Kleenmaid RH4 Installation guide

CookingCooking
c o l l e c t i o nc o l l e c t i o n
Instructions for Use
and
Warranty Details
RH4 - 600mm Slide Away Rangehood
RH5 - 900mm Slide Away Rangehood

ongratulations on the purchase of your new
C
appliance. This appliance has been
designed and manufactured to give you years
of reliable performance.
For best results, carefully read the instructions on
how to install your new appliance. Correct installation
will avoid delays and unnecessary service calls.
Once installation is complete, read this booklet
carefully and get to know the controls and the
features of your new appliance.
We reserve the right to alter the specifications
with no influence on the operation of the
appliance. This instruction manual cannot be
reason for a claim.

C
D
1
2
3
3
4
53
4
5
1
2
A
GG
F
K
2.1 2.2
1.1
1.2
1.3
45
66
H
B
3
CLOSED
OPEN
2.3
A

1
2
3
4
O
P
D
M
N
Q
R
O
P
67
89
10
11.1
11.2

7
Introduction to the Hood - Fig. 1.1
1. LightSwitch
2. MotorSpeed Switch
3. Illuminationofthecookingsurface
4. GreaseFilters/greasefiltersupportgrate
5. LightCoverSupports
6. Pull-OutDrawer
ModelwithGreaseFilterSupportGrate
Opening the Grease Filter Support Grates - Fig. 2.1
a. Remove the pull-out drawer completely.
b. PushtheAknobsinwards toward each other (inthe
“Open”directionasindicatedontheplasticknobitself).
c. To remove the grates completely, use the Bspring
fasteners,whichactaspinstoholdthegrateinplace
(Fig. 3).
Model with Self-supporting Metal Filters
Removing the Grease Filters - Fig. 2.2
a. Remove the pull-out drawer completely.
b. PressthesidehandlesC(somemodelsaresupplied
with handles Z - Fig. 2.3) towards the opposite side
and remove the filters.
Putting the Filters Back in Place
a. Removethepull-outdrawercompletelyandmountthe
grease filter so that it covers the drawer.
b. Closethedrawerandinstalltheremaininggreasefilter.
Opening the Light Cover Support
a. Remove the pull-out drawer completely.
b. According to model in possession:
Lamp Dwith hook locks type A- Fig.2.2
Movethebrackethooklockstowardseachother (in
direction“Open”asprintedontheplasticpartofthe
lock). Lamp Fwith hook locks type G- Fig. 1.2
Movethehooklocksasindicatedbythearrowsand
completelyremovethelampfromthehousing(Fig.
1.3).
SystemsAvailable
Venting Outdoors
Theairisventedoutdoorsthroughaductwhichmustbe
connectedtotheexhaustopeningK(Fig.5)bymeansof
the flange H. The diameter of the exhaust duct must be
exactly the same as that of the flange.
AirRecirculation
— Theairiscleanedbymeansofcharcoalfiltersandthen
circulatedback into the room.
— Theuseofacharcoalfilterisnecessarywhenthehood
cannotventedoutdoorseitherbecauseductingisnot
availableor cannot be installed.
— Thefilteredairisreturnedfromatopthecabinetthrough
a duct that passes through the cabinet itself.The
diameteroftheductmustbethesameasthatofflange
H(Fig. 5).
ThedeflectorJcanbefixedtotheoutletholeusingthe
two screws provided
(Fig. 4).
Tofit or replace a carbon filter:
a. Requestacharcoalfilterfromtheretailer,specifying
the model and type of hood.
Caution! Some charcoal filters come covered with a
plasticfilmtoprotecttheirfilteringproperties.Ifthisisthe
case, remove the film before installing the filter.
b. Remove the pull-out drawer completely.
c. Remove the grease filters or the grates.
d. Placetheactivatedcarbon filterinposition:
1) Versionwithonemotor:insertthefilterinitshousing
over the plastic grill and rotate it until it locks in
position (Fig. 6).
2) Version with two motors: to assemble the filter,
insertitinitsseatingandfixitinpositionusingthe
clips L(Fig. 7)
e. Remove the grease filters or grills
To remove the carbon filter, follow the procedure
described in item 1) or 2), depending on the version) in
the reverse order.
Installation
Wheninstalled,thedistancebetweenthehoodandburners
mustbenotlessthan43cmforelectricburnersor65cm
for gas or mixed-fuel burners.
Caution
This appliance is designed to be operated by adults.
Childrenshouldnotbeallowedtotamperwiththecontrols
or play with the appliance.
Donotusethecookerhoodwherethegrillisnotcorrectly
fixed! Thesuctionedairmustnotbeconveyedinthesame
channelusedforfumesdischargedbyappliancespowered
by other than electricity. The environment must always
beadequatelyaeratedwhenthecookerhoodandother
appliancespoweredbyotherthanelectricityareusedat
the same time. Flambé cooking with a cooker hood is
prohibited.Theuseofafreeflameisdamagingtothefilters
andmaycausefireaccidents,thereforefreeflamecooking
mustbeavoided. Fryingoffoodsmustbekeptunderclose
controlinordertoavoidoverheatedoilcatchingfire.Carry
outfumesdischarginginaccordancewiththeregulations
inforcebylocallawsforsafetyandtechnicalrestrictions.
Themanufacturersrefusetoacceptanyresponsibilityfor
damagetothehoodoritscatchingonfirebecauseoffailure
to observe the above instructions.
Electricalconnection
Theelectricaltensionmustcorrespondtothetensionnoted
onthelabelplacedinsidethecookerhood.Connectthe
electricalplug,whereprovided,totheaneasilyaccessible
GB

