KMC Controls TTE-1001 User manual

TTE-1001 1 Installation Guide
Installation Guide
Room Temperature Transmitter
TTE-1001
Mounting
Standard:
• The base unit’s mounting slots are designed to
align with the holes in a standard 2" x 4" (51 x 102
mm) handy conduit box. Use such a box if using
conduit.
• On solid walls, normal screw and anchor systems
may be used.
Mounting 1
Connections and Wiring 2
Maintenance 2
Accessories 2
Important Notices 2
All dimensions are in inches (mm).
Hollow wall:
1. Cut a 3-3/4" x 1-3/4" rectangular opening in the
wall. (Check if unit is horizontal or vertical before
cuing.)
2. Make all necessary connections.
3. Insert an HMO-5001 Toggle Bolt Assembly
(ordered separately) through the wall and tighten.
NOTE: Care should be taken not to bend or ex the
base of the thermostat.

TTE-1001 2 Installation Guide
© 2011 KMC Controls, Inc. 815-019-01D
KMC Controls, Inc.
19476 Industrial Drive
New Paris, IN 46553
574.831.5250
www.kmccontrols.com
[email protected]
Maintenance
No routine maintenance is required. Each compo-
nent is designed for dependable, long term reliability
and performance. Careful installation will also
ensure long term reliability and performance.
Important Notices
The material in this document is for information
purposes only. The contents and the product it
describes are subject to change without notice.
KMC Controls, Inc. makes no representations or
warranties with respect to this document. In no event
shall KMC Controls, Inc. be liable for any damages,
direct or incidental, arising out of or related to the
use of this document.
Connections and Wiring
Refer to the wiring diagram.
NOTE: This TTE-1001/CEE-11xx conguration can
be used in place of an applicable CTE-11xx
room thermostat.
CEE-1100
Series Remote
Thermostat
Controllers
CEP/CSP
Series
Controller-
Actuator
TTE-1001
Remote
Temperature
Transmitter
HMO-5001 Toggle bolt assembly (for hollow
wall installation)
HMO-5002 Insulating backplate, 1-1/8" deep
HMO-5007 Insulating backplate, 1-11/16"
deep
HMO-5022 Mounting trim plate
Accessories