Kogan OVELA MICHELLE OVMICHMBBSA User manual

MICHELLE METAL BED
(SINGLE/KING/QUEEN/DOUBLE)
OVMICHMBBSA, OVMICHMBBDA, OVMICHMBBQA, OVMICHMBBKA,
OVMICHMBWSA, OVMICHMBWDA, OVMICHMBWQA & OVMICHMBWKA

Important!Read this user guide before you commence assembly.
• Follow the guidelines in this user guide to ensure correct assembly and care for this
product.
• Do not, for any reason, use a power tool to assemble this product. Use of power tools
may apply greater than necessary force on the fixtures, causing irreparable damage.
SAFETY & WARNINGS

Lay all components out on a clean floor and ensure all parts are included. If any pieces are
missing, check all packaging thoroughly, then contact help.Kogan.com for assistance.
1 LHS Upright
2 RHS Upright
3Headrest boards (x3)
4 Headrest support
5 Sides frame (x2)
6 Centre support
7a Slat assembly
7b Slat assembly
8 End board
9 Leg (x3)
10 Upright cap (x8)
11 Leg cap (x3)
COMPONENTS

Hardware
AM8x70 Screw (x8)
BM8x45 Screw (x12)
CM6x16 Screw (x10)
DM8x16 Screw (x4)
S5 M8 Allen key
S4 M6 Allen key

Step 1:
• Attach the three headrest boards (3) to the LHS upright (1) using six M8x45 Screws (B).
• Attach the headrest support (4) to the LHS upright (1) using two M8x16 Screws (D).
• Attach the RHS upright (2) to the head rest assembly using six M8x45 Screws (B) and
two M8x16 Screws (D).
• Place an upright cap (10)on the top and bottom of the two uprights (1)(2).
ASSEMBLY
Note:
Do not use power tools when assembling this product as this may cause damage to the
components.

Step 2:
• Attach the three legs (9) to the centre support (6) using six M6x16 Screws (C).
• Place a leg cap (11) on the bottom of the three legs (9).

Step 3:
• Attach the centre support (6) to the middle of the headrest support (4) using two M6x16
Screws (C).
• Attach the two side frames (5) to the headrest assembly using four M8x70 Screws (A).
Note:Pay attention to the orientation of the side frames. The flat edge should be
facing outwards.

Step 4:
• Attach the end board (8) to the two side frames (5) using four M8x70 Screws (A).
• Secure the centre support (6) to the end board (8) using two M6x16 Screws (C).
• Place an upright cap (10)on the top and bottom of both the end board (8) legs.

Step 6: Place both slat assemblies (7a, 7b) on top of the assembled bed frame.
Completed!