8
outlet in conformity with local standards in force.
Where an electrical plug is not provided (for direct
connectiontoelectricalnetwork)placeastandardsapproved
bipolarswitchwith an aperture distance ofnotless than
3mm (accessible) from the contacts.
Mounting the Hood
Thediameteroftheventilationductmustbethesameas
thethatoftheflangemountedontheventilationholeonthe
hood.
To mount the hood proceed as follows:
— Positionthedrillingtemplateinsidetheleftcupboard
on the right hand side with the arrow point towards
the back on the cupboard (Fig. 8)
— Drilltheholes marked on the template(Fig.8)
— Repeattheprocedurefortherighthandcupboard
— Ifthesidesofthecupboardsare18mmthick,insert
4 spacers Mon the sides of the hood (Fig. 9)
— Fix the hood to the cupboard using four screws N
(Fig. 9).
Adjusting the Pull-Out Drawer
Thehoodcanbeinstalledbeneathcabinets withvarying
depths.Adjustmentsforopeningandclosingthedrawer
can be made based on your specific needs.
To adjust the drawer, remove the ventilation grates by
looseningtheOscrewsandadjustingthePbrackets.Then
retighten the Oscrews (Fig. 10).
Using the hood
The hood is provided with several speeds.
Forthebestperformance,werecommendusingthelow
speeds in normal conditions and the high speeds when
strongodourandvapourconcentrationsarepresent.
We recommend starting the hood a few minutes before
cookingandkeepingitrunningforatleast15 minutesuntil
allthe odours have been eliminated.
Maintenance
Caution! Before performing any maintenance,
disconnect the hood from the electrical supply.
GreaseFilter
The grease filter serves to trap grease particles by
suspendingthem.
1. Synthetic Filter (thickness: 10-15 mm): wash the
filter in warm water and a biodegradable detergent
onceamonth.Letdrywithoutwringing.Replaceafter
the filter has been washed 5 or 6 times.
2. Thin Synthetic Filter (approximately 1 mm thick):
replacewhenthecoloringfromthetopisvisibleonthe
bottompart.
3. Thin Synthetic Filter (approximately 1 mm thick -
withoutsaturationindicator)replaceeverytwomonths.
4. Metal Filter: unlimited life; wash every month in
warmsoapy water, or, if possible, in thedishwasher
(60°C).Letdrybeforereinstallingit.
RemovingtheGreaseFilters(formodelswtihgrease
filter support grates)
To remove the dirty grease filter, proceed as follows:
a. Removethepull-outdrawercompletelyandopenthe
ventilationgratesthatsupportthegreasefilters.
b. Remove the Qfasteners for the grease filter and
removeit(Fig.11.1).Ifspecialmetalfiltershavebeen
installed,pressontheplasticspringsRtounhookthem
(Fig. 11.2).
c. Whenwashingorreplacingthegreasefilter,washthe
grate as well with warm soapy water.
d. Remountthenewfilterortheoldoneafterithasdried
thoroughly.
CharcoalFilter
The charcoal filter serves to eliminate odours that form
duringthecookingprocess.Undernormaluseconditions,
the filter should be replaced every 4 months. It can be
orderedfromtheretailer.Thecharcoalfiltermustneverbe
washed.
To remove the charcoal filter, proceed as follows:
a. Remove the pull-out drawer.
b. Remove the grease filters and open the light cover
support(orthegreasfiltersupportgrate).
c. Reverse the procedure described in item 1) or 2),
depending on the version, of the “Air recirculation”
paragraph.
ReplacingtheLamp
a. Remove the pull-out drawer.
b. Openthelightcoversupportorthebackgreasefilter
supportgrate.
c. Alwaysreplaceburnt-outlamps,accordingtowhatis
provided for your appliance, with olive-shaped max.
40Watt(E14)bulbs,orneon-lamp14Wattmax.,or
PLlamp11Watt(onePLlampappliance)orPL9Watt
(two PL lamp appliance).
d. Closethelightcoversupportorthebackgreasefilter
supportgrate.
e. Before calling for customer service because the
lighting system does not work, make sure that the
lamps are screwed in tightly.
Cleaning
Tocleantheoutsideofthehooduseaclothmoistenedwith
denaturedalcoholorneutralliquiddetergents.Neveruse
products containing abrasives.
Attention
Failuretoobservetheinstructionsforcleaningtheappliance
and changing and cleaning the filters may cause fires.
Therefore,werecommendobservingtheseinstructions.
GB

