Kuppersbusch 503187 Manual

Support Technical Information T5-85-05
Responsible: Uwe Laarmann Tel.: [phone]
Date: 17.07.2012 Fax: [phone]

Internal use only
Modification instructions for the new control unit,
spare part no. 503187
Models concerned
EDIP607.0E 1. Model with no circuit board
EDIP607.0E 2. Model with a circuit board
EDIPEM >approx. 1990 with a circuit board
Z
The pictures are shown as examples and may vary for the individual models.
1. Remove all the plug connections from the
electronic circuit board.
2. Disconnect the 4 wires from the green resistor.
3. Remove all the green resistor wiring.

2/3 T5-85-05
Internal use only
New control unit (spare-part no. 503187)
• If you have an appliance WITHOUT a circuit
board, please carry out steps 4, 5 and 6.
• If you have an appliance WITH a circuit
board, 4, 5 and 6 will not apply. Commence
with step 7.
4. Cut the plug connection for the new control unit.
5. Cut approx. 5 mm off the sheath and expose the
wires.
6. Connect all the wires to the new control unit as shown in the adjacent illustration.
from the internal
wiring system
from
the new
control unit

T5-85-05 3/2
Internal use only
7. Connect the cables to the circuit board as shown
on the adjacent chart.
Caution!
8. Take special care not to mix up the cables for the
mains connection (18/19) and the lamp cables
(32/33). Check this with the numbers on the lamp
cables.