Kohler K-20184K Assembly instructions
Installation and Care Guide
Two-Piece Toilet
1326101-X2-C ©2020 Kohler Co.
K-20184K, K-22586X
EN English
TH
1326101-X2-C 2 Kohler Co.
Thank You for Choosing Kohler Company
Thank you for choosing Kohler. Kohler craftsmanship offers you a rare
combination of proven performance and graceful sophistication that will
satisfy you for years to come. The dependability and beauty of your Kohler
product will surpass your highest expectations. We’re very proud of our
products here at Kohler and we know you will be too.
Please take a few minutes to review this manual before you start installation. If
you encounter any installation or performance problems, please don’t hesitate
to contact us. Our phone numbers and website are listed on back cover.
All information in this manual is based upon the latest product information avail-
able at the time of publication. At Kohler, we constantly strive to improve the
quality of our products. We reserve the right to make changes in product char-
acteristics, packaging or availability at any time without notice.
Thank you for choosing Kohler Company.
Important Information
IMPORTANT NOTICE TO INSTALLERS!: Please leave these instructions for
the consumer. They contain important information.
In addition to installation procedures, this manual contains important care and
cleaning. Please retain for future reference.
NOTE: The toilet pictured in the installation steps may differ from the model
being installed.
Kohler Co. 3 1326101-X2-C
Before You Begin
¨Observe all local plumbing and building codes.
¨Prior to installation, unpack the new product and inspect it for damage.
Return the product to its protective carton until you are ready to install it.
¨Use the template supplied with the product.
¨Failure to follow these precautions may result in a poor installation.
¨If the existing toilet does not have a supply shut-off valve below the tank,
install one before installing the new toilet.
¨Do not use white cement or high lime content cements to install this toilet.
The expansion of cement due to a rise in temperature may make the toilet
crack or cause damage. Kohler is not responsible for any damage caused
by installation with the use of cement.
¨Fixture dimensions are nominal and conform to tolerances established by
Standards ASME A112.19.2/CSA B45.1, TIS 792
CAUTION: Risk of personal injury or product damage. Handle with
care. Product can break, chip, or cause injury if handled carelessly.
CAUTION: Risk of property or product damage. Turn on the water
and allow water to ow through the supply pipe to ush the system of
any debris before connecting ll valve.
CAUTION: Risk of hazardous gases. If the new toilet is not installed
immediately, temporarily place a rag in the closet ange.
1326101-X2-C 4 Kohler Co.
Kohler Co. 5 1326101-X2-C
Tools/
¨
¨
¨
¨
¨
¨
¨
1326101-X2-C 6 Kohler Co.
Installation/
1
2
1/2” Supply
Verify inlet and outlet position. Position the template on the oor to
ensure the template against the wall.
Tape in place.
3Drill 2 oor mounting holes and
3 ange holes. Insert anchors.
Draw centerline
on the oor.
10
4Position the brackets as shown on
the template and install the bracket.
Kohler Co. 7 1326101-X2-C
Installation/
5
Plastic Trap Outlet
Install the wax ring and trap outlet on the
floor. Tighten with screws.
Ceramic Trap Outlet
Install the wax ring on the oor.
Connector
Wax Ring
For Plastic Trap
Carefully align and lower the bowl.
Apply weight to the bowl rim to let the
outlet insert into connector.
For Ceramic Trap
Carefully align and lower the bowl, insert
into waste pipe.
Wax Ring
Waste Pipe
ท่อน้ำทิ�ง
6
Outlet
Plastic trap
ท่อน้ำทิ�ง
ข้อต่อท่อน้ำทิ�ง Finished floor / พื�น
Waste Pipe
ท่อน้ำทิ�ง
1326101-X2-C 8 Kohler Co.
Installation/
910
Apply silicone around base.
Connect supply and turn on the water.
1/2” Supply
Turn the tank upside down and place
the gasket to the tank. Install the tank
onto the bowl.
7
Bolt
Rubber washer
Gasket
Washer
Nut
Gasket
8Carefully thread the screws into the
brackets, until toilet is secure.
Alternately tighten left and right sides
to prevent pulling the toilet off center.
Bushing
Screw
Cap
Kohler Co. 9 1326101-X2-C
Installation/
11 12
Attach the tank cover.
Install the seat.