WARRANTY AND SERVICE
DOMESTIC WARRANTY - FULL FIVE YEAR WARRANTY
In addition to all statutory rights which you, the Consumer, have under the relevant laws in respect
of this appliance, during the first five years of ownership as the original purchaser of this
Kleenmaid appliance, we guarantee that any fault caused by faulty material or workmanship
becoming apparent will be rectified free of charge for parts and labour, provided that all service is
performed during normal working hours by Kleenmaid or their designated Agents. Where the
appliance is installed outside the normal servicing area of the above, the Purchaser must pay for
the cost of transporting the appliance to and from the Agent or the Agent’s travelling cost to and
from the Purchaser’s home.
COMMERCIAL WARRANTY - ONE YEAR WARRANTY
When this appliance is installed in a commercial application, you, the Consumer, have under the
relevant laws in respect of this appliance, during your first one year of ownership as the original
purchaser of this Kleenmaid appliance, we guarantee that any fault caused by faulty material or
workmanship becoming apparent, will be rectified free of charge for parts and labour, provided that
all service is performed during normal working hours by Kleenmaid or their designated Agents.
Where the appliance is installed outside the normal servicing area of the above, the Purchaser
must pay for the cost of transporting the appliance to and from the Agent or the Agent’s travelling
cost to and from the Purchaser’s home.
WHAT THESE WARRANTIES DO NOT COVER
We are not responsible for any damage or malfunction unless caused by a defect in material or
workmanship. This includes but is not limited to abuse, misuse, improper installation and
transportation damage. We are not responsible for any consequential damages from any
malfunction.
The Consumer must make the appliance available for servicing and shall bear any costs incurred
for any de-installation and/or re-installation required to make the appliance available for servicing.
Kleenmaid is not liable for any consequential damage incurred during de-installation or re-
installation.
WARRANTY DOES NOT COVER REPLACEMENT OF LIGHT
GLOBES OR GLASS BREAKAGE DUE TO IMPACT
In case of fractured glass do not use your appliance.
WARRANTY REGISTRATION
Please complete warranty details below and retain together with your proof of purchase document
These documents will need to be viewed by our Service Representative should you request in warranty
service.
SERVICE ASSISTANCE
To assist you when phoning our After Sales Service number to arrange a service call please complete
the following details and have them ready when you call.
Model Number_____________________________Date of purchase____________________________
Kleenmaid Store purchased from_________________________Date of installation ________________
KLEENMAID AFTER SALES SERVICE
1300 652 100

Other products available in the Kleenmaid
Range of appliances
Washers
Dryers
Dishwashers
Ovens
Cooktops
Outdoor Cooking Centres
Built In Espresso Coffee Machines
Rangehoods
Freestanding Ranges
Sinks
Waste Disposals
Taps
Cookware
Refrigerators
Freezers
Wine Cellars
Vacuum Cleaners
For sales information on the full range of quality appliances
Phone 13 13 08