Kohler novita BN330 User manual

BN330
Elongated bidet toilet seat
BN330
Features
•Fits most elongated toilets
•Compact design is just over 5" high
•Stainless steel wand is automatically cleaned before and
after each use
•Separate front and rear nozzles for maximum comfort and
personalization
•Oscillating wash covers a wider area of cleansing
•Turbo setting produces a massaging effect as water moves
back and forth
•Air-bubble wash offers a soft, gentle wash with effective
cleansing
•Side-mounted control panel is accessible and easy to use
•Sittable lid for convenience
•Soft-close seat and lid prevent slamming
Technology
•Two-stage energy-saving feature
Installation
•Requires dedicated electrical GFCI circuit (120V, 15A, 60Hz)
Codes/Standards
ASME A112.4.2/CSA B45.16
UL 1431
CSA C22.2 No. 64
CSA C22.2 No. 68
KOHLER®Intelligent Toilet and C3®
Cleansing Seat Three-Year Limited
Warranty
See website for detailed warranty information.
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.NovitaSeats.com.
8-13-2023 02:28 - US/CA

BN330
Elongated bidet toilet seat
BN330
1-9/16"
(40 mm)
16-3/8"
(416 mm)
20-7/8"
(530 mm)
11-7/8"
(302 mm)
7-7/8"
(200 mm)
15-1/4" (387 mm)
17-11/16" (449 mm)
18-1/4"
(464 mm)
Min
19-3/4"
(502 mm)
Max
1-1/4"
(32 mm)
Min
5-1/2"
(140 mm)
Electrical Service Detail
32" (813 mm) R.
6" (152 mm) Min
2"
(51 mm)
13-1/4"
(337 mm)
Min
5" (127 mm)
Required Electrical Service
One dedicated circuit required, protected with Class A Ground-
Fault Circuit-Interrupter (GFCI). Outside North America, this
device may be known as a Residual Current Device (RCD).
120 V, 15 A, 60 Hz
Technical Information
All product dimensions are nominal.
Seat shape type: Elongated
Seat front type: Closed-front
Seat-mounting
holes:
5-1/2" (140 mm)
Power cord length: 39" (991 mm)
Notes
Install this product according to the installation
instructions.
Connect the seat to a cold water supply of
drinking quality water at a pressure of 20 psi -
80 psi (139 kPa - 551 kPa).
Do not install this seat in a location where: (1)
water might be splashed on the product or
(2) excessive moisture, high humidity levels,
or condensation is present. This will avoid
damage to the electronic components.
NOTICE: Do not use an extension cord with
this product.
NOTICE: Do not plug in the seat until instructed
to do so in the installation guide. This will avoid
possible product malfunction.
Locate the receptacle at least 6" (152 mm)
above the floor, and within a 32" (813 mm)
radius measured 2" (51 mm) from the bowl
ledge.
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.NovitaSeats.com.
8-13-2023 02:28 - US/CA