Kohler STRAYT 37341-4 User manual

BEFORE YOU BEGIN
All information is based on the latest product information available at the time of publication. Kohler Co.
reserves the right to make changes in product characteristics, packaging, or availability at any time without
notice.
Please leave these instructions for the consumer. They contain important information.
NOTES:
1. Flush the water supply pipes thoroughly to remove debris.
2. Shut off the water supplies to the fitting.
3. Observe all local plumbing and building codes.
1167459-2A-A 1
37341-4 1-WAY BIB TAP
37342-4 2-WAY BIB TAP
HANDLE OPERATION
INSTALLATION INSTRUCTIONS
Bib Tap
For 37341-4, handle opens counter-clockwise and closes clockwise．
For 37342-4, turn the handle left, the spout works; turn the handle right, the connector works.
37341-4
ROUGH-IN DIMENSIONS
37342-4
127
G1/2″
157
83
65
54
63
46
15°
63
46
15°
83
128
G1/2"
G1/2"
11.5
55
82
STRAYT

1167459-2A-A 2
How To Install The Bib Tap
To perform installation, installer must provide G1/2″ female supply
fitting(1).
NOTE: The supply fitting should be not beyond, but below the finished
wall less than 20mm, and be vertical with finished wall as well.
Put the washer(2) into the groove on the bottom of the escutcheon(3).
Aligning the pin holes on the escutcheon with the pins(4) on the
bottom of the spout kit(5), and slide the escutcheon onto the spout kit.
Apply tape or thread sealant to G1/2″ nipple threads of the spout kit.
Tighten the spout kit to the G1/2″ female supply fitting. Adjust the
spout downwards.
INSTALLATION
CLEANING INSTRUCTIONS
INSTALLATION CHECKOUT
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean
soft cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc. which could
adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
Ensure that all connections are tight. Ensure that the handle is in the
off position.
Turn on the drain and main water supply, and check for leaks. Repair
as needed.
Remove the aerator(6) with the key(7). Turn on the handle. Run the
water through the spout for about one minute to remove any debris.
Check for leaks. Shut off the handle. Reinstall the aerator.
1
2
3
4
5
6
7
**Color code must be specified when ordering
SERVICE PARTS
1167459-2A-A 3
37341-4 1-WAY BIB TAP
37342-4 2-WAY BIB TAP
Bib Tap
834705**
Plug
3013706
Screw
1161962**
Handle
3008243
Spline Adapter
835749
Valve
3010762
Aerator
3006146
Aerator Key
3013706
Screw
834705**
Plug
1161637**
Handle
3008243
Spline Adapter
3007275
Nut
3008894
Valve
1068126
Washer
1167450**
Escutcheon
3007036
Pin
3010762
Aerator
3006146
Aerator Key
STRAYT