Kuzma STABI R User manual

1
KUZMA STABI R WOOD FRAME ASSEMBLY- in the photo, a
wooden frame fitted with Stabi R base turntable
Instruction manual
2022-07

2
KUZMA LTD
INSTRUCTION MANUAL FOR STABI R WOODEN
FRAME ASSEMBLY-PLINTH
The Stabi R base turntable can be fitted into the Kuzma supplied wooden frame -plinth.
CONTENTS: Page
General 2
Technical data 2
Unpacking 2
Preparing Stabi R 3
Assembling 3
Tonearm mounting 4
Maintenance 4
General
Stabi R wooden frame-plinth is made from solid walnut and plywooda into which you can fit
the Stabi R base turntable. The armboard block is supplied with the Kuzma 9 inch arm cut.
The Stabi R plinth is supported on three fully adjustable metal feet.
For more details read instruction manual for Stabi R wood turntable and check plinth dimensions
which are both available on our web site.
Technical data:
Mass 9 kg
Plinth: walnut( oil protected)
Levelling yes (3 adjustable feet)
Armboard yes ( armboard block)
No. of tonearms 1
Dimensions 500 x 463 x 113 mm
Accessories supplied Torx bit T30, screws 3 x M6x40, 2x wooden screws
Basic Setup
Note: Some parts are heavy, so be careful when handling!
Note: Choose a suitable supporting table which can hold over 40 kg without warping.
Unpacking
The plinth is packed in one box. Before unpacking prepare the area where the assembly will take
place.The best position is on a solid table which is strong and rigid enough to support 40-50 kg.

3
Preparing Stabi R for plinth fitting
Depending on which version of the turntable you have, remove all parts from the base: platter,
belt, subplatter, tonearm, armwing, arm holders, arm balconies,supporting spikes, side panels, un
plug cable and it is best to remove the bearing shaft with oil reservoir by removing 3 screws using
Allen key 3 mm. See Fig. 1.&2.
Fig. 1. Stabi R base top view Fig. 2. Stabi R base bottow view
Assembling
Place the sheet of white foam from packing box on the table.
Place Stabi R base with the top down. See Fig. 2.
Over Stabi R base put plinth face down over the base. See Fig. 3.
Check alignement of holes and manually fit three fixing screws M 6x40 and secure them by
using Allen key 5mm. See Fig. 3.
Turn the whole assembly turn back and remove foam. Be careful-it is heavy. See Fig. 4.
Position turntable over the edge of table to fix armboard block. Fix 2 wooden screws into
armboard block. See Fig. 5.
Then return bearing shaft with reservoir and assemble turntable.
Fig. 3. Plinth-bottom view Fig. 4. Stabi R base fitted into plinth

4
Tonearm mounting
Mount the arm as instructed in the tonearm instruction manual. The armboard block is fixed in the
plinth. Under the arm cutout is hole with access underneath to fix the armbase. If required route
the tonearm cable underneath.
Fig. 5. Stabi R with plinth
Maintenance
Wood:
Wipe with damp cloth or special tissues for oiled wood.
Kuzma Ltd
Hotemaze 17A
SI-4205 PREDDVOR
SLOVENIJA
Phone: + 386 4 25 35 450
Fax: + 386 4 25 35 454
E mail: [email protected]. www.kuzma.si