Kogan Shangri-La SLBUSSKTWA User manual

BURNIE STAINLESS STEEL
KITCHEN TROLLEY
SLBUSSKTWA, SLBUSSKTWB

COMPONENTS

Hardware
165mm M6
screw (x14) 2Barrel nut (x14) 3Hinge (x2) 4Handle (x2)
518mm M4
screw (x2) 6Stopper (x1)
712mm M3.5 screw
(x12)
835mm M3.5
screw (x4)
914mm M3.5
screw (x15)
10LLeft runner and
track set (x1)
10R Right runner
and track set (x1) 11 Dowel (x10)
12 Cam lock (x4) 13 Cam screw (x4)
14 14mm M4
screw (x2)
15 Locking castor
(x2)
16
Castor (x2)

A Phillips head screwdriver (not supplied) will be required to assemble this kitchen trolley.
Runner and track sets
The user guide refers to multiple sets of metal Slide Runners and Slide Tracks (pictured
above separately).
To avoid any damage to these items during transportation, the Slide Runners and Slide
Tracks have been pre-assembled together in pairs. Each pair includes a Slide Runner and
Slide Track. Before assembling your furniture, please separate the Slide Runners from the
Slide Tracks according to the below instructions.
Step 1: Extend the Slide Runners apart from the Slide Track
BEFORE ASSEMBLY
Slide Track
Slide Runner

Step 2: Gently press the plastic release lever on the Slide Runner while pulling the Slide
Runner and Slide Track apart from each other.
Step 3: The Slide Runner and Slide Track should now be separated. Repeat these steps for
all remaining pairs of Slide Runners and Slide Tracks.
Slide Runner
Slide Track

Step 1:
Step 2:
3 (x2)
6(x1)
9(x7)
1(x2)
2(x2)
11 (x2)
ASSEMBLY

Step 3:
Step 4: Using a Phillips head screwdriver, secure the left and right runners (10L, 10R) to parts
K and L with four 12mm M3.5 screws (7).
Secure parts K and L to parts M and N using four 35mm M3.5 screws (8).
7(x4)
8 (x4)
10L (x1)
10R (x1)
6(x1)
9(x2)
11 (x2)

Step 5: Insert four cam screws (13) into part J, then using a Phillips head screwdriver, insert
four cam locks (12) into both parts Kand L.
Align part J with both parts K and L. Ensuring the arrows on the cam locks (12) are pointing
towards the corresponding cam screws (13), secure the cam locks (12) into the cam screws
(13) to connect part J to parts Kand L.
Secure the handle (4) to part Jusing two 14mm M4 screws (14).
4(x1)
12 (x4)
13 (x4)
14 (x2)
Step 6:
1(x4)
2(x4)

Step 7:
2(x4)
11 (x8)
Step 8:
1(x4)