Kogan X9 User manual

X9 WET & DRY FLOOR
VACUUM CLEANER
(KAVACSTWDX9)

2
Safety & Warnings 3
Components list 6
Overview 7
Getting started 9
Operation 12
Cleaning & Care 14
Troubleshooting 19
Specifications 19

3
READ ALL INSTRUCTIONS BEFORE USING
THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY.
WARNING – To reduce the risk of fire, electric shock, or injury. Read all safety
warnings and instructions. Failure to follow the warnings and instructions may result in
electric shock, fire and/or serious injury. When using an electrical appliance, basic
precautions should always be followed, including the following:
•This vacuum can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the vacuum in a safe
way and understand the hazards involved. Cleaning and user maintenance shall not be
made by children without supervision.
•Children should be supervised to ensure they do not play with the vacuum.
•Do not immerse your vacuum into water or liquid.
•Keep hair, loose clothing, fingers and all parts of body away from openings and moving
parts of the vacuum and its accessories.
•Do not use with damaged cable or plug.
•If the supply cord is damaged, it must be replaced by Kogan.com, its service agent or
qualified person to avoid a hazard.
•Please dispose of the battery safely.
•The batteries can only be replaced by the trained person.
•Do not burn the vacuum even though damaged seriously because the battery could be
exploded on the fire.
•In the case of excessive force, liquid may spill from the battery, avoid touching the liquid,
please flush with water if accident happen. If the fluid goes into your eyes, ask for medical
help. The spilled liquid may cause pain or burns.
•Charge only with the charger specified by Kogan.com. A charger suitable for one type of
battery pack can cause a fire when mixed with another.
•The battery must be removed from the unit before disposal.
•Do not use damaged power cords or chargers.
•If the vacuum does not work properly or has been dropped on the ground to be damaged,
left outside or dropped in water, do not attempt to operate it and have it repaired at an
authorised service centre.
SAFETY & WARNINGS

4
•Use only the type and amount of liquids specified as instruction.
•Liquid must not be directed towards equipment containing electrical components.
•Do not pull or carry by cable, use cable as a handle, close door on cable or pull cable
around sharp edges or corners.
•Do not unplug by pulling on cable
•To unplug, grasp the plug, not the cable.
•Do not handle plug or appliance with wet hands.
•Do not short-circuit the output terminal of the battery string or charger base.
•Do not charge the device outdoors.
•When removing the battery, disconnect the power supply of the device.
•Do not charge, disassemble, heat (above 60 °C) or burn waste batteries.
•Please dispose of the discarded battery in time.
•Keep the battery out of reach of children.
•Do not put battery in mouth. If swallowed by mistake, contact your physician or local
poison control centre.
•To reduce the risk of injury from moving parts, assemble the brush cover correctly in place
before operation.
•Do not put any object into openings.
•Do not use with any opening blocked; keep free of dust, lint, hair and anything that may
reduce air flow.
•Turn off all controls before unplugging.
•Use extra care when cleaning on stairs.
•Do not use to pick up flammable or combustible liquids, such as petrol or use in areas
where they may be present.
•Do not suck toxic material (chlorine bleach, ammonia, drain cleaner, etc.)
•Do not use vacuum in an enclosed space filled with vapours given off by oil base paint,
some mothproofing substances, flammable dust or other explosive or toxic vapours.
•Do not suck hard or sharp objects such as glass, nails, screws, coins, etc.
•Do not use to sweep up burning or smoking objects, such as cigarettes and matches.
•Install the filter in proper before starting the vacuum.
•Do not use it outside of houses.
•Do not store the vacuum in places where icing may occur.
•Do not expose to rain. Store indoors.
•Use only manufacturer’s recommended attachments.
•Do not allow to be used as a toy.
•Keep vacuum on a level surface.

5
•Please use the cleaning solution specified by manufacturer and use it in the specified
proportion. Cleaning fluids that are not approved by manufacturer may cause damage
and injury to users, the environment and parts inside the fuselage.
•Prevent accidental start. Make sure the switch is in the off position before lifting or
handling the unit.
•Do not use damaged or modified devices. Damaged or modified batteries can behave in
unpredictable ways, resulting in a risk of fire, explosion or injury.
•Do not expose the device to flame or excessive temperature. Exposure to flame or
temperature above 130°C may cause explosion.
•Please follow all charging instructions and do not charge the device outside the
temperature range specified in the instructions. Improper charging or charging outside
the specified temperature range can cause battery damage and increase the risk of fire.
•Repair work must be conducted by qualified personnel and use only the same spare
parts. This ensures sustainable product safety.
•Do not modify or attempt to repair the device unless expressly stated in the instructions
for use and maintenance.
•Keep the temperature between 4°C and 40°C during battery charging, device storage or
device use.
•If storing or not using the vacuum for a long time, it’s important to ensure the battery is
kept charged. Charge the battery every three months.
•Do not use without water tank or filters in place.
•Do not carry the appliance with your finger on the switch, or power on the appliance with
the switch on.
•Use of any other battery packs may create a risk of injury and fire.
•Do not run appliance over cord.
•Keep cord away from heated surfaces.
•Plastic film can be dangerous. Keep away from children to avoid danger of suffocation.
•Use only as described in this user guide.
This marking indicates that this appliance should not be disposed with other
household wastes. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote
the sustainable reuse of material resources.

