RECOMMENDATIONS AND SUGGESTIONS
INSTALLATION
The manufacturer will not be held liable for any damages resulting from incorrect or
Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside
of the hood.
For Class I appliances, check that the domestic power supply guarantees adequate earthing.
Connect the range hood to the exhaust flue through a pipe of minimum diameter
120mm. The route of the flue must be as short as possible.
Do not connect the range hood to exhaust ducts carrying combustion flumes
(boilers, fireplaces, etc.).
If the range hood is used in conjunction with non-electrical appliances (e.g. gas
burning appliances),a sufficient degree of aeration must be guaranteed in the room in order to
prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly
with the open air in order to guarantee the entry of clean air. When the range hood is used in
conjunction with appliances supplied with energy other than electric, the negative pressure in the
room must not exceed 0,04 mbar to prevent fumes being drawn back into the room by the range
hood.
Regulations concerning the discharge of air have to be fulfilled.
WARNING: Failure to install the screws or fixing device in accordance with these instructions
may result in electrical hazards.
USE
The symbol on packaging indicates that this product may not be treated as
household waste. Instead it should be handed over at an applicable collection point for the
recycling of electrical and electronic equipment. By ensuring this product is disposed of
correctly, you will help prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate waste handling of this
product. For more detailed information about recycling of this product, please contact your
local council, your household waste disposal service or the shop where you purchased
the product.
The range hood has been designed exclusively for domestic use to eliminate kitchen
smells.
Never use the hood for purposes other than for which it has been designed.
Never leave high naked flames under the hood when it is in operation.
Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that
it does not engulf the sides.
Deep fat fryers must be continuously monitored during use: overheated oil can burst
into flames.
Do not flame under the range hood to avoid potential risk of fire.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their well being.
Children should be supervised to ensure that they do not play with the appliance.
Cleaning and user maintenance should not be performed by children without supervision.
CAUTION: Accessible parts may become hot when used with cooking appliances.
There shall be adequate ventilation of the room when the range hood is used at the
same time as appliances burning gas or other fuels.
MAINTENANCE
Switch off or unplug the appliance from the mains supply before carrying out any
maintenance work.
Clean and/or replace the Filters after the specified time period (Fire hazard).
Clean the hood using a damp cloth and a neutral liquid detergent.
The ap
pliance uses 4 hob elements at most.
There is a fire risk if cleaning is not carried out in accordance with the instructions.
improper installation.
The safety gap between the rangehood and the hob below must comply with the
recommendations of the hob manufacturer. In case of no instructions, a minimum
distance of 650mm (or other minimum distance as may be specified by AS/NZS 5601 and
interpreted by a certified installer) should apply.
It is necessary to allow disconnection of the appliance from the supply after installation. The
disconnection can be achieved by having the plug accessible or by incorporating a switch in the
fixed wiring in accordance with the wiring rules.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
