Kramer VP-428H2 User manual

VP
-428H2 Quick Start (P/N: 2900-300855QS REV 1)
P/N:
2900- 300855QS
Rev:
1
Scan for full manual
VP-428H2 Quick Start Guide
This guide helps you install and use your VP-428H2 for the first time.
Go to www.kramerav.com/downloads/VP-428H2 to download the latest user manual and check if firmware
upgrades are available.
Step 1: Check what’s in the box
VP-428H2 4K HDBT Transmitter/Scaler
1 Bracket set
1 Quick start guide
1 Power adapter and cord
4 Rubber feet
Step 2: Get to know your VP-428H2
#
Feature
Function
1
PROG USB Connector
Connects to a USB memory stick for programming upgrade.
2 ON LED Lights green when the unit is powered on.
3
IR IN 3.5mm Mini Jack
Connects to an IR sensor.
4
IR OUT 3.5mm Mini Jack
Connects to an IR emitter.
5 INPUT SELECT Button Press to cycle between inputs.
INPUT SELECT LEDs The selected input lights.
6 STEP-IN Button Press to activate the input on the switcher to which the VP-428H2 is connected.
7 MENU Button Press to enter/exit the on-screen display (OSD) menu. Press together with the – button to
reset to 1080p.
8 ENTER Button In OSD, press to choose the highlighted menu item. Press together with the +/FREEZE
button to reset to XGA.
9 – In OSD, press to move back through the list or to decrement the parameter value.
10 +/FREEZE Button In OSD, press to move forward through the list or to increment the parameter value. When
not in OSD, press to freeze the display.
11
DP IN DisplayPort Connector
Connect to a DisplayPort source.
12
HDMI IN Connector
Connect to an HDMI source.
13 PC IN 15-pin HD Connector Connect to a computer graphics source.

#
Feature
Function
14
AUDIO IN 3.5mm Mini Jack
Connects to an unbalanced stereo audio source.
15 DATA (G, Rx, Tx)Terminal Block
Connectors
Connect to a source for tunneling control commands via HDBaseT.
16 CTRL (G, Rx, Tx)Terminal Block
Connectors
Connect to the PC or the remote controller to control VP-428H2.
17 ETHERNET RJ-45 Connector Connect to a PC via a LAN to tunnel Ethernet data via HDBT.
18
HDBT OUT RJ-45 Connector
Connect to an HDBaseT receiver.
19 48V DC Power Terminal Block
Connector
Connect to the Kramer power adapter.
Step 3: Install the VP-428H2
Install VP-428H2 using one of the following methods:
•Attach the rubber feet and place the unit on a flat surface.
•Fasten a bracket (included) on each side of the unit and attach it to a flat surface.
For more information go to www.kramerav.com/downloads/VP-428H2.
•Mount the unit in a rack using an optional RK-T2B rack adapter.
Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your VP-428H2. For best results, we recommend that you
always use Kramer high-performance cables to connect AV equipment to the VP-428H2.
Step 5: Connect the power
Connect the 48V DC power adapter to the VP-428H2 and plug the adapter into the mains.
Safety Instructions
Caution:
There are no operator serviceable parts inside the unit.
Warning:
Use only the Kramer Electronics power supply that is provided with the unit.
Warning:
Disconnect the power and unplug the unit from the wall before installing.
See www.KramerAV.com for updated safety information.