1326101-X2-C 10 Kohler Co.
Care and Cleaning
For best results, keep the following in mind when caring for your product:
• Carefully read the cleaner product label to ensure the cleaner is safe for use
on the material.
• Always test your cleaning solution on an inconspicuous area before applying
to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately after
cleaner application. Rinse and dry any overspray that lands on nearby
surfaces.
• Do not allow cleaners to sit or soak on the surface.
• Use a soft, dampened sponge or cloth. Never use an abrasive material such as
a brush or scouring pad to clean surfaces.
• Be careful not to leave staining materials in contact with the surface for
extended periods of time.
• The ideal cleaning technique is to rinse thoroughly and blot dry any water
from the surface after each use.
WARNING: Risk of property or product damage. Do not use in-tank
cleaners in your toilet. Products containing chlorine (calcium hypochlorite)
can seriously damage ttings in the tank. This damage can cause leakage
and property damage.
Kohler Co. 11 1326101-X2-C
•
•
•
•
•
•
•
1326101-X2-C 12 Kohler Co.
Troubleshooting Guide
Symptoms Recommended Action
1. Poor ush. A. Adjust the tank water level to match the waterline.
B. Fully open the water supply shut-off valve.
C. Clear obstructions from the trapway, jet, or bowl rim
holes.
D. Clear obstructions from the waste line.
2. No ush. A. Make sure the push button rods are in place. Adjust
as needed.
3. The ll valve
turns on/off by
itself or it runs,
allowing water to
enter the tank.
A. Check the position of ush valve cable, Flush valve
cable must not overlap the valve oat sinks.
B. Check the position of ush valve cable, ush valve
cable must not obstructive the phase of overow
tube.
C. Clean or replace the ush valve seal if it is worn,
dirty, or misaligned with the valve seat or ush valve
seat is damaged.
D. Clean the ll valve seal of debris or replace the
seal assembly.
E. Replace the ll valve if the valve oat sinks.
F. Adjust the tank water level if it is too high.
4. Long tank ll
cycle.
A. Fully open the water supply shut-off valve.
B. Clean the valve inlet, valve head, or supply line.
Flush the lines.
C. Clean the valve inlet, valve head, or supply line.
Flush lines.
5. Noisy tank ll
cycle.
A. Partially close the water supply shut-off valve if the
water pressure to the toilet is too high. Check the
toilet performance following any such adjustment.
B. Remove dirt or obstructions from the valve head.
Flush the lines.
Kohler Co. 13 1326101-X2-C
1326101-X2-C kohler.com
E-mail: [email protected]
KOHLER ASIA PACIFIC LIMITED
Asia Customer Service Centre
No.158, Jiang Chang San Road, Zhabei District, Shanghai, PRC. 200436.
Tel : +86 21 2606 2572
KOHLER (THAILAND) PUBLIC COMPANY LIMITED
16th FL. Jasmine City Bldg., 2 Soi Sukhumvit23, Sukhumvit Road, Wattana, Bangkok, Thailand. 10110
Call Center Tel. +(66) 2700 9299
This manual suits for next models
1
Table of contents
Languages:
Other Kohler Toilet manuals
Kohler
Kohler K-3489 Series Assembly instructions
Kohler
Kohler REACH K-18643T-SLJ User manual
Kohler
Kohler K-3422 User manual
Kohler
Kohler K-3357 Assembly instructions
Kohler
Kohler WELLINGTON LITE K-3446 User manual
Kohler
Kohler K-3324 Assembly instructions
Kohler
Kohler REVIVAL User manual
Kohler
Kohler Cimarron Comfort Height K-31588-0 User manual
Kohler
Kohler WELLWORTH LITE K-3414-PB User manual
Kohler
Kohler K-30215T-S User manual
Kohler
Kohler K-4108 Assembly instructions
Kohler
Kohler LUSTRA User manual
Kohler
Kohler REVE K-24766T-S User manual
Kohler
Kohler K-5401 Assembly instructions
Kohler
Kohler K-4195 User manual
Kohler
Kohler K-22241K Assembly instructions
Kohler
Kohler K-3423 User manual
Kohler
Kohler K-11489X Assembly instructions
Kohler
Kohler KARAT K-2444X Assembly instructions
Kohler
Kohler K-4406X Assembly instructions
