Notes:
nAlways remove the kettle from the base before filling it with water.
nNever use without water or fill with liquids other than water. When filling the kettle, take care to not
expose the electrical connections at the bottom of the kettle to water.
nYou can also fill the kettle with water through the spout.
nDo not fill the kettle beyond the maximum level, or below the minimum level marked on the water level
indicator (h) If the kettle is overfilled, boiling water may splash outside of the kettle.
nAlways use the kettle with its lid closed.
3- Place the kettle on its base.
4- Press the On/Off switch (i) located at the bottom of the kettle under the handle (g). (fig. 4). The blue
ED light on the water windows (h) will switch on. The boiling cycle starts.
5- At the end of the boiling cycle, the blue ED light will automatically turn off and the On/Off switch (i)
will go back to the Off position.
Note: At any time during the boiling cycle, you can manually stop the boiling cycle, simply by lifting the
On/Off switch (i) to its Off position.
6- Remove the kettle from its base before pouring.
7- To avoid the risk of splashing, pour boiled water slowly and don’t over-tilt the kettle.
CAUTION: A dry boil cut-off system will automatically switch the kettle off.
5. C EANING AND MAINTENANCE
DO NOT LEAVE WATE IN THE KETTLE AFTE USE.
EMPTY THE KETTLE AFTE EACH USE TO EDUCE ACCUMULATION OF LIMESCALE
DEPOSITS.
To clean the kettle and base
nAlways unplug the base and allow the kettle to cool before cleaning.
nAvoid exposing the base or the bottom of the kettle to excess water. To protect against risk of electrical
shock, do not immerse the base in water or any other liquid, or place under running water to clean.
Wipe clean with a damp sponge and a small amount of gentle dishwashing liquid if necessary. Never
clean with harsh or abrasive cleaners or sponges. Dry all parts carefully before next use.
To clean the limescale filter © (fig. 5)
nAlways unplug the base and allow the kettle to cool before cleaning.
nThe limescale filter is a removable mesh filter in the spout of the kettle. This filter does not treat or
remove the scale from the water, it traps the scale particles from being poured out.
nWith very hard water, the filter may need to be cleaned as often as 10-15 uses. If the filter is wet, run
under lukewarm water to remove particles. If filter is dry, brush gently to remove particles. To avoid
damaging the mesh, do not scrub the filter.
nTo remove excessive scale, descale as described below.
English
8
