Kohler Revival K-2950-1/8 User manual

BEFORE YOU BEGIN
BEFORE YOU BEGIN
ROUGHING-IN DIMENSIONS
ROUGHING-IN DIMENSIONS
NOTE
·
·
·
·
·
·
Observe all local plumbing and building codes.
Inspect the waste and supply tubing; replace if necessary.
Prior to installation, unpack the new lavatory and carefully
inspect it for damage. Return the lavatory to its protective
carton until you are ready to install it.
For replacement installations, make sure the existing
cutout is the same or smaller size as the new lavatory.
Use the template supplied with the lavatory to mark
correct size cutout.
Do not substitute another sealant if one is supplied with
this lavatory.
·
·
·
·
·
·
TOOLS AND MATERIALS REQUIRED
·
·
·
·
·
·
·
·
·
·
·
·
·
Template (supplied)
Sealant (may be supplied with some models)
Safety glasses
Pencil
Scissors
Tape measure
Putty knife
Plumbers putty
Hacksaw
Keyhole saw or saber saw
Drill (13mm or 1/2" dia. drill bit or larger)
Adjustable wrench
Pipe wrench
·
·
·
·
·
·
·
·
·
·
·
·
·
13mm
K-2950-8
356mm
102mm 102mm FINISHED WALL
79mm
79mm
241mm
483mm
COUNTERTOP EDGE
K-2950-1
-1-
113905-1M-CA(-)
INSTALLATION INSTRUCTIONS
CAST IRON SELF-RIMMING LAVATORY
K-2950-1/8
(S) 254mm 305mm
711mm
35mm
206mm
102mm
3/8" COLD
3/8" HOT
(S)
813mm
OUTLET
FINISHED FLOOR

·
·
·
·
RENOVE EXISTING LAVATORY
RENOVE EXISTING LAVATORY
·
·
·
·
Turn off the water supply to the
faucet.
Open the faucet valves, then
disconnect the supply lines.
Disconnect the drain assembly,
and remove the trap.
Remove the existing lavatory.
INSTALL NEW LAVATORY
INSTALL NEW LAVATORY
·
·
·
Cut the template on the cutout line.
Position the template on the
countertop to ensure clearance
between the lavatory, faucet, and
backsplash.
Verify cabinet clearance beneath
the countertop.
In china installation will not
have separate backsplash. The back
wall is the "backsplash".
NOTE:
·
·
·
·
·
Trace the template on the
countertop with a pencil.
Re-check the clearance between
the lavatory, faucet, backsplash or
wall, and cabinet Adjust the
template accordingly.
·
·
·
·
Drill a 13mm hole on the inside of
the cutout opening.
Cut the opening in the countertop
along the inside edge of the pencil
line.
·
·
13mm
Drain Assembly
Faucet
Supply Lines
Shut-Off Valve
*Template is supplied with product.
*
Template
Cut-out Line
RIM OF LAVATORY
-2-
113905-1M-CA(-)

·
·
Apply two beads of sealant to the
inside of the pencil line.
Do not substitute another
sealant if one is supplied with this
lavatory.
Spread the sealant evenly with a
putty knife.
NOTE:
·
·
·Carefully position the lavatory in
the cutout, and press down firmly.
Large lavatories are very heavy.
Get help lifting the lavatory into
place.
CAUTION: Risk of personal
injury or product damage.
·
·
·
·
·
·
·
·
Immediately wipe away any excess
sealant, and fill any voids as
needed.
Verify that the lavatory has not
moved out of position.
Allow the sealant to cure for at
least 30minutes before proceeding.
Connect the faucet supply lines.
Connect the drain assembly.
Open the faucet valves, and check
for leakage.
Clean up with a non-abrasive
cleaner.
·
·
·
·
Temporaily position the lavatory in
the opening, and adjust to fit.
Large lavatories are
very heavy. Get help lifting the
lavatory into lpace.
Trace a pencil line around the
outside edge of the lavatory.
Remove the lavatory.
Install the faucet and drain
according to the manufacturer's
instructions.
CAUTION: Risk of personal
injury or product
damage.
·
·
·
·
·
·
·
·
·
·
·
-3-
113905-1M-CA(-)

IMPORTANT CONSUMER INFORMATION
IMPORTANT CONSUMER INFORMATION
Kohler plumbing fixtures and fittings are warranted free of
manufacturing defects.
Kohler will at its election, repair, replace, or make appropriate
adjustment where Kohler inspection discloses any such
defects occurring in normal usage within one year after
installation. Kohler is not responsible for installation costs.
To obtain warranty service, contact Kohler either through your
Dealer or Plumbing Contractor or by writing:
Central Customer Service Centre, Kohler China Ltd.
19/F Shanghai Square, 138 Huai Hai Road,
LuWan District, Shanghai, China
200021, PRC
Http://www.kohler.com.cn Http://www.kohler.com.cn
LIMITED ONE-YEAR WARRANTY
LIMITED ONE-YEAR WARRANTY
CARE AND CLEANING
To keep your lavatory looking new, make sure you rinse it out
thoroughly after each use. on this
product, as they will scratch and ruin the surface. Stubborn
stains, paint, or tar can be removed with turpentine or paint
thinner.
DO NOT ABRASIVES
-4-
113905-1M-CA(-)