6
Vacuum handle Vacuum body Charging base
Cleaning tool Multi-surface
rolling brush
Replacement
filter
User guide
COMPONENTS LIST

7
OVERVIEW
Filter cover
Speed button
(High / Low)
Self-cleaning /
Voice button
Power button
Filter
Clean
water tank
Rolling brush cover
Float
Dirty water tank
LED display panel
Water spray button
Rolling brush

8
Underneath:
Charging dock:
Charging contact pins
Drying plate
Power adapter
Charging base
Auxiliary wheels
Base
Wheels

9
Upon removing from the packaging, your vacuum cleaner will be in two separate parts.
To assemble the vacuum, insert the handle into body as directed by the arrow until a
“CLICK” sound is heard.
Charging vacuum
Connect the charging dock AC adapter plug to wall socket and turn on. Place vacuum on
the dock to charge; the light on display panel will indicate the status of charging.
Before first use of the product, ensure it has been charged for at least 5 hours.
GETTING STARTED
Vacuum
handle
Vacuum
body
click

10
Lifting
An ergonomically correct lift design has been applied on back of vacuum, we recommend
you lift or move the vacuum via this point rather than holding by the handle.
Display panel introduction
Display panel indicates status for the following:
Arrow to lift up
Lift from here
Brush jam/clean reminder
Refill clean
water tank
Charging indicator Water spray
indicator
Empty dirty water
tank / clean filter
Brush drying
indicator

11
Fill clean water tank
Remove clean water tank from vacuum, fill with warm tap water to the “MAX” line, and
then add 2 to 3 caps of a floor cleaner liquid (not supplied). Seal with rubber cap, then place
the water tank back into vacuum.
MAX
Click
DO NOT USE BOILING WATER – MAXIMUM 60°C.
DO NOT HEAT WATER OR TANK IN MICROWAVE.

12
1. Hold the base with your foot and press the handle downwards.
2. Recline the body of vacuum backward to start the roller brush spinning.
OPERATION

13
3. To select deep cleaning mode, press the Speed control button (next to Power
button)
4. To press Water Spray trigger and release, the water from the clean water tank will
wet the roller brush.
5. After cleaning, ensure the vacuum is stood upright. To stop roller brush spinning,
push the handle forward until a “CLICK” sounds.
Click

14
Emptying dirty water tank & cleaning the filter
The float is what prevents your dirty tank from overflowing. When your dirty tank is full, the
float will shut off your suction motor creating a high-pitched sound indicating it is time to
empty your dirty water tank.
1. To empty dirty water
tank, press down on
recessed button at
the top of the tank.
2. While pressing down on
the button, grab the
front handle and pull
dirty water tank away
from the unit.
3.Remove the float from the
dirty water tank to
separate solid waste and
dirty water.
CLEANING & CARE
Dirty water tank & filter
cleaning reminder

15
Do not use sharp/hard force
to scratch the inner surface.
4.Pour dirty water and
debris out. Rinse the
inside of the dirty
water tank.
5.Clean here to avoid air
blockages.
6.Remove the filter from the
dirty water tank top by
pulling it up.
7. Open the mesh cover
to take out the filter,
clean & dry the filter
8.Hand wash the vacuum
filter and screen with
warm water and mild
detergent.
9.Rinse the float located at
the bottom of the dirty
water tank’s top.

16
10.If the inside area
where the dirty water
tank sits is dirty, wipe
it clean with a rag or
towel.
11. Leave parts out to dry
naturally in a well
ventilated location.
Avoid direct exposure
to the sun or heating,
as this can age or
damage the parts.
12.Once parts are dry, place
vacuum filter back into
dirty water tank top.
13.Reassemble and
replace the top of
dirty water tank.
14.Angle the dirt tank back into body or machine inserting
bottom first, then tilt the top of the dirt tank toward the
machine and push into place until you hear a click.
Click
Notes:
Make sure to clean your dirty tank and let all components dry out after each use to
keep your product at its best.
Click

17
Maintenance: Cleaning roller brush
1. Grasp cover at the front and pull upward
to remove.
2. Pull roller brush via lifting the nose of
roller brush.
3.Use the supplied cleaning tool to cut
and clean out all hair and debris.
4.Clean the nozzle with the cleaning
tool’s brush end.
Note:
Ensure the vacuum has been turned off before removing the roller brush cover.

18
5.Insert the end of roller into one side of
the base and then to fix the pin of roller
into the hole on the other side of the
foot.
6.Align the cover to the edges of the
base and then to lock the cover into
place until a CLICK sound is heard.
Maintenance: Self-Clean and Drying
After floor cleaning, place the vacuum on charging station to charge. Ensure vacuum is
well-charged and there’s sufficient cleaning solution in the clean water tank prior to
pressing the Self-Cleaning button. The voice guide will confirm when self-cleaning and
drying is complete.
Self-clean
Click

19
Vacuum is not operating:
1. Ensure battery is sufficiently charged.
2. Ensure the vacuum is standing upright.
3. Check the roller brush is locked in place.
Self-cleaning is not completing:
If self-clean is failing, it could be low power. Charge the vacuum for at least five minutes
before running the self-clean mode.
Low suction, or abnormal noise:
1. Make sure no objects stuck in entrance places.
2. Make sure dirty water tank relocates in place.
3. Make sure to clean thoroughly the dirty water tank unit and filter sponge.
Voice guide:
Press and hold the Self-cleaning / Voice button for 3 seconds to turn Voice Guide on or off.
Voltage 28.8V Noise ≤72dBA
Battery SPEC BP2940 21700 (8 cells) Clean Water Tank Volume 600ml
Battery Volume 4000 mAh Dirty Water Tank Volume 550ml
Suction Power 8000Pa Net Weight 5.55 kg
Roller Brush
Speeds
2300rpm (high speed)
1800rpm (low speed) Working Duration > 32 minutes
(approximate)
Product
Dimensions 280 * 245 * 1150mm Charging Time < 5 hours
(approximate)
Packaging
Dimensions 352 * 302 * 745mm
SPECIFICATIONS
TROUBLESHOOTING

20
Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com