Konica Minolta bizhub C220 Series User manual

17-04-7551
Installation Instructions
Image Transfer Belt for use in
Konica Minolta bizhub C220/C280/C360
and C224/258/284/308/364/368/454/554 applications
INSTRUCCIONES DE INSTALACIÓN
INSTRUCTIONS D’INSTALLATION
INSTALLATIONSANLEITUNG
ISTRUZIONI PER L’INSTALLAZIONE
INSTRUÇÕES DE INSTALAÇÃO
2
4
6
1
Remove the cleaning blade assembly by first removing
the two screws.
3
Remove two bracket screws and rotate the ground wire up.
5
Remove the front screw securing the small metal side bracket.
Remove the bracket.
Remove the side bracket.

8
Position the assembly with the handle down
(as shown in the picture).
7
Remove the tension roller springs
on each side of the assembly.
17-04-7551
9
Remove the tension roller by sliding it up and out.
10
Remove the old belt from the frame.
11
Locate the lot code written on the inside of the new belt.
Position the new belt with the lot code facing up.
13
Taking great care not to damage the belt,
slide the new belt onto the frame.
14. Reassemble all other parts in reverse order.
Note: Prior to re-installing the cleaning blade assembly, apply drum lubricating powder (Katun recommends Kynar powder – Katun part
number 707200) to approximately half the outer belt surface. Install the cleaning blade assembly on to the powdered surface, and then
manually rotate the belt in the normal direction until the powder is cleaned from the belt.