according to the European directive
2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate
waste handling of this product. The symbol on the product
indicates that this product may not be treated as household
waste. Instead it shall be handed over to the applicable collection
point for the recycling of electrical and electronic equipment.
Disposal must be carried out in accordance with local
environmental regulations for waste disposal. For more detailed
information about treatment, recovery and recycling of this
product, please contact your local city office, your household
waste disposal service or the shop where you purchased the
product.

!The appliance must be installed by a qualified person in compliance
with the instructions provided.
!
Wear gloves when carrying out installation and maintenance
operations.
Warning: Failure to install the screws or fixing device in accordance with
these instructions may result in electrical hazards.
IMPORTANT: So as not to damage your product, during installation USE
ONLY THE SCREWS PROVIDED. Make sure these are used as shown in
the following instructions.
Prepare the power supply (see “Warning” sheet).
For the ducting version and version with an external motor, prepare the pipe
for air evacuation (see “Warnings” sheet).
FILTERINGORDUCTINGVERSION?
The hood may be in filtering or in ducting version. Decide from the outset
which type is to be installed.
For better efficiency, we recommend installing the hood in the ducting
version (if possible).
Ducting version
The hood purifies the air and evacuates it to the outside through an exhaust
duct.
Version with external motor
The hood purifies the air and evacuates it to the outside through an exhaust
duct. The appliance must be connected to an ducting apparatus/motor which
works on its own using the appliance as a union for the air to be scavenged
Filtering version
The hood purifies the air and recycles the clean air back into the room.
CONTROLS
Controls of Fig. 16:
A = ON/OFF 1st speed switch
B = II speed switch
C = III speed switch
The motor is automatically ON or OFF by opening/closing the truck (unless
switch A is on 0). Opening the truck the motor works according to last
speed registered.
D = Light switch:position A (automatic), the light are automatically regulated
ON or OFF by the opening/closing of the truck. Position M (manual), the
light is on. Position 0, the light is off.
MAINTENANCE
!Before cleaning or maintenance cut the power.
Cleaning the hood
WHEN TO CLEAN IT: clean in relation to use, at least every 2 months to
prevent the risk of fire.
EXTERNAL CLEANING: use a cloth moistened in lukewarm water and
neutral detergent (for painted hoods); use specific products for steel,
copper or brass hoods.
INTERNAL CLEANING: use a cloth (or brush) soaked in denatured ethyl
alcohol.
WHAT NOT TO DO: do not use abrasive or corrosive products (e.g. metal
sponges, brushes, too hard brushes, very aggressive detergents, etc.)
Cleaning the grease filters (F)
WHEN TO CLEAN IT: clean in relation to use, at least every 2 months to
prevent the risk of fire.
HOW TO CLEAN THE FILTERS: hand wash or in the dishwasher using a
neutral detergent. If washing in the dishwasher, possible discoloration of the
filters does not in any way compromise their functioning.
Replacing the charcoal filter
(for filtering version only)
WHEN TO REPLACE IT: replace in relation to use, at least every 6
months.
HOW TO REMOVE IT: see Figures 10.
Lighting
- Replace with light bulbs of the same type.
MALFUNCTIONS
If something appears not to be working properly, do the following simple
checks before calling Technical Service:
• If the hood is not working:
Check that:
- The power has not been disconnected.
- A speed has been selected.
• If the hood performs inefficiently:
Check that:
- The motor speed selected is sufficient for the amount of smoke and
vapours released.
- The kitchen is sufficiently ventilated to allow air intake.
- The charcoal filter is not worn (hood in filtering version).
• If the hood has turned off during normal functioning:
Check that:
- The power has not been disconnected.
- the omnipolar disconnection device has not tripped.
F
Components not provided